參數資料
型號: RS-170
廠商: National Semiconductor Corporation
英文描述: Programmable Video Sync Generator
中文描述: 可編程視頻同步發生器
文件頁數: 6/16頁
文件大?。?/td> 340K
代理商: RS-170
Addressing Logic
(Continued)
LOAD will load the first byte of data. Auto Incrementing is
disabled on the falling edge of LOAD after ADDRDATA and
LHBYTE goes low.
Manual Addressing Mode
Cycle
#
1
2
3
4
5
6
Load Falling Edge
Enable Manual Addressing
Enable Lbyte Data Load
Enable Hbyte Data Load
Enable Manual Addressing
Enable Lbyte Data Load
Enable Hbyte Data Load
Load Rising Edge
Load Address m
Load Lbyte m
Load Hbyte m
Load Address n
Load Lbyte n
Load Hbyte n
Auto Addressing Mode
Cycle
#
1
2
3
4
5
6
Load Falling Edge
Enable Auto Addressing
Enable Lbyte Data Load
Enable Hbyte Data Load
Enable Lbyte Data Load
Enable Hbyte Data Load
Enable Manual Addressing
Load Rising Edge
Load Start Address n
Load Lbyte (n)
Load Hbyte (n); Inc Counter
Load Lbyte (n+1)
Load Hbyte (n+1); Inc Counter
Load Address
ADDRDEC LOGIC
The ADDRDEC logic decodes the current address and gen-
erates the enable signal for the appropriate register. The en-
able values for the registers and counters change on the fall-
ing edge of LOAD. Two types of ADDRDEC logic is enabled
by 2 pair of addresses, Addresses 22 or 54 (Vectored Re-
start logic) and Addresses 23 or 55 (Vectored Clear logic).
Loading these addresses will enable the appropriate logic
and put the part into either a Restart (all counter registers are
reinitialized with preprogrammed data) or Clear (all registers
are cleared to zero) state. Reloading the same ADDRDEC
address will not cause any change in the state of the part.
The outputs during these states are frozen and the internal
CLOCK is disabled. Clocking the part during a Vectored Re-
start or Vectored Clear state will have no effect on the part.
To resume operation in the new state, or disable the Vec-
tored
Restart
or
Vectored
non-ADDRDEC address must be loaded. Operation will be-
gin in the new state on the rising edge of the non-ADDRDEC
load pulse. It is recommended that an unused address be
loaded following an ADDRDEC operation to prevent data
registers from accidentally being corrupted. The following
Addresses are used by the device.
Address 0
Status Register REG0
Address 1–18Data Registers REG1–REG18
Clear
state,
another
DS100232-7
DS100232-8
www.national.com
6
相關PDF資料
PDF描述
RS-170 Micro-size Surface Mountable Infrared Remote Control Receiver Unit
RS1006 10 Amp Single Phase Bridge Rectifier 50 to 1000 Volts
RS1007 10 Amp Single Phase Bridge Rectifier 50 to 1000 Volts
RS1001 10 Amp Single Phase Bridge Rectifier 50 to 1000 Volts
RS1002 10 Amp Single Phase Bridge Rectifier 50 to 1000 Volts
相關代理商/技術參數
參數描述
RS1706-6 制造商:Starrett Company 功能描述:POWER HACKS, REDSTRIPE HIGH SPEED STEEL, 17"L x 1 1/4"W x .062"T, 6T
RS-171 制造商:B3 Cable Solutions 功能描述:12CORE UNSCREENED 7X0.1MM
RS17-10R 制造商:Thomas & Betts 功能描述:4 SQ BX RS CVR 2 X GFCI REC
RS-171-T 制造商:Citizen Finetech Miyota Co Ltd 功能描述:REMOTE CONTROL RECEIVER UNIT
RS-172 制造商:B3 Cable Solutions 功能描述:20CORE UNSCREENED 7X0.1MM