- 您現在的位置：買賣IC網 > PDF目錄374590 > RH1021-5 (Linear Technology Corporation) Precision 5V Reference PDF資料下載
參數資料
| 型號： | RH1021-5 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Precision 5V Reference |
| 中文描述： | 精密5V的參考 |
| 文件頁數： | 3/4頁 |
| 文件大?。?/td> | 137K |
| 代理商： | RH1021-5 |
3
RH1021-5
TABLE 1A: ELECTRICAL CHARACTERISTICS
(Postirradiation) (Note 6)
TABLE 2: ELECTRICAL TEST REQUIRE U
MIL-STD-883 TEST REQUIREMENTS
Final Electrical Test Requirements (Method 5004)
Group A Test Requirements (Method 5005)
Group B and D for Class S, and
Group C and D for Class B
End Point Electrical Parameters (Method 5005)
* PDA Applies to subgroup 1. See PDA Test Notes.
SUBGROUP
1*,2,3,4
1,2,3,4
1
PDA Test Notes
The PDA is specified as 5% based on failures from group A, subgroup 1,
tests after cooldown as the final electrical test in accordance with method
5004 of MIL-STD-883. The verified failures of group A, subgroup 1, after
burn-in divided by the total number of devices submitted for burn-in in
that lot shall be used to determine the percent for the lot.
Linear Technology Corporation reserves the right to test to tighter limits
than those given.
Note 1:
Output voltage is measured immediately after turn-on. Changes
due to chip warm-up are typically less than 0.005%.
Note 2:
Temperature coefficient is measured by dividing the change in
output voltage over the temperature range by the change in temperature.
Separate tests are done for hot and cold; T
MIN
to 25°C and 25°C to T
MAX
.
Incremental slope is also measured at 25°C.
Note 3:
Line and load regulation are measured on a pulse basis. Output
changes due to die temperature change must be taken into account
separately. Package thermal resistance is 150°C/W for the TO-5 (H)
package.
Note 4:
RMS noise is measured with a 2-pole highpass filter at 10Hz and a
2-pole lowpass filter at 1kHz. The resulting output is full wave rectified and
then integrated for a fixed period, making the final reading an average as
opposed to RMS. Correction factors are used to convert from average to
RMS and to correct for the nonideal bandpass of the filters. Peak-to-peak
noise is measured with a single highpass filter at 0.1Hz and a 2-pole
lowpass filter at 10Hz. The unit is enclosed in a still-air environment to
eliminate thermocouple effects on the leads. Test time is 10 seconds.
Note 5:
Consult factory for units with long term stability data.
Note 6:
V
IN
= 10V, I
OUT
= 0, T
A
= 25°C, unless otherwise noted.
Note 7:
I
OUT(MAX)
(Sourcing) is 5mA for exposures greater than 100Krad
(Si).
Note 8:
V
IN
= 10V, I
OUT
= 0, unless otherwise noted.
15V
–15V
GND
V
IN
Information furnished by Linear Technology Corporation is believed to be accurate and reliable.
However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen-
tation that the interconnection of its circuits as described herein will not infringe on existing patent rights.
TOTAL DOSE BIAS CIRCUIT
相關PDF資料 |
PDF描述 |
|---|---|
| RH1021-7 | BRACKET END 11MM FOR TERM BLOCK |
| RH1021BM-10 | Precision 10V Reference |
| RH1021BM-5 | STAND-ALONE TX/SSFXSM/ PLUS SC (1310XMT/1550RCV) |
| RH1021BM-7 | STAND-ALONE TX/SSFXSM/ PLUS SC (1550XMT/1310RCV) |
| RH1021CM-10 | Precision 10V Reference |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RH10215R0FS03 | 功能描述:線繞電阻器 - 底架安裝 RH 10 215U 1% BA10 e1 RoHS:否 制造商:Vishay/Dale 電阻:7 Ohms 容差:1 % 功率額定值:100 W 溫度系數:50 PPM / C 系列:RH 工作溫度范圍:- 55 C to + 250 C 尺寸:46.02 mm Dia. x 46.02 mm W x 88.9 mm L x 44.45 mm H 封裝:Bulk 產品:Power Resistors Wirewound Aluminum Housed |
| RH1021-7 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Precision 7V Reference |
| RH1021BM-10 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Precision 10V Reference |
| RH1021BM-10H | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Voltage Reference |
| RH1021BM-5 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Precision 5V Reference |
發布緊急采購，3分鐘左右您將得到回復。