- 您現在的位置：買賣IC網 > PDF目錄11828 > SC16IS762IBS,157 (NXP Semiconductors)IC DUAL UART 64BYTE 32HVQFN PDF資料下載
參數資料
| 型號： | SC16IS762IBS,157 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 8/60頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DUAL UART 64BYTE 32HVQFN |
| 標準包裝： | 2,450 |
| 特點： | 低電流 |
| 通道數： | 2，DUART |
| FIFO's： | 64 字節 |
| 規程： | RS232，RS485 |
| 電源電壓： | 2.5V, 3.3V |
| 帶自動流量控制功能： | 是 |
| 帶故障啟動位檢測功能： | 是 |
| 帶調制解調器控制功能： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 32-HVQFN（5x5） |
| 包裝： | 托盤 |
| 配用： | 568-4000-ND - DEMO BOARD SPI/I2C TO DUAL UART 568-3510-ND - DEMO BOARD SPI/I2C TO UART |
| 其它名稱： | 935279293157 SC16IS762IBS SC16IS762IBS-ND |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
SC16IS752_SC16IS762
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2012. All rights reserved.
Product data sheet
Rev. 9 — 22 March 2012
16 of 60
NXP Semiconductors
SC16IS752; SC16IS762
Dual UART with I2C-bus/SPI interface, 64-byte FIFOs, IrDA SIR
7.6 Sleep mode
Sleep mode is an enhanced feature of the SC16IS752/SC16IS762 UART. It is enabled
when EFR[4], the enhanced functions bit, is set and when IER[4] is set. Sleep mode is
entered when:
The serial data input line, RX, is idle (see Section 7.7 “Break and time-out
The TX FIFO and TX shift register are empty.
There are no interrupts pending except THR.
Remark: Sleep mode will not be entered if there is data in the RX FIFO.
In Sleep mode, the clock to the UART is stopped. Since most registers are clocked using
these clocks, the power consumption is greatly reduced. The UART will wake up when
any change is detected on the RX line, when there is any change in the state of the
modem input pins, or if data is written to the TX FIFO.
Remark: Writing to the divisor latches DLL and DLH to set the baud clock must not be
done during Sleep mode. Therefore, it is advisable to disable Sleep mode using IER[4]
before writing to DLL or DLH.
7.7 Break and time-out conditions
When the UART receives a number of characters and these data are not enough to set off
the receive interrupt (because they do not reach the receive trigger level), the UART will
generate a time-out interrupt instead, 4 character times after the last character is
received. The time-out counter will be reset at the center of each stop bit received or each
time the receive FIFO is read.
A break condition is detected when the RX pin is pulled LOW for a duration longer than
the time it takes to send a complete character plus start, stop and parity bits. A break
condition can be sent by setting LCR[6], when this happens the TX pin will be pulled LOW
until LSR[6] is cleared by the software.
7.8 Programmable baud rate generator
The SC16IS752/SC16IS762 UART contains a programmable baud rate generator that
takes any clock input and divides it by a divisor in the range between 1 and (216
1). An
additional divide-by-4 prescaler is also available and can be selected by MCR[7], as
shown in Figure 10. The output frequency of the baud rate generator is 16
the baud
rate. The formula for the divisor is:
(1)
where:
prescaler = 1, when MCR[7] is set to logic 0 after reset (divide-by-1 clock selected)
prescaler = 4, when MCR[7] is set to logic 1 after reset (divide-by-4 clock selected).
Remark: The default value of prescaler after reset is divide-by-1.
divisor
XTAL1 crystal input frequency
prescaler
-----------------------------------------------------------------------------------
desired baud rate
16
-----------------------------------------------------------------------------------------
=
相關PDF資料 |
PDF描述 |
|---|---|
| SC16C750BIBS,157 | IC UART 64BYTE 32HVQFN |
| SC16C750BIBS,128 | IC UART 64BYTE 32HVQFN |
| SC16C650BIBS,157 | IC UART SOT617-1 |
| SC16C650BIBS,128 | IC UART SOT617-1 |
| ATMEGA16-16AUR | MCU AVR 16KB FLASH 16MHZ 44TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC16IS762IBS-F | 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE W/IRDA AND GPIO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16IS762IBS-T | 功能描述:IC UART DUAL I2C/SPI 32-HVQFN RoHS:是 類別:集成電路 (IC) >> 接口 - UART（通用異步接收器/發送器） 系列:- 標準包裝:250 系列:- 特點:* 通道數:2，DUART FIFO's:16 字節 規程:RS232，RS485 電源電壓:2.25 V ~ 5.5 V 帶并行端口:- 帶自動流量控制功能:是 帶IrDA 編碼器/解碼器:是 帶故障啟動位檢測功能:是 帶調制解調器控制功能:是 帶CMOS:是 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:托盤 其它名稱:XR16L2551IM-F-ND |
| SC16IS762IPW | 功能描述:UART 接口集成電路 DUAL UART 64BYTE RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16IS762IPW,112 | 功能描述:UART 接口集成電路 DUAL UART 64BYTE RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16IS762IPW,128 | 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。