- 您現在的位置：買賣IC網 > PDF目錄373332 > RV5VH3XX Power Management ICs PDF資料下載
參數資料
| 型號： | RV5VH3XX |
| 英文描述： | Power Management ICs |
| 中文描述： | 電源管理IC |
| 文件頁數： | 19/47頁 |
| 文件大?。?/td> | 384K |
| 代理商： | RV5VH3XX |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
RV5VH1
××
/RV5VH2
××
18
OPERATION
DC/DC Converter 1
The DC/DC1 uses input voltage as an initial power supply, once boost operation is started, the boost output will be used
for the power supply of device itself. A change in the V
OUT1
will feed back to the internal error amplifier through external
voltage setting resistors and internal feed back resistors. When the feed back voltage is lower than the reference voltage
the error amplifier enables oscllation or otherwise will stop oscillation. The internal feed back resistor “R” which is fixed
and adjusted by laser trim can make the feed back input voltage to “Error Amp.1” stable. Pulses from the “OSC” circuit
have a duty cycle of 50% and it becomes 65 to 75%(at high side) through the “P_shift” circuit. The duty cycle may be
smaller with light load spontaneously.
These clook pulses control VFM circuit and make it possible to operate as a boost converter. The output of L
X1
is Nch open
drain, while the output of “EXT1” is driven by CMOS buffer and an external NMOS driver is also available instead of an
NPN transistor, in such cases the Rb and the Cb are not necessary. A recommended Rb is 300
.
When you use a MOS-
FET for the EXT1, the input voltage should be high enough and you can get high effiiciency applications.
A current limit is available only for the RV5VH1 series, to prevent an excess current from flowing through Nch driver tran-
sistor.
The DC/DC1 can be shut down by CSW pin. When the CSW pin is High, V
DD
level, the DC/DC1 is enabled and when the
CSW pin is “L”, GND level, the DC/DC1 is disabled. The EXT1 pin outputs “L” while the DC/DC1 is disabled.
C
L
SBD
V
OUT1
V
OUT1
L
X1
R
–
+
V
LX
lim.
OSC
Vref
p_shift
VFM1
V
IN
RV5VH1
××
Error Amp.1
3
4
C
L1
SBD
V
OUT1
V
OUT1
EXT1
R
–
+
OSC
Vref
p_shift
V
IN
RV5VH2
××
Error Amp.1
VFM1
NPN Tr.
Cb
3
4
Rb
相關PDF資料 |
PDF描述 |
|---|---|
| RV5VH301 | DC/DC CONVERTER CONTROLLER |
| RV5VH301-E1 | DC/DC CONVERTER CONTROLLER |
| RV5VH301-E2 | DC/DC CONVERTER CONTROLLER |
| RV5VH302 | DC/DC CONVERTER CONTROLLER |
| RV5VH302-E1 | DC/DC CONVERTER CONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RV600-6334-001 | 制造商:SOCKET SCREWS 功能描述: |
| RV-6022 | 制造商:GC Electronics 功能描述: |
| RV-6032 | 制造商:GC Electronics 功能描述: |
| RV6177-6-5 | 制造商:GESIPA 功能描述: |
| RV-63V101MH10UQ-R2 | 功能描述:CAP 100UF 63V SMD 制造商:elna america 系列:RV 包裝:剪切帶（CT） 零件狀態:在售 電容:100μF 容差:±20% 電壓 - 額定:63V ESR（等效串聯電阻）:- 不同溫度時的使用壽命:85°C 時為 2000 小時 工作溫度:-40°C ~ 85°C 極化:極化 等級:- 應用:通用 Ripple Current:226mA @ 120Hz Ripple Current @ High Frequency:323mA @ 100kHz 引線間距:- 大小/尺寸:0.394" 直徑（10.00mm） 高度 - 安裝（最大值）:0.413"（10.50mm） 表面貼裝焊盤尺寸:0.409" 長 x 0.409" 寬（10.40mm x 10.40mm） 安裝類型:表面貼裝 封裝/外殼:徑向，Can - SMD 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。