- 您現在的位置：買賣IC網 > PDF目錄368147 > PSD411A2-20UI 200V 100kRad Hi-Rel Single N-Channel TID Hardened MOSFET in a TO-205AF package; JANS Certified version of the IRHF7230 PDF資料下載
參數資料
| 型號： | PSD411A2-20UI |
| 英文描述： | 200V 100kRad Hi-Rel Single N-Channel TID Hardened MOSFET in a TO-205AF package; JANS Certified version of the IRHF7230 |
| 中文描述： | 現場可編程外圍 |
| 文件頁數： | 8/123頁 |
| 文件大?。?/td> | 657K |
| 代理商： | PSD411A2-20UI |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁
PSD4XX Famly
5
5.0
Integrated
Power
Management
TM
Operation
Upon each address or logic input change to the ZPSD, the device powers up from low
power standby for a short time. Then the ZPSD consumes only the necessary power to
deliver new logic or memory data to its outputs as a response to the input change. After the
new outputs are stable, the ZPSD latches them and automatically reverts back to standby
mode. The I
CC
current flowing during standby mode and during DC operation is identical
and is only a few microamperes.
The ZPSD automatically reduces its DC current drain to these low levels and does not
require controlling by the CSI (Chip Select Input). Disabling the CSI pin unconditionally
forces the ZPSD to standby mode independent of other input transitions.
The only significant power consumption in the ZPSD occurs during AC operation.
The ZPSD contains the first architecture to apply zero power techniques to memory and
logic blocks.
Figure 2 compares ZPSD Zero-power operation to the operation of a discrete solution.
A standard microcontroller (MCU) bus cycle usually starts with an ALE (or AS) pulse and
the generation of an address. The ZPSD detects the address transition and powers up for a
short time. The ZPSD then latches the outputs of the PAD, EPROM and SRAM to the new
values. After finishing these operations, the ZPSD shuts off its internal power, entering
standby mode. The time taken for the entire cycle is less than the ZPSD’s “access time.”
The ZPSD will stay in standby mode if inputs do not change between bus cycles. In an
alternate system implementation using discrete EPROM, SRAM, and other discrete
components, the system will consume operating power during the entire bus cycle. This is
because the chip select inputs on the memory devices are usually active throughout the
entire cycle. The AC power consumption of the ZPLD may be calculated using the
composite frequency of the MCU address and control signals, as well as any other logic
inputs to the ZPLD.
NOTE:
The ZPSD4XX is rated for lower standby current (I
SB
) than the PSD4XX.
ALE
DISCRETE EPROM, SRAM & LOGIC
ADDRESS
EPROM
ACCESS
SRAM
ACCESS
EPROM
ACCESS
I
CC
ZPSD
ZPSD
ZPSD
TIME
Figure 2. Zero-Power Operation vs. Dscrete Implementation
相關PDF資料 |
PDF描述 |
|---|---|
| PSD411A2-70J | 100V 100kRad Hi-Rel Single N-Channel TID Hardened MOSFET in a TO-204AE package; Similar to IRH7150 with optional Total Dose Rating of 500kRads |
| PSD411A2-70U | Field-Programmable Peripheral |
| PSD411A2-90J | -200V 100kRad Hi-Rel Single P-Channel TID Hardened MOSFET in a TO-204AA package; A IRH9230 with Standard Packaging |
| PSD411A2-90U | 200V 100kRad Hi-Rel Single N-Channel TID Hardened MOSFET in a TO-257AA package; Similar to IRHY7230CM with optional Total Dose Rating of 300kRads |
| PSD412A0 | 200V 100kRad Hi-Rel Single N-Channel TID Hardened MOSFET in a TO-257AA package; A IRHY7230CM with Standard Packaging |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PSD411A2-70J | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Peripheral |
| PSD411A2-70U | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Peripheral |
| PSD411A2-90J | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Peripheral |
| PSD411A2-90U | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Peripheral |
| PSD411A2-C-15J | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low Cost Field Programmable Microcontroller Peripherals |
發布緊急采購，3分鐘左右您將得到回復。