參數資料
型號: SC16IS762IPW,128
廠商: NXP Semiconductors
文件頁數: 52/60頁
文件大小: 0K
描述: IC DUAL UART 64BYTE 28TSSOP
標準包裝: 2,500
特點: 低電流
通道數: 2,DUART
FIFO's: 64 字節
規程: RS232,RS485
電源電壓: 2.5V, 3.3V
帶自動流量控制功能:
帶故障啟動位檢測功能:
帶調制解調器控制功能:
安裝類型: 表面貼裝
封裝/外殼: 28-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 28-TSSOP
包裝: 帶卷 (TR)
配用: 568-4000-ND - DEMO BOARD SPI/I2C TO DUAL UART
568-3510-ND - DEMO BOARD SPI/I2C TO UART
其它名稱: 935279294128
SC16IS762IPW-F
SC16IS762IPW-F-ND
SC16IS752_SC16IS762
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2012. All rights reserved.
Product data sheet
Rev. 9 — 22 March 2012
56 of 60
NXP Semiconductors
SC16IS752; SC16IS762
Dual UART with I2C-bus/SPI interface, 64-byte FIFOs, IrDA SIR
For further information on temperature profiles, refer to Application Note AN10365
“Surface mount reflow soldering description”.
18. Appendix
18.1 Errata for Rev. E added 12 August 2011
18.1.1 IrDA wake-up
In Rev. D, the UART cannot wake up through RX pin once the UART is put to sleep by the
host.
18.1.2 Clearing of RX FIFO overflow
In Rev. D, once the receive FIFO overflows, the receive FIFO cannot be cleared with FIFO
reset command if the UART is continuously receiving data.
18.1.3 Interrupt priority encoder
When the edge of the IOR signal (an internal signal that reads IIR register) comes close to
the X1 clock that generates the interrupt, the value of the Interrupt Indication Register (IIR)
might not be correct. This issue might occur if the X1 clock is very slow and the host read
operation is very fast in response to the interrupt from the UART.
18.1.4 Time-out interrupt
If the host reads the receive FIFO at the at the same time as a time-out interrupt condition
happens, the host might read 0xCC (time-out) in the Interrupt Indication Register (IIR), but
bit 0 of the Line Status Register (LSR) is not set (means there is not data in the
receive FIFO). This is a conflict of the receive FIFO status when IIR = 0xCC (time-out), it
indicates that there are data in the receive FIFO, but LSR bit 0 = 0 indicates otherwise.
MSL: Moisture Sensitivity Level
Fig 39. Temperature profiles for large and small components
001aac844
temperature
time
minimum peak temperature
= minimum soldering temperature
maximum peak temperature
= MSL limit, damage level
peak
temperature
相關PDF資料
PDF描述
SC16IS762IBS,157 IC DUAL UART 64BYTE 32HVQFN
SC16C750BIBS,157 IC UART 64BYTE 32HVQFN
SC16C750BIBS,128 IC UART 64BYTE 32HVQFN
SC16C650BIBS,157 IC UART SOT617-1
SC16C650BIBS,128 IC UART SOT617-1
相關代理商/技術參數
參數描述
SC16IS762IPW-F 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE W/IRDA AND GPIO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16IS762IPW-S 功能描述:IC UART DUAL I2C/SPI 28-TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - UART(通用異步接收器/發送器) 系列:- 標準包裝:250 系列:- 特點:* 通道數:2,DUART FIFO's:16 字節 規程:RS232,RS485 電源電壓:2.25 V ~ 5.5 V 帶并行端口:- 帶自動流量控制功能:是 帶IrDA 編碼器/解碼器:是 帶故障啟動位檢測功能:是 帶調制解調器控制功能:是 帶CMOS:是 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP(7x7) 包裝:托盤 其它名稱:XR16L2551IM-F-ND
SC16IS762IPW-T 功能描述:IC UART DUAL I2C/SPI 28-TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - UART(通用異步接收器/發送器) 系列:- 標準包裝:250 系列:- 特點:* 通道數:2,DUART FIFO's:16 字節 規程:RS232,RS485 電源電壓:2.25 V ~ 5.5 V 帶并行端口:- 帶自動流量控制功能:是 帶IrDA 編碼器/解碼器:是 帶故障啟動位檢測功能:是 帶調制解調器控制功能:是 帶CMOS:是 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP(7x7) 包裝:托盤 其它名稱:XR16L2551IM-F-ND
SC16IS850LIBS,128 功能描述:UART 接口集成電路 UART/12C-BUS/ SPI INTERF.128 FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16IS850LIBS,151 功能描述:UART 接口集成電路 UART/12C-BUS/ SPI INTERF.128 FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel