- 您現在的位置：買賣IC網 > PDF目錄379352 > SC16IS762IBS (NXP Semiconductors N.V.) Dual UART with I2C-bus-SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support PDF資料下載
參數資料
| 型號： | SC16IS762IBS |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 連接器件 |
| 英文描述： | Dual UART with I2C-bus-SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support |
| 封裝： | SC16IS752IBS<SOT617-1 (HVQFN32)|<<http://www.nxp.com/packages/SOT617-1.html<1<Always Pb-free,;SC16IS752IBS<SOT617-1 (HVQFN32)|<<http://www.nxp.com/packages/SOT617-1.html& |
| 文件頁數： | 31/60頁 |
| 文件大?。?/td> | 356K |
| 代理商： | SC16IS762IBS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁當前第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
SC16IS752_SC16IS762
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 8 — 1 September 2011
31 of 60
NXP Semiconductors
SC16IS752; SC16IS762
Dual UART with I
2
C-bus/SPI interface, 64-byte FIFOs, IrDA SIR
8.17 I/O Interrupt Enable register (IOIntEna)
This register enables the interrupt due to a change in the I/O configured as inputs. If
GPIO[7:4] or GPIO[3:0] are programmed as modem pins, their interrupt generation must
be enabled via IER[3]. In this case, IOIntEna will have no effect on GPIO[7:4] or
GPIO[3:0].
Table 28.
Bit
7:0
8.18 I/O Control register (IOControl)
Table 29.
Bit
7:4
3
Remark:
As I/O pins, the direction, state, and interrupt enable of GPIO are controlled by
the following registers: IODir, IOState, IOIntEna, and IOControl. The state of CD, RI, DSR
pins will not be reflected in MSR[7:5] or MSR[3:1], and any change of state on these three
pins will not trigger a modem status interrupt (even if enabled via IER[3]), and the state of
the DTR pin cannot be controlled by MCR[0].
As modem CD, RI, DSR pins, the status at the input of these three pins can be read from
MSR[7:5] and MSR[3:1], and the state of the DTR pin can be controlled by MCR[0]. Also,
if modem status interrupt bit is enabled, IER[3], a change of state on RI, CD, DSR pins will
trigger a modem interrupt. The IODir, IOState, and IOIntEna registers will not have any
effect on these three pins.
IOIntEna register bits description
Symbol
Description
IOIntEna
Input interrupt enable.
0 = a change in the input pin will not generate an interrupt
1 = a change in the input will generate an interrupt
IOControl register bits description
Symbol
Description
reserved
These bits are reserved for future use.
SRESET
Software Reset. A write to this bit will reset the device. Once the
device is reset this bit is automatically set to logic 0.
GPIO[3:0] or
RIB, CDB,
DTRB, DSRB
1 = GPIO[3:0] emulate RIB, CDB, DTRB, DSRB
GPIO[7:4] or
RIA, CDA,
DTRA, DSRA
1 = GPIO[7:4] emulate RIA, CDA, DTRA, DSRA
IOLATCH
Enable/disable inputs latching.
0 = input value are not latched. A change in any input generates an
interrupt. A read of the input register clears the interrupt. If the input
goes back to its initial logic state before the input register is read,
then the interrupt is cleared.
1 = input values are latched. A change in the input generates an
interrupt and the input logic value is loaded in the bit of the
corresponding input state register (IOState). A read of the IOState
register clears the interrupt. If the input pin goes back to its initial
logic state before the interrupt register is read, then the interrupt is
not cleared and the corresponding bit of the IOState register keeps
the logic value that initiates the interrupt.
2
This bit programs GPIO[3:0] as I/O pins or as modem pins.
0 = I/O pins
1
This bit programs GPIO[7:4] as I/O pins or as modem pins.
0 = I/O pins
0
相關PDF資料 |
PDF描述 |
|---|---|
| SC16IS762IPW | Dual UART with I2C-bus-SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support |
| SC5R5153Z | 2.7V/2.0F Primary or back-up power supply for video, audio |
| SC5R5222Z | SWITCH DIP,SPST,10-POS,20-PIN STANDARD,SLIDE RAISED,50VDC |
| SC5R5332Z | High capacitance and low resistance for long cycle life applications |
| SC5R5303Z | High capacitance and low resistance for long cycle life applications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC16IS762IBS,128 | 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16IS762IBS,151 | 功能描述:UART 接口集成電路 UART DUAL I2C/SPI RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16IS762IBS,157 | 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16IS762IBS151 | 制造商:NXP 功能描述: 制造商:NXP Semiconductors 功能描述: |
| SC16IS762IBS-F | 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE W/IRDA AND GPIO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。