- 您現在的位置：買賣IC網 > PDF目錄98073 > SAB83C517A-N18-T4 (INFINEON TECHNOLOGIES AG) 8-BIT, 18 MHz, MICROCONTROLLER, PQCC84 PDF資料下載
參數資料
| 型號： | SAB83C517A-N18-T4 |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, 18 MHz, MICROCONTROLLER, PQCC84 |
| 封裝： | PLASTIC, LCC-84 |
| 文件頁數： | 16/137頁 |
| 文件大?。?/td> | 2089K |
| 代理商： | SAB83C517A-N18-T4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁
Device Specification
Semiconductor Group
7-50
Requirements for Hardware Power Down Mode
There is no dedicated pin to enable the Hardware Power Down Mode. Nevertheless for a
correct function of the Hardware Power Down Mode the oscillator watchdog unit including its
internal RC oscillator is needed. Therefore this unit must be enabled by pin OWE (OWE =
high). However, the control pin PE/SWD has no control function in this mode. It enables and
disables only the use of software controlled power saving modes.
Software controlled power saving modes
All of these modes are entered by software. Special function register PCON (power control
register, address is 87H) is used to select one of these modes.
Slow Down Mode
During slow down operation all signal frequencies that are derived from the oscillator clock, are
divided by eight, also the clockout signal and the watchdog timer count.
The slow down mode is enabled by setting bit SD. The controller actually enters the slow down
mode after a short synchronisation period (max. 2 machine cycles).
The slow down mode is disabled by clearing bit SD.
Idle Mode
During idle mode all peripherals of the SAB 80C517A (except for the watchdog timer) are still
supplied by the oscillator clock. Thus the user has to take care which peripheral should
continue to run and which has to be stopped during Idle.
The procedure to enter the idle mode is similar to the one entering the power down mode. The
two bits IDLE and IDLS must be set by two consecutive instructions to minimize the chance of
unintentional activating of the idle mode.
There are two ways to terminate the idle mode:
– The idle mode can be terminated by activating any enabled interrupt. This interrupt will
be serviced and the instruction to be executed following the RETI instruction will be the
one following the instruction that set the bit IDLS.
–
The other way to terminate the idle mode, is a hardware reset. Since the oscillator is
still running, the hardware reset must be held active only for two machine cycles for
a complete reset.
Normally the port pins hold the logical state they had at the time idle mode was activated. If
some pins are programmed to serve their alternate functions they still continue to output during
idle mode if the assigned function is on. The control signals ALE and hold at logic high levels
PSEN (see table 8).
相關PDF資料 |
PDF描述 |
|---|---|
| SAB80C517A-S18-T3 | 8-BIT, 18 MHz, MICROCONTROLLER, PQFP100 |
| SAB83C517A-5S18-T3 | 8-BIT, MROM, 18 MHz, MICROCONTROLLER, PQFP100 |
| SAB83C517A-5S18-T4 | 8-BIT, MROM, 18 MHz, MICROCONTROLLER, PQFP100 |
| SAB80C517A-S18-T3 | 8-BIT, 18 MHz, MICROCONTROLLER, PQFP100 |
| SAB80C535-M-T40/85 | 8-BIT, 12 MHz, MICROCONTROLLER, PQFP80 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAB88C166 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit CMOS Single-Chip Microcontrollers with/without oscillator prescaler with 32 KByte Flash EPROM |
| SAB88C166-5M | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit CMOS Single-Chip Microcontrollers with/without oscillator prescaler with 32 KByte Flash EPROM |
| SAB88C166EVAL | 制造商:Siemens 功能描述: |
| SAB88C166W-5M | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit CMOS Single-Chip Microcontrollers with/without oscillator prescaler with 32 KByte Flash EPROM |
| SAB9075H | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Picture-in-Picture PIP controller for NTSC |
發布緊急采購，3分鐘左右您將得到回復。