- 您現在的位置：買賣IC網 > PDF目錄378101 > R1211N002D-TR (RICOH COMPANY LTD) Step-up DC/DC Controller PDF資料下載
參數資料
| 型號： | R1211N002D-TR |
| 廠商： | RICOH COMPANY LTD |
| 元件分類： | 穩壓器 |
| 英文描述： | Step-up DC/DC Controller |
| 中文描述： | 0.05 A SWITCHING CONTROLLER, 805 kHz SWITCHING FREQ-MAX, PDSO6 |
| 封裝： | SOT-23, 6 PIN |
| 文件頁數： | 10/33頁 |
| 文件大?。?/td> | 375K |
| 代理商： | R1211N002D-TR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
Rev. 1.10 - 10 -
G
Use a 1
μ
F or more capacitance value of bypass capacitor between V
IN
pin and GND, C1 as shown in the typical
applications above.
G
In terms of the capacitor for setting delay time of the latch protection, C2 as shown in typical applications of the
previous page, connect between Delay pin and GND pin of the IC with the minimum wiring distance.
G
Connect a 1
μ
F or more value of capacitor between V
OUT
and GND, C3 as shown in typical applications of the
previous page. (Recommended value is from 10
μ
F to 22
μ
F.) If the operation of the composed DC/DC converter may
be unstable, use a tantalum type capacitor instead of ceramic type.
G
Connect a capacitor between V
OUT
and the dividing point, C4 as shown in typical applications of the previous page.
The capacitance value of C4 depends on divider resistors for output voltage setting. Typical value is between 100pF
and 1000pF.
G
Output Voltage can be set with divider resistors for voltage setting, R1 and R2 as shown in typical applications of
the previous page. Refer to the next formula.
Output Voltage = V
FB
×
(R1+R2)/R2
R1+R2=100k
is recommended range of resistances.
G
The operation of Latch protection circuit is as follows: When the IC detects maximum duty cycle, charge to an
external capacitor, C2 of DELAY pin starts. And maximum duty cycle continues and the voltage of DELAY pin
reaches delay voltage detector threshold, V
DLY
, outputs “L” to EXT pin and turns off the external power MOSFET.
To release the latch protection operation, make the IC be standby mode with CE pin and make it active in terms of
B/D version. Otherwise, restart with power on.
The delay time of latch protection can be calculated with C2, V
DLY
, and Delay Pin Charge Current, I
DLY1
, as in the
next formula.
t=C2
×
V
DLY
/I
DLY1
Once after the maximum duty is detected and released before delay time, charge to the capacitor is halt and delay
pin outputs “L”.
G
As for R1211X002A/C version, the values and positioning of C4, C5, R3, and R4 shown in the above diagram are
just an example combination. These are for making phase compensation. If the spike noise of V
OUT
may be large,
the spike noise may be picked into V
FB
pin and make the operation unstable. In this case, a resistor R3, shown in
typical applications of the previous page. The recommended resistance value of R3 is in the range from 10k
to
50k
. Then, noise level will be decreased.
G
As for R1211X002B/D version, EXT pin outputs GND level at standby mode.
G
Select the Power MOSFET, the diode, and the inductor within ratings (Voltage, Current, Power) of this IC. Choose
the power MOSFET with low threshold voltage depending on Input Voltage to be able to turn on the FET completely.
Choose the diode with low V
F
such as Shottky type, and with low reverse current I
R,
and with fast switching speed.
When an external transistor is switching, spike voltage may be generated caused by an inductor, therefore
recommended voltage tolerance of capacitor connected to V
OUT
is three times of setting voltage or more.
The performance of power circuit with using this IC depends on external components. Choose the most suitable
components for your application.
相關PDF資料 |
PDF描述 |
|---|---|
| R1211D002A | Step-up DC/DC Controller |
| R1211D002A-TR | Step-up DC/DC Controller |
| R1211D002C | Step-up DC/DC Controller |
| R1211D002C-TR | Step-up DC/DC Controller |
| R1221N33AA-TR | Step-down DC/DC Converter with Voltage Detector |
相關代理商/技術參數 |
參數描述 |
|---|---|
| R1211N002X | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Power Management ICs |
| R1211X | 制造商:RICOH 制造商全稱:RICOH electronics devices division 功能描述:Step-up DC/DC Controller |
| R12-12012X2E1 | 制造商:M.E.C. TIMERS 功能描述: |
| R12-12024X2E1 | 制造商:TE Connectivity 功能描述: |
| R12-12048X4E1 | 制造商:TE Connectivity 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。