- 您現在的位置：買賣IC網 > PDF目錄96795 > PT7615A (TEXAS INSTRUMENTS INC) 20 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA27 PDF資料下載
參數資料
| 型號： | PT7615A |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 20 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA27 |
| 封裝： | HORIZONTAL MOUNT PACKAGE-27 |
| 文件頁數： | 6/8頁 |
| 文件大?。?/td> | 197K |
| 代理商： | PT7615A |
Application Notes
For technical support and more information, see inside back cover or visit www.ti.com
Pin-Coded Output Voltage Adjustment of
20-A Programmable Regulators
The 20-A family of programmable ISRs incorporate a pin-
coded control to adjust the output voltage. This feature
uses the control pins VID0–VID4 (pins 1–6). When
the control pins are left open-circuit, the ISR output
regulates at its default output voltage. Each control pin
is internally connected to a precision resistor, which
when grounded applies a weighted change to the output
voltage. By selectively grounding VID0–VID4, the output
voltage of these ISRs can be programmed in incremental
steps over the module’s output voltage range. The program
codes and output voltage range offered by these ISRs are
compatible with the Voltage ID specifications defined by
Intel Corporation for VRMs (voltage regulator mod-
ules). The codes are used by both the Pentium and
Athlon microprocessors. Refer to Figure 1 for the
connection schematic, and the respective device Data Sheet
for the programming code information.
Notes:
1. The programming convention is as follows:
Logic 0:
Connect to pin 12 (Remote Sense Ground).
Logic 1:
Open circuit/open drain (See notes 2, & 4)
2. Do not connect pull-up resistors to the voltage
programming pins.
3. Use pin 12 (Remote Sense Ground) as the logic “0”
reference. While the regular ground (pins 13-19) can also
be used for programming, doing so will degrade the load
reglation of the product. If the remote sense ground is
not used, pin 12 must be connected to pin 13 for
optimum output voltage accuracy.
Figure 1
4. If active devices are used to ground the voltage control
pins, low-level open drain MOSFET devices should be
used over bipolar transistors. The inherent Vce(sat) in
bipolar devices introduces errors in the device’s internal
divider network. Discrete transistors such as the BSS138,
2N7002, or IRLML2402 are examples of appropriate
devices.
Active Voltage Programming:
Special precautions should be taken when making changes
to the voltage control progam code while the unit is
powered. It is highly recommended that the ISR be either
powered down or held in standby. Changes made to the
program code while Vout is enabled induces high current
transients through the device. This is the result of the
electrolytic output capacitors being either charged or
discharged to the new output voltage set-point. The
transient current can be minimized by making only in-
cremental changes to the binary code, i.e. one LSB at a
time. A minimum of 100s settling time between each
program state is also recommended. Making non-
incremental changes to VID3 or VID4 while the output
is enabled is discouraged. The transients induced can
overstress the device. If the program code cannot be
asserted priot to power-up, pull pin 5 (STBY) control to
GND during the period that the input voltage is applied
to Vin. Releasing pin 5 will then allow the device to per-
form a soft-start to the programmed voltage. For more
information on the use of the Standby function, consult
the related application note, “Using the Standby Function
on 20-A Programmable Switching Regulators”
C
out
+
C
in
+
1H
(Optional)
+5V
COM
STBY
L
O
A
D
64321
26
20-25
12
5
13-19
27
7-11
Vo
Vin
GND
SNS(+)
SNS(-)
Synch
Out
STBY
VID4 - VID0
PT770X/PT761X
PT7708/09, PT7615
相關PDF資料 |
PDF描述 |
|---|---|
| PT7615N | 20 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA27 |
| PT7673N | 30 A SWITCHING REGULATOR, 350 kHz SWITCHING FREQ-MAX, MSMA27 |
| PT7701N | 15 A SWITCHING REGULATOR, 750 kHz SWITCHING FREQ-MAX, SMA27 |
| PT7702A | SWITCHING REGULATOR, SIP27 |
| PT7702N | SWITCHING REGULATOR, SIP27 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PT7615C | 制造商:TI 制造商全稱:Texas Instruments 功能描述:20-A Low-Voltage Programmable Integrated Switching Regulator |
| PT7615N | 制造商:TI 制造商全稱:Texas Instruments 功能描述:20-A Low-Voltage Programmable Integrated Switching Regulator |
| PT7616 | 制造商:DIODES 制造商全稱:Diodes Incorporated 功能描述:DIODE MODULE 75A/1200V/1600V |
| PT7671 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:1.3V to 3.5V 32A. 5-V Input Programmable ISR |
| PT7671-5V | 制造商:TI 制造商全稱:Texas Instruments 功能描述:30-A Programmable Integrated Switching Regulator |
發布緊急采購，3分鐘左右您將得到回復。