- 您現在的位置：買賣IC網 > PDF目錄10914 > SAB-C165-L25F HA (Infineon Technologies)IC MCU 16BIT TQFP-100-3 PDF資料下載
參數資料
| 型號： | SAB-C165-L25F HA |
| 廠商： | Infineon Technologies |
| 文件頁數： | 10/77頁 |
| 文件大小： | 0K |
| 描述： | IC MCU 16BIT TQFP-100-3 |
| 標準包裝： | 450 |
| 系列： | C16xx |
| 核心處理器： | C166 |
| 芯體尺寸： | 16-位 |
| 速度： | 25MHz |
| 連通性： | EBI/EMI，SPI，UART/USART |
| 外圍設備： | POR，PWM，WDT |
| 輸入/輸出數： | 77 |
| 程序存儲器類型： | ROMless |
| RAM 容量： | 2K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 4.5 V ~ 5.5 V |
| 振蕩器型： | 外部 |
| 工作溫度： | 0°C ~ 70°C |
| 封裝/外殼： | 100-LQFP |
| 包裝： | 托盤 |
| 其它名稱： | B165L25FHAXP SABC165L25FHAXT SP000011591 SP000011592 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁
C165
Data Sheet
14
V2.0, 2000-12
External Bus Controller
All of the external memory accesses are performed by a particular on-chip External Bus
Controller (EBC). It can be programmed either to Single Chip Mode when no external
memory is required, or to one of four different external memory access modes, which are
as follows:
– 16-/18-/20-/24-bit Addresses, 16-bit Data, Demultiplexed
– 16-/18-/20-/24-bit Addresses, 16-bit Data, Multiplexed
– 16-/18-/20-/24-bit Addresses, 8-bit Data, Multiplexed
– 16-/18-/20-/24-bit Addresses, 8-bit Data, Demultiplexed
In the demultiplexed bus modes, addresses are output on PORT1 and data is input/
output on PORT0 or P0L, respectively. In the multiplexed bus modes both addresses
and data use PORT0 for input/output.
Important timing characteristics of the external bus interface (Memory Cycle Time,
Memory Tri-State Time, Length of ALE and Read Write Delay) have been made
programmable to allow the user the adaption of a wide range of different types of
memories and external peripherals.
In addition, up to 4 independent address windows may be defined (via register pairs
ADDRSELx / BUSCONx) which control the access to different resources with different
bus characteristics. These address windows are arranged hierarchically where
BUSCON4 overrides BUSCON3 and BUSCON2 overrides BUSCON1. All accesses to
locations not covered by these 4 address windows are controlled by BUSCON0.
Up to 5 external CS signals (4 windows plus default) can be generated in order to save
external glue logic. The C165 offers the possibility to switch the CS outputs to an
unlatched mode. In this mode the internal filter logic is switched off and the CS signals
are directly generated from the address. The unlatched CS mode is enabled by setting
CSCFG (SYSCON.6).
Access to very slow memories or memories with varying access times is supported via
a particular ‘Ready’ function.
A HOLD/HLDA protocol is available for bus arbitration and allows to share external
resources with other bus masters. The bus arbitration is enabled by setting bit HLDEN
in register PSW. After setting HLDEN once, pins P6.7 … P6.5 (BREQ, HLDA, HOLD)
are automatically controlled by the EBC. In Master Mode (default after reset) the HLDA
pin is an output. By setting bit DP6.7 to ‘1’ the Slave Mode is selected where pin HLDA
is switched to input. This allows to directly connect the slave controller to another master
controller without glue logic.
For applications which require less than 16 MBytes of external memory space, this
address space can be restricted to 1 MByte, 256 KByte, or to 64 KByte. In this case
Port 4 outputs four, two, or no address lines at all. It outputs all 8 address lines, if an
address space of 16 MBytes is used.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-23K-IX-F1 | CONVERTER MOD DC/DC 40V 75W |
| VI-23J-IX-F4 | CONVERTER MOD DC/DC 36V 75W |
| VI-23J-IX-F3 | CONVERTER MOD DC/DC 36V 75W |
| DS80C390-QCR | IC MPU CAN DUAL HS 68-PLCC |
| VI-23D-IX-F4 | CONVERTER MOD DC/DC 85V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SABC165L25FHAXT | 制造商:Infineon Technologies AG 功能描述:MCU 16-bit C166 CISC/RISC ROMLess 5V 100-Pin TQFP |
| SAB-C165-L25M | 制造商:Infineon Technologies AG 功能描述:IC 16BIT MCU ROM/ROMLESS SMD |
| SAB-C165-L25M HA | 功能描述:16位微控制器 - MCU 16-Bit Single-Chip 5V 25MHz ROM less RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| SAB-C165-L25MHA | 制造商:Infineon Technologies AG 功能描述: 制造商:Rochester Electronics LLC 功能描述: |
| SAB-C165-L25MHATR | 制造商:Infineon Technologies AG 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。