參數資料
型號： SAA6588T
廠商： NXP SEMICONDUCTORS
元件分類： 消費家電
英文描述： RDS/RBDS pre-processor
中文描述： SPECIALTY CONSUMER CIRCUIT, PDSO20
封裝： PLASTIC, SO-20
文件頁數： 8/28頁
文件大小： 176K
代理商： SAA6588T
1997 Sep 01
8
Philips Semiconductors
Product specification
RDS/RBDS pre-processor
SAA6588
Data processing control
The pre-processor provides different operating modes
selectable via the external I
2
C-bus. The data processing
control performs the pre-selected operating modes and
controls the requested output of the RDS/RBDS
information.
Restart of synchronization mode:
The ‘restart synchronization’ (NWSY) control mode
immediately terminates the actual synchronization and
restarts a new synchronization search procedure.
The NWSY flag is automatically reset after the restart of
synchronization by the decoder.
This mode is required for a fast new synchronization on
the RDS/RBDS data from a new transmitter station if the
tuning frequency is changed by the radio set.
Restart of synchronization search is furthermore
automatically carried out if the internal flywheel signals
a loss of synchronization (see Section “Flywheel for
synchronization hold”).
Error correction control mode for synchronization:
For error correction and identification of valid blocks
during synchronization search, three different modes
are selectable. (SYM1, SYM0, see Table 4).
RBDS processing mode:
The pre-processor is suitable for receivers intended for
the European (RDS) as well as for the USA (RBDS)
standard. If RBDS mode is selected via the I
2
C-bus, the
block detection and the error detection and correction
are adjusted to RBDS data processing.
Data available control mode:
The pre-processor provides three different RDS/RBDS
data output processing modes selectable via the ‘data
available’ control mode: (see also Section “RDS/RBDS
data output” and Table 5).
Standard processing mode:
if the decoder is
synchronized and a new block is received (every
26 bits), the actual RDS/RBDS information of the last
two blocks is available with every new received block.
Fast PI search mode:
during synchronization search
and if a new A-block is received, the actual RDS/RBDS
information of this or the last two A-blocks respectively
is available with every new received A-block. If the
decoder is synchronized, the standard processing mode
is valid.
Reduced data request processing mode:
if the
decoder is synchronized and two new blocks are
received (every 52 bits), the actual RDS/RBDS
information of the last two blocks is available with every
two new received blocks.
The RDS/RBDS pre-processor provides data output of the
block identification, the RDS/RBDS information words and
error detection and correction status of the last two blocks
as well as signal quality indication and general decoder
status information.
In addition, the decoder controls also the data request from
the external main controller. The pre-processor activates
the ‘data overflow’ status flag DOFL
(see Section “Programming”), if the decoder is
synchronized and a new RDS/RBDS block is received
before the previously processed block was completely
transmitted via I
2
C-bus. After detection of data overflow
the interface registers are not updated until reset of the
data overflow flag by reading via the I
2
C-bus.
RDS/RBDS data output
The decoded RDS/RBDS block information and the
current pre-processor status is available via the I
2
C-bus.
For synchronization of data request between main
controller and pre-processor the additional data available
output signal is used.
If the decoder has processed new information for the main
controller the data available signal (DAVN) is activated
(LOW) under the following conditions (see also Table 5):
During synchronization search in DAVB mode if a valid
A-block has been detected. This mode can be used for
fast search tuning (detection and comparison of the PI
code contained in the A-block).
During synchronization search in any DAV mode, if two
blocks in correct sequence have been detected
(synchronization criterion).
If the pre-processor is synchronized and in mode DAVA
and DAVB a new block has been processed. This mode
is the standard data processing mode, if the decoder is
synchronized.
If the pre-processor is synchronized and in DAVC mode
two new blocks have been processed.
If the pre-processor is synchronized and in any DAV
mode loss of synchronization is detected (flywheel
counter overflow and resulting restart of
synchronization).
In any DAV mode, if a reset condition caused by
power-on or voltage-drop is detected.
相關PDF資料
PDF描述
SAA6721 SXGA RGB to TFT graphics engine
SAA6721E SXGA RGB to TFT graphics engine(XGA RGB 到 TFT圖形引擎)
SAA6750 Encoder for MPEG2 image recording EMPIRE
SAA6750H Encoder for MPEG2 image recording EMPIRE
SAA6752HS MPEG-2 video and MPEG-audio/AC-3 audio encoder with multiplexer
相關代理商/技術參數
參數描述
SAA6588T/V2,512 功能描述:射頻無線雜項 RDS PREPROCESSOR RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel
SAA6588T/V2,518 功能描述:射頻無線雜項 RDS PREPROCESSOR RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel
SAA6588T/V2H,512 功能描述:射頻無線雜項 RDS/RBDS Pre-Processor 20-Pin RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel
SAA6588T/V2H,518 功能描述:射頻無線雜項 RDS/RBDS Pre-Process RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel
SAA6588TD 功能描述:射頻無線雜項 RDS/RBDS PRE-PROCESSOR RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*