參數資料
型號： SC16C750
廠商： NXP Semiconductors N.V.
英文描述： Universal Asynchronous Receiver/Transmitter (UART) with 64-byte FIFO
中文描述： 通用異步接收器/發送器（UART）的64字節FIFO
文件頁數： 7/45頁
文件大?。?/td> 598K
代理商： SC16C750
Philips Semiconductors
SC16C750
UART with 64-byte FIFO
Product data
Rev. 04 — 20 June 2003
7 of 45
9397 750 11623
Koninklijke Philips Electronics N.V. 2003. All rights reserved.
OUT1, OUT2 38, 35
30, 25
O
Outputs 1 and 2.
These are user-designated output terminals that are set
to the active (low) level by setting respective modem control register (MCR)
bits (OUT1 and OUT2). OUT1 and OUT2 are set to inactive the (HIGH) level
as a result of Master Reset, during loop mode operations, or by clearing
bit 2 (OUT1) or bit 3 (OUT2) of the MCR.
Receiver clock.
RCLK is the 16
×
baud rate clock for the receiver section of
the UART.
Read inputs.
When either IOR or IOR is active (LOW or HIGH,
respectively) while the UART is selected, the CPU is allowed to read status
information or data from a selected UART register. Only one of these inputs
is required for the transfer of data during a read operation; the other input
should be tied to its inactive level (i.e., IOR tied LOW or IOR tied HIGH).
Ring indicator.
RI is a modem status signal. Its condition can be checked
by reading bit 6 (RI) of the modem status register. Bit 2 (
RI) of the modem
status register indicates that RI has transitioned from a LOW to a HIGH
level since the last read from the modem status register. If the modem
status interrupt is enabled when this transition occurs, an interrupt is
generated.
Request to send.
When active, RTS informs the modem or data set that
the UART is ready to receive data. RTS is set to the active level by setting
the RTS modem control register bit and is set to the inactive (HIGH) level
either as a result of a Master Reset or during loop mode operations or by
clearing bit 1 (RTS) of the MCR. In the auto-RTS mode, RTS is set to the
inactive level by the receiver threshold control logic.
Receiver ready.
Receiver direct memory access (DMA) signaling is
available with RXRDY. When operating in the FIFO mode, one of two types
of DMA signaling can be selected using the FIFO control register bit 3
(FCR[3]). When operating in the 16C450 mode, only DMA mode 0 is
allowed. Mode 0 supports single-transfer DMA in which a transfer is made
between CPU bus cycles. Mode 1 supports multi-transfer DMA in which
multiple transfers are made continuously until the receiver FIFO has been
emptied. In DMA mode 0 (FCR0 = 0 or FCR0 = 1, FCR3 = 0), when there is
at least one character in the receiver FIFO or receiver holding register,
RXRDY is active (LOW). When RXRDY has been active but there are no
characters in the FIFO or holding register, RXRDY goes inactive (HIGH). In
DMA mode 1 (FCR0 = 1, FCR3 = 1), when the trigger level or the time-out
has been reached, RXRDY goes active (LOW); when it has been active but
there are no more characters in the FIFO or holding register, it goes inactive
(HIGH).
Serial data input.
RX is serial data input from a connected communications
device.
Serial data output.
TX is composite serial data output to a connected
communication device. TX is set to the marking (HIGH) level as a result of
Master Reset.
RCLK
10
54
I
IOR, IOR
24, 25
9, 10
I
RI
43
38
I
RTS
36
26
O
RXRDY
32
21
O
RX
11
55
I
TX
13
58
I
Table 2:
Symbol
Pin description
…continued
Pin
PLCC44 LQFP64
Type
Description
相關PDF資料
PDF描述
SC16C750IA44 Universal Asynchronous Receiver/Transmitter (UART) with 64-byte FIFO
SC16C750IB64 Universal Asynchronous Receiver/Transmitter (UART) with 64-byte FIFO
SC16C752 Dual UART with 64-byte FIFO
SC16C752IB48 Dual UART with 64-byte FIFO
SC16C754 Quad UART with 64-byte FIFO
相關代理商/技術參數
參數描述
SC16C750B 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:5 V, 3.3 V and 2.5 V UART with 64-byte FIFOs
SC16C750BIA44 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C750BIA44,512 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C750BIA44,518 功能描述:UART 接口集成電路 1CH. UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C750BIA44,529 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*