- 您現在的位置：買賣IC網 > PDF目錄224796 > PS9817-1-V-F4 (California Eastern Laboratories) Power Resistor; Series:MK; Resistance:10ohm; Resistance Tolerance:+/- 1 %; Power Rating:0.75W; Voltage Rating:400V; Temperature Coefficient:+/-50 ppm; Mounting Type:Through Hole; Operating Temp. Min:0 C; Terminal Type:Radial Leaded PDF資料下載
參數資料
| 型號： | PS9817-1-V-F4 |
| 廠商： | California Eastern Laboratories |
| 英文描述： | Power Resistor; Series:MK; Resistance:10ohm; Resistance Tolerance:+/- 1 %; Power Rating:0.75W; Voltage Rating:400V; Temperature Coefficient:+/-50 ppm; Mounting Type:Through Hole; Operating Temp. Min:0 C; Terminal Type:Radial Leaded |
| 中文描述： | 鄰舍高CMR，10Mbps的集電極開路輸出型8引腳SSOP（以SO - 8）高速光電耦合器 |
| 文件頁數： | 3/12頁 |
| 文件大小： | 592K |
| 代理商： | PS9817-1-V-F4 |
PS9817-1,-2
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reow soldering
Peak reow temperature
260°C or below (package surface temperature)
Time of peak reow temperature
10 seconds or less
Time of temperature higher than 220°C
60 seconds or less
Time to preheat temperature from 120 to 180°C 120±30 s
Number of reows
Three
Flux
Rosin ux containing small amount of chlorine (The ux with a maximum
chlorine content of 0.2 Wt% is recommended.)
(2) Wave soldering
Temperature
260°C or below (molten solder temperature)
Time
10 seconds or less
Preheating conditions
120°C or below (package surface temperature)
Number of times
One (Allowed to be dipped in solder including plastic mold portion.)
Flux
Rosin ux containing small amount of chlorine (The ux with a maximum chlorine content of 0.2
Wt% is recommended.)
(3) Soldering by Soldering Iron
Peak Temperature (lead part temperature) 350°C or below
Time (each pins)
3 seconds or less
Flux
Rosin ux containing small amount of chlorine (The ux with a maximum
chlorine content of 0.2 Wt% is recommended.)
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead
(b) Please be sure that the temperature of the package would not be heated over 100°C
120±30 s
(preheating)
220C
180C
Package
Surface
T
emperature
T
(C)
Time (s)
Recommended Temperature Profile of Infrared Reflow
(heating)
to 10 s
to 60 s
260C MAX.
120C
相關PDF資料 |
PDF描述 |
|---|---|
| PSB3AC | VCO |
| PSCIA2CHP-1 | P-CHANNEL, Si, SMALL SIGNAL, JFET |
| PSD2-24 | POWER TRANSFORMER, 1.1 VA |
| PSD2-28 | POWER TRANSFORMER, 1.1 VA |
| PSD2-36 | POWER TRANSFORMER, 1.1 VA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PS9817-2 | 制造商:CEL 制造商全稱:CEL 功能描述:NECs HIGH CMR, 10Mbps OPEN COLLECTOR OUTPUT TYPE 8-PIN SSOP (SO-8) HIGH-SPEED OPTOCOUPLER |
| PS9817-2-A | 功能描述:高速光耦合器 10Mbps H-Spd Digital RoHS:否 制造商:Avago Technologies 電流傳遞比: 最大波特率: 最大正向二極管電壓:1.75 V 最大反向二極管電壓:5 V 最大功率耗散:40 mW 最大工作溫度:+125 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-5 封裝:Tube |
| PS9817-2-AX | 功能描述:高速光耦合器 SO8 DulCH HISpd Digi Cpler 10Mb HI Perf RoHS:否 制造商:Avago Technologies 電流傳遞比: 最大波特率: 最大正向二極管電壓:1.75 V 最大反向二極管電壓:5 V 最大功率耗散:40 mW 最大工作溫度:+125 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-5 封裝:Tube |
| PS9817-2-F3 | 制造商:CEL 制造商全稱:CEL 功能描述:NECs HIGH CMR, 10Mbps OPEN COLLECTOR OUTPUT TYPE 8-PIN SSOP (SO-8) HIGH-SPEED OPTOCOUPLER |
| PS9817-2-F3-A | 功能描述:PHOTOCOUPLER HS DGTL OC OUT SMD RoHS:是 類別:隔離器 >> 光隔離器 - 邏輯輸出 系列:NEPOC 標準包裝:1,000 系列:- 電壓 - 隔離:7500Vrms 通道數:1，單向 電流 - 輸出 / 通道:50mA 數據速率:5MHz 傳輸延遲高 - 低 @ 如果:100ns 電流 - DC 正向(If):5mA 輸入類型:DC 輸出類型:開路集電極 安裝類型:表面貼裝 封裝/外殼:6-SMD 供應商設備封裝:6-SMD 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。