參數資料
型號: S5629-01
廠商: Electronic Theatre Controls, Inc.
英文描述: POSITION SENSITIVE DETECTOR
中文描述: 位置靈敏探測器
文件頁數: 13/16頁
文件大?。?/td> 1289K
代理商: S5629-01
10
Figure 6-1 Response wavelength example of PSD
KPSDC0078EB
2) Diffusion time t
2
of carriers generated outside the deple-
tion layer
Carriers are also generated outside the depletion layer
when light is absorbed in the PSD chip surrounding areas
outside the active area or at locations deeper than the de-
pletion layer in the substrate. These carriers diffuse through
the substrate and are extracted as an output. The time t
2
required for these carriers to diffuse may be more than sev-
eral microseconds.
The equation below gives the approximate rise time tr of a
PSD. Figure 6-1 shows typical output waveforms in re-
sponse to stepped light input.
Figure 6-2 shows the relation between the rise time and re-
verse voltage measured at different wavelengths. The rise
time can be reduced by increasing the reverse voltage and
using a light beam of shorter wavelengths. Selecting a PSD
with a small Rie is also effective in improving the rise time.
Figure 6-2 Rise time vs. reverse voltage (S4583-06)
A method for integrating position signals can be used when
detecting pulsed light having a pulse width shorter than the
PSD rise time.
Characteristic and use
6. Response speed
As with photodiodes, the response speed of PSD is the
time required for the generated carriers to be extracted as
current by an external circuit. This is generally expressed
as the rise time tr and is an important parameter when de-
tecting a spot light traveling over the active surface at high
speeds or using pulse-modulated light for subtracting the
background light. The rise time is defined as the time need-
ed for the output signal to rise from 10 to 90 % of its peak
value and is chiefly determined by the following two factors.
1) Time constant t
1
determined by the interelectrode resist-
ance, load resistance and terminal capacitance
The interelectrode resistance Rie of PSD basically acts as
load resistance R
L
, so the time constant t
1
is given by the
interelectrode resistance Rie and terminal capacitance Ct,
as follows:
t
1
= 2.2 . Ct . (Rie + R
L
) ......... (6-1)
The rise time listed in our PSD datasheets is measured
with a spot light striking the center of the active area with
the interelectrode resistance Rie distributed between the
electrodes. So the time constant t
1
is as follows:
t
1
= 0.5 . Ct . (Rie + R
L
) ......... (6-2)
KPSDB0110EA
REVERSE VOLTAGE (V)
(Typ. Ta=25
C)
R
1
0.1
0
10
8
6
4
2
10
100
l
=890 nm
l
=650 nm
t
12
+ t
22
.................... (6-3)
tr
LIGHT INPUT
OUTPUT WAVEFORM
(t
1
>>t
2
)
OUTPUT WAVEFORM
(t
2
>>t
1
)
相關PDF資料
PDF描述
S5629-02 POSITION SENSITIVE DETECTOR
S5991-01 POSITION SENSITIVE DETECTOR
S5629 POSITION SENSITIVE DETECTOR
S5A 5.0 AMPS. Surface Mount Rectifiers
S5B 5.0 AMPS. Surface Mount Rectifiers
相關代理商/技術參數
參數描述
S5629-02 制造商:未知廠家 制造商全稱:未知廠家 功能描述:POSITION SENSITIVE DETECTOR
S562K53Y5PN63J7R 功能描述:CAP CER 5600PF 1KV 10% RADIAL RoHS:是 類別:電容器 >> 陶瓷 系列:S 標準包裝:4,000 系列:- 電容:1000pF 電壓 - 額定:50V 容差:±10% 溫度系數:X7R 安裝類型:表面貼裝,MLCC 工作溫度:-55°C ~ 125°C 應用:自動 額定值:AEC-Q200 封裝/外殼:0805(2012 公制) 尺寸/尺寸:0.079" L x 0.047" W(2.00mm x 1.20mm) 高度 - 座高(最大):- 厚度(最大):- 引線間隔:- 特點:- 包裝:帶卷 (TR) 引線型:-
S562M39Z5UN65J7R 功能描述:CAP CER 5600PF 1KV 20% RADIAL RoHS:是 類別:電容器 >> 陶瓷 系列:S 標準包裝:4,000 系列:- 電容:1000pF 電壓 - 額定:50V 容差:±10% 溫度系數:X7R 安裝類型:表面貼裝,MLCC 工作溫度:-55°C ~ 125°C 應用:自動 額定值:AEC-Q200 封裝/外殼:0805(2012 公制) 尺寸/尺寸:0.079" L x 0.047" W(2.00mm x 1.20mm) 高度 - 座高(最大):- 厚度(最大):- 引線間隔:- 特點:- 包裝:帶卷 (TR) 引線型:-
S-562T 功能描述:穩流二極管 100V 5.6mA RoHS:否 制造商:Central Semiconductor 最大調節器電流:5.17 mA 最大極限電壓:2.9 V 最大峰值工作電壓:100 V 安裝風格:Through Hole 封裝 / 箱體:DO-204AH 封裝:
S56-340 制造商:Specialty Tapes 功能描述:3'' Black/Yellow Tunnel Tape 制造商:SPECIALTY TAPES 功能描述:Specialty Tapes Tunnel Tape, Roll Size: 3 x 40 yards, Color: Black/Yellow 制造商:SPECIALTY TAPES 功能描述:TUNNEL TAPE 3 BLACK/YELLOW X 40 YARDS