- 您現在的位置：買賣IC網 > PDF目錄372112 > SAA5695HL (NXP Semiconductors N.V.) Enhanced TV microcontrollers with On-Screen Display (OSD) PDF資料下載
參數資料
| 型號： | SAA5695HL |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Enhanced TV microcontrollers with On-Screen Display (OSD) |
| 中文描述： | 與微控制器在強化電視屏幕顯示（OSD） |
| 文件頁數： | 43/116頁 |
| 文件大?。?/td> | 532K |
| 代理商： | SAA5695HL |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁
2002 May 06
43
Philips Semiconductors
Objective specification
Enhanced TV microcontrollers with
On-Screen Display (OSD)
SAA567x; SAA569x
13 TIMERS/COUNTERS
Three 16-bit Timers/counters are incorporated: Timer 0, 1
and 2. Each can be configured to operate as either timers
or event counters. Timer 2 is new for the SAA56xx,
whereas Timer 0 and 1 are standard 80C51
Timer/counters, refer to “Handbook IC20 80C51-Based
8-bit Microcontrollers”
Remark:
It should be noted that
because the SAA56xx uses both clock edges, the division
factor is 6 instead of 12.
When the Timers/counters are configured as timers, the
period depends on the microcontroller clock frequency of
12 MHz.
In Timer mode, the register is incremented on every
machine cycle, so that machine cycles are counted. Since
the machine cycle consists of six oscillator periods, the
count rate is
1
6
f
clk
(where f
clk
is the microcontroller clock
frequency: 12 MHz).
In Counter mode, the register is incremented in response
to a negative transition at its corresponding external pin
T0/T1/T2. Since pins T0/T1/T2 are sampled once per
machine cycle, it takes two machine cycles to recognise a
transition. This gives a maximum count rate of
1
12
f
clk
(where f
clk
is the microcontroller clock frequency, 12 MHz).
13.1
Timer/counter 0 and 1
There are six Special Function Registers used to control
Timer/counter 0 and 1.
Table 14
Timer/counter 0 and 1 registers
The Timer/counter function is selected by control bits C/T
in the Timer Mode SFR(TMOD). These two
Timers/counters have four operating modes, which are
selected by bit-pairs (M1 and M0) in TMOD. Details of the
modes of operation is given in “Handbook IC20,
80C51-Based 8-Bit Microcontrollers”
TL0 and TH0 are the actual Timer/counter registers for
Timer 0. TL0 is the low byte and TH0 is the high byte. TL1
and TH1 are the actual Timer/counter registers for
Timer 1. TL1 is the low byte and TH1 is the high byte.
13.2
Timer/counter 2
Timer 2 is controlled using the following SFRs:
Table 15
Timer 2 Special Function Registers
Timer 2 can operate in four different modes
(see Table 16):
Auto-reload
Capture
Baud rate generation
Clock output.
The count-down option is only possible in the Auto-reload
mode with DCEN in T2MOD set and the external trigger
input disabled.
Table 16
Timer 2 operating mode
13.2.1
C
APTURE MODE
In the Capture mode, registers RCAP2L/RCAP2H are
used to capture the TL2/TH2 data. By setting/clearing bit
EXEN2 in T2CON, the external trigger input T2EX (P3.4)
can be enabled/disabled. If EXEN2 = 0, Timer 2 is a 16-bit
Timer/counter which, upon overflow, sets TF2 flag in
T2CON. If EXEN2 = 1, then Timer 2 does the above, but
with the added feature that a HIGH-to-LOW transition at
T2EX on Port 3.4 causes the current Timer 2 value
(TL2/TH2 data) to be captured into RCAP2L/RAP2H, and
bit EXF2 in T2CON to be set.
SFR
ADDRESS
TCON
TMOD
TL0
TH0
TL1
TH1
88H
89H
8AH
8BH
8CH
8DH
SFR
ADDRESS
T2CON
T2MOD
RCAP2L
RCAP2H
TL2
TH2
F1H
F2H
F3H
F4H
F5H
F6H
RCLK0 OR
TCLK0 OR
RCLK1 OR
TCLK1
CP/RL2 T2OE C/T2
OPERATING
MODE
0
0
1
0
1
X
0
0
X
X
X
X
16-bit Auto-reload
16-bit Capture
Baud rate
generation
Clock output
X
0
1
0
相關PDF資料 |
PDF描述 |
|---|---|
| SAA569x | Enhanced TV microcontrollers with On-Screen Display (OSD) |
| SAA5677HL | Enhanced TV microcontrollers with On-Screen Display (OSD) |
| SAA5700GP | Chinese Character System Teletext CCST decoder |
| SAA5700 | Chinese Character System Teletext CCST decoder |
| SAA6579 | Radio Data System RDS demodulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAA5697HL | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Enhanced TV microcontrollers with On-Screen Display (OSD) |
| SAA569X | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Enhanced TV microcontrollers with On-Screen Display (OSD) |
| SAA5700 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Chinese Character System Teletext CCST decoder |
| SAA5700GP | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Chinese Character System Teletext CCST decoder |
| SAA5731 | 制造商:The Stanley Works 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。