男男羞羞视频网站国产,国产精品偷伦视频

<abbr id="oiu6y"></abbr>

您好，
買賣IC網歡迎您。
請登錄
免費注冊

您現在的位置：買賣IC網 > PDF目錄25635 > S80C32XXX-40R (ATMEL CORP) 8-BIT, 40 MHz, MICROCONTROLLER, PQCC44 PDF資料下載

型號：	S80C32XXX-40R
廠商：	ATMEL CORP
元件分類：	微控制器/微處理器
英文描述：	8-BIT, 40 MHz, MICROCONTROLLER, PQCC44
封裝：	PLASTIC, LCC-44
文件頁數：	12/1021頁
文件大小：	15196K
代理商：	S80C32XXX-40R

32072H–AVR32–10/2012

AT32UC3A3

Fix/Workaround

Disable and then enable the peripheral after the transfer error.

URAD (Unspecified Register Access Detection Status) does not detect read accesses

to the write-only KEYW[5..8]R registers

Fix/Workaround

In the PRAS and PRBS registers, the MxPR fields are only two bits

In the PRAS and PRBS registers, the MxPR fields are only two bits wide, instead of four bits.

The unused bits are undefined when reading the registers.

Fix/Workaround

Mask undefined bits when reading PRAS and PRBS.

TWIM SR.IDLE goes high immediately when NAK is received

When a NAK is received and there is a non-zero number of bytes to be transmitted,

SR.IDLE goes high immediately and does not wait for the STOP condition to be sent. This

does not cause any problem just by itself, but can cause a problem if software waits for

SR.IDLE to go high and then immediately disables the TWIM by writing a one to CR.MDIS.

Disabling the TWIM causes the TWCK and TWD pins to go high immediately, so the STOP

condition will not be transmitted correctly.

Fix/Workaround

If possible, do not disable the TWIM. If it is absolutely necessary to disable the TWIM, there

must be a software delay of at least two TWCK periods between the detection of

SR.IDLE==1 and the disabling of the TWIM.

TWIM TWALM polarity is wrong

The TWALM signal in the TWIM is active high instead of active low.

Fix/Workaround

Use an external inverter to invert the signal going into the TWIM. When using both TWIM

and TWIS on the same pins, the TWALM cannot be used.

TWIS Version Register reads zero

TWIS Version Register (VR) reads zero instead of 0x112.

Fix/Workaround

The busy signal of the responses R1b is not taken in account for CMD12

STOP_TRANSFER

It is not possible to know the busy status of the card during the response (R1b) for the com-

mands CMD12.

Fix/Workaround

The card busy line should be polled through the GPIO Input Value register (IVR) for com-

mands CMD12.

相關PDF資料	PDF描述
S83C154DCXXX-16R	8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQCC44
SD80C32EXXX-30SC	8-BIT, 30 MHz, MICROCONTROLLER, CDIP40
S80C52XXX-12SHXXX:R	8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQCC44
S80C154-20	8-BIT, 20 MHz, MICROCONTROLLER, PQCC44
S83C154DCXXX-12	8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQCC44

相關代理商/技術參數	參數描述
S80C376CB8 WAF	制造商:Intel 功能描述:
S80C42	制造商:Intel 功能描述:
S80C51 WAF	制造商:Intel 功能描述:
S80C51-12	制造商:未知廠家制造商全稱:未知廠家功能描述:8-Bit Microcontroller
S80C51-16	制造商:未知廠家制造商全稱:未知廠家功能描述:8-Bit Microcontroller

發布緊急采購，3分鐘左右您將得到回復。

(若只采購一條型號，填寫一行即可)

*型號	*數量	廠商	批號	封裝

采購需求

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

我的聯系方式

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價