- 您現在的位置：買賣IC網 > PDF目錄2016 > SA555DX (Fairchild Semiconductor)IC OSC MONO TIMING 8-SOP PDF資料下載
參數資料
| 型號： | SA555DX |
| 廠商： | Fairchild Semiconductor |
| 文件頁數： | 9/13頁 |
| 文件大小： | 0K |
| 描述： | IC OSC MONO TIMING 8-SOP |
| 標準包裝： | 3,000 |
| 類型： | 555 型，計時器/振蕩器（單路） |
| 電源電壓： | 4.5 V ~ 16 V |
| 電流 - 電源： | 7.5mA |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 包裝： | 帶卷 (TR) |
| 供應商設備封裝： | 8-SOP |
| 安裝類型： | 表面貼裝 |
LM555
—
Single
T
imer
2002 Fairchild Semiconductor Corporation
www.fairchildsemi.com
LM555 Rev. 1.1.0
5
1. Monostable Operation
Figure 2 illustrates a monostable circuit. In this mode, the timer generates a fixed pulse whenever the trigger voltage
falls below VCC/3. When the trigger pulse voltage applied to the #2 pin falls below VCC/3 while the timer output is low,
the timer's internal flip-flop turns the discharging transistor off and causes the timer output to become high by charging
the external capacitor C1 and setting the flip-flop output at the same time.
The voltage across the external capacitor C1, VC1 increases exponentially with the time constant t = RA*C and
reaches 2 VCC/3 at tD = 1.1 RA*C. Hence, capacitor C1 is charged through resistor RA. The greater the time constant
RAC, the longer it takes for the VC1 to reach 2 VCC/3. In other words, the time constant RAC controls the output pulse
width.
When the applied voltage to the capacitor C1 reaches 2 VCC/3, the comparator on the trigger terminal resets the flip-
flop, turning the discharging transistor on. At this time, C1 begins to discharge and the timer output converts to low.
In this way, the timer operating in the monostable repeats the above process. Figure 3 shows the time constant rela-
tionship based on RA and C. Figure 4 shows the general waveforms during the monostable operation.
It must be noted that, for a normal operation, the trigger pulse voltage needs to maintain a minimum of VCC/3 before
the timer output turns low. That is, although the output remains unaffected even if a different trigger pulse is applied
while the output is high, it may be affected and the waveform does not operate properly if the trigger pulse voltage at
the end of the output pulse remains at below VCC/3. Figure 5 shows such a timer output abnormality.
2. Astable Operation
Figure 5. Waveforms of Monostable Operation
(abnormal)
Figure 6. A Stable Circuit
Figure 7. Capacitance and Resistance vs. Frequency
1
5
6
7
8
4
2
3
RESET
Vcc
DISCH
THRES
CONT
GND
OUT
TRIG
+Vcc
RA
C1
C2
RL
RB
100m
1
10
100
1k
10k
100k
1E-3
0.01
0.1
1
10
100
10M
Ω
1M
Ω
100
kΩ
10k
Ω
1kΩ
(R
A+2RB)
Ca
p
a
ci
ta
nc
e(
uF)
Frequency(Hz)
相關PDF資料 |
PDF描述 |
|---|---|
| SA555S-13 | IC OSC MONO TIMING SO8 |
| SCG102A-DFC-A1P2 V1.0 | IC OSC CLCK GEN 77.76MHZ OUT SMD |
| SCG2500-77.76M | IC OSC CLK GEN 77.76MHZ OUT SMD |
| SCG4500-155.52M | IC OSC CLK GEN 155.52MHZ OUT SMD |
| SI2400-BS | IC ISOMODEM SYSTEM-SIDE 16SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SA555FK | 制造商:TI 制造商全稱:Texas Instruments 功能描述:PRECISION TIMERS |
| SA555JG | 制造商:TI 制造商全稱:Texas Instruments 功能描述:PRECISION TIMERS |
| SA555N | 功能描述:計時器和支持產品 General Purp Single RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| SA555P | 功能描述:計時器和支持產品 Precision RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| SA555P | 制造商:Texas Instruments 功能描述:Timer IC 制造商:Texas Instruments 功能描述:IC, PRECISION TIMER, 500KHZ, 16V, 8-DIP |
發布緊急采購，3分鐘左右您將得到回復。