參數資料
型號： R5F21292SNXXXSP
元件分類： 微控制器/微處理器
英文描述： 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PDSO20
封裝： 4.40 X 6.50 MM, 0.65 MM PITCH, PLASTIC, LSSOP-20
文件頁數： 39/66頁
文件大?。?/td> 599K
代理商： R5F21292SNXXXSP
47
ATmega165A/PA/325A/PA/3250A/PA/645A/P/6450A/P [DATASHEET]
8285E–AVR–02/2013
11.4
Watchdog Timer
The Watchdog Timer is clocked from a separate On-chip Oscillator which runs at 1MHz. This is the typical value at
V
CC = 5V. See characterization data for typical values at other VCC levels. By controlling the Watchdog Timer pres-
caler, the Watchdog Reset interval can be adjusted as shown in Table 11-2 on page 50. The WDR – Watchdog
Reset – instruction resets the Watchdog Timer. The Watchdog Timer is also reset when it is disabled and when a
Chip Reset occurs. Eight different clock cycle periods can be selected to determine the reset period. If the reset
period expires without another Watchdog Reset, the Atmel
ATmega165A/165PA/325A/325PA/3250A/3250PA/645A/645P/6450A/6450P resets and executes from the Reset
Vector. For timing details on the Watchdog Reset, refer to Table 11-2 on page 50.
To prevent unintentional disabling of the Watchdog or unintentional change of time-out period, two different safety
levels are selected by the fuse WDTON as shown in Table 11-1. Refer to ”Timed Sequences for Changing the
Figure 11-7. Watchdog Timer.
11.4.1
Timed Sequences for Changing the Configuration of the Watchdog Timer
The sequence for changing configuration differs slightly between the two safety levels. Separate procedures are
described for each level.
11.4.1.1
Safety Level 1
In this mode, the Watchdog Timer is initially disabled, but can be enabled by writing the WDE bit to 1 without any
restriction. A timed sequence is needed when changing the Watchdog Time-out period or disabling an enabled
Watchdog Timer. To disable an enabled Watchdog Timer, and/or changing the Watchdog Time-out, the following
procedure must be followed:
1.
In the same operation, write a logic one to WDCE and WDE. A logic one must be written to WDE regardless
of the previous value of the WDE bit.
2.
Within the next four clock cycles, in the same operation, write the WDE and WDP bits as desired, but with
the WDCE bit cleared.
Table 11-1.
WDT Configuration as a Function of the Fuse Settings of WDTON
WDTON
Safety level
WDT initial state
How to disable the WDT
How to change time-out
Unprogrammed
1
Disabled
Timed sequence
Programmed
2
Enabled
Always enabled
Timed sequence
WATCHDOG
OSCILLATOR
相關PDF資料
PDF描述
R5F21286KXXXSP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PDSO20
R5F21292SNSP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PDSO20
R5F21294SDXXXSP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PDSO20
R5F21294SDSP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PDSO20
R5F21294KSP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PDSO20
相關代理商/技術參數
參數描述
R5F21294JSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MCU
R5F21294JSP#W4 功能描述:MCU 16KB ROM 1KB RAM 20LSSOP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:R8C/2x/29 標準包裝:300 系列:78K0R/Ix3 核心處理器:78K/0R 芯體尺寸:16-位 速度:40MHz 連通性:3 線 SIO，I²C，LIN，UART/USART 外圍設備:DMA，LVD，POR，PWM，WDT 輸入/輸出數:27 程序存儲器容量:16KB（16K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:38-SSOP 包裝:托盤
R5F21294JXXXSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:RENESAS 16-BIT SINGLE-CHIP MCU R8C FAMILY / R8C/2x SERIES
R5F21294KSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MCU
R5F21294KSP#ES 制造商:Renesas Electronics Corporation 功能描述:MCU 3/5V 16+2K - Tape and Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*