- 您現在的位置：買賣IC網 > PDF目錄69255 > PTH12050WAS (TEXAS INSTRUMENTS INC) 1-OUTPUT DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PTH12050WAS |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| 封裝： | DIP-6 |
| 文件頁數： | 6/26頁 |
| 文件大?。?/td> | 1233K |
| 代理商： | PTH12050WAS |
www.ti.com
Q1VDS (2 V/div)
VO (2 V/div)
II (2 A/div)
t Time 40 ms/div
SLTS214H – MAY 2003 – REVISED OCTOBER 2007
Figure 12. Power-Up from Track Control
NOTE:
If a prebias condition is not present, it is highly recommended that the Track control
pin be used for controlled power-up and power-down. If Track control is not used, the
output voltage starts up and overshoots by as much as 10%, before settling at the
output voltage setpoint.
How Auto-Track Works
Auto-Track works by forcing the module output voltage to follow a voltage presented at the Track control pin (1).
This control range is limited to between 0 V and the module set-point voltage. Once the track-pin voltage is
raised above the set-point voltage, the module output remains at its set-point (2). As an example, if the Track pin
of a 2.5-V regulator is at 1 V, the regulated output is 1 V. If the voltage at the Track pin rises to 3 V, the regulated
output does not go higher than 2.5 V.
When under Auto-Track control, the regulated output from the module follows the voltage at its Track pin on a
volt-for-volt basis. By connecting the Track pin of a number of these modules together, the output voltages follow
a common signal during power up and power down. The control signal can be an externally generated master
ramp waveform, or the output voltage from another power supply circuit (3). For convenience, the Track input
incorporates an internal RC-charge circuit. This operates off the module input voltage to produce a suitable rising
waveform at power up.
14
Copyright 2003–2007, Texas Instruments Incorporated
Product Folder Link(s): PTH12050W/L
相關PDF資料 |
PDF描述 |
|---|---|
| PTH12050WAD | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PTH12060LAST | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PTH12060WAD | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PTH12060LAS | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PTH12060WAST | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PTH12050WAST | 功能描述:DC/DC轉換器 1.2 to 5.5V 6A 12V Input WideAdj Module RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PTH12050WAZ | 功能描述:DC/DC轉換器 1.2 to 5.5V 6A 12V Input WideAdj Module RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PTH12050WAZT | 功能描述:DC/DC轉換器 1.2 to 5.5V 6A 12V Input WideAdj Module RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PTH12050Y | 制造商:TI 制造商全稱:Texas Instruments 功能描述:6-A Non-Isolated DDR/QDR Memory Bus Termination Modules |
| PTH12050YAD | 功能描述:DC/DC轉換器 10.8W 12VDC .55-1.8V Through-Hole RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發(fā)布緊急采購，3分鐘左右您將得到回復。