- 您現在的位置：買賣IC網 > PDF目錄378204 > RT9181 (Electronic Theatre Controls, Inc.) 150MA LDO REGULATOR WITH POG PDF資料下載
參數資料
| 型號： | RT9181 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 150MA LDO REGULATOR WITH POG |
| 中文描述： | 150mA的LDO穩壓器與POG |
| 文件頁數： | 6/10頁 |
| 文件大小： | 200K |
| 代理商： | RT9181 |
RT9181
Preliminary
www.richtek-ic.com.tw
6
DS9181-00 February 2002
Timing Diagram
Application Guides
CE/Shutdown
The RT9181 is enabled by driving the CE input high,
and shutdown by pulling the input low. If this feature
is not to be used, the CE input should be tied to VIN
to keep the regulator enabled at all times (the CE
input must
not
be left floating).
Internal P-Channel Pass Transistor
The RT9181 features a P-channel MOSFET pass
transistors. It provides several advantages over
similar designs using PNP pass transistors, including
longer battery life. The P-channel MOSFET requires
no base drive, which reduces quiescent current
considerably.
PNP-based
considerable current in dropout when the pass
transistor saturates, They also use high base-drive
currents under large loads. The RT9181 does not
suffer from these problems and consume only 160
μ
A
of quiescent current whether in dropout, light-load, or
heavy-load applications.
regulators
waste
Power Good
The power good output is an open-drain output. It is
designed essentially to work as a power-on reset
generator once the regulated voltage was up or a
fault condition. The output of the power good drives
low when a fault condition occurs. The power good
output come back up once the output has reached
90% of its nominal value and a 2.0ms (typ.) delay
has passed. See Timing Diagram. The output voltage
level will be drooped at the fault conditions including
current limit, thermal shutdown, or shutdown and
triggers the POG detector to alarm a fault condition.
This output is fed into an on-board delay circuitry that
drives the open drain transistor to indicate a fault.
Because at shutdown mode, a fault condition occurs
by pulling the POG output low, it will sink a current
from the open drain and the external power.
Selecting a suitable pulling resistance will be well to
control this dissipated power.
Current Limit and Thermal Protection
The RT9181 includes a current limit structure which
monitor and control the pass transistor’s gate voltage
limiting the guaranteed maximum output current to
150mA minimum.
Thermal-overload protection limits total power
dissipation in the RT9181. When the junction
temperature exceeds T
J
= +150
°
C, the thermal
sensor signals the shutdown logic turning off the
pass transistor and allowing the IC to cool. The
thermal sensor will turn the pass transistor on again
after the IC’s junction temperature cools by 20
°
C,
resulting in a pulsed output during continuous
thermal-overload
conditions.
protection is designed to protect the RT9181 in the
event of fault conditions. Do not exceed the absolute
maximum junction-temperature rating of T
J
= +125
°
C
for continuous operation. The output can be shorted
to ground for and indefinite amount of time without
damaging the part by cooperation of current limit and
thermal protection.
Thermal-overloaded
Operating Region and Power Dissipation
The maximum power dissipation of RT9181 depends
on the thermal resistance of the case and circuit
board, the temperature difference between the die
junction and ambient air, and the rate of air flow. The
90% max of V
OUT
(normal)
t
d
(POG) 2.0ms typ.
VOUT
POG
V
POGL
85% min
V
POGH
相關PDF資料 |
PDF描述 |
|---|---|
| RT9224 | 5-Bit Programmable Synchronous PWM Buck Converter Controller and Output Voltage Monitor |
| RT9224C | 5-Bit Programmable Synchronous PWM Buck Converter Controller and Output Voltage Monitor |
| RT9224P | 5-Bit Programmable Synchronous PWM Buck Converter Controller and Output Voltage Monitor |
| RT9224PS | 5-Bit Programmable Synchronous PWM Buck Converter Controller and Output Voltage Monitor |
| RT9224CCS | VOLT DETECT IC N-CH OD 2.2V TO92 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RT9181-18GB | 功能描述:IC REG LDO 1.8V .15A SOT23-5 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:3,000 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3.3V 輸入電壓:最高 6V 電壓 - 壓降（標準）:0.08V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最?。?- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:帶卷 (TR) 其它名稱:LP3988IMFX-3.3 |
| RT9181GB | 功能描述:IC REG LDO 1.2V .15A SOT23-5 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:3,000 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3.3V 輸入電壓:最高 6V 電壓 - 壓降（標準）:0.08V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最?。?- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:帶卷 (TR) 其它名稱:LP3988IMFX-3.3 |
| RT9181PB | 制造商:Richtek Technology Corporation 功能描述: |
| RT9183-12GG | 功能描述:IC REG LDO 1.2V 1.5A SOT223 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:MIC5365/66 Ultra-small LDO Regulators 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3V 輸入電壓:最高 5.5V 電壓 - 壓降（標準）:0.155V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最小）:200mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:4-UDFN 裸露焊盤，4-TMLF? 供應商設備封裝:4-TMLF?（1x1） 包裝:Digi-Reel® 其它名稱:576-3192-6 |
| RT9183-12GGF | 功能描述:IC REG LDO 1.2V 1.5A SOT223 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:50 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:2.1V 輸入電壓:最高 7.5V 電壓 - 壓降（標準）:- 穩壓器數量:1 電流 - 輸出:5A（最小值） 電流 - 限制（最?。?5.1A 工作溫度:-40°C ~ 100°C 安裝類型:通孔 封裝/外殼:TO-220-5 供應商設備封裝:TO-220-5 包裝:管件 配用:296-20624-ND - EVAL MOD FOR TPS72518 其它名稱:296-15154-5 |
發布緊急采購，3分鐘左右您將得到回復。