- 您現在的位置：買賣IC網 > PDF目錄378063 > PR36MF21NSZF (Sharp Corporation) IT(rms)÷0.6A, Zero Cross type DIP 8pin Triac output SSR PDF資料下載
參數資料
| 型號： | PR36MF21NSZF |
| 廠商： | Sharp Corporation |
| 英文描述： | IT(rms)÷0.6A, Zero Cross type DIP 8pin Triac output SSR |
| 中文描述： | 資訊科技（有效值）÷ 0.6A的電流，零交叉式雙酯雙向晶閘管輸出蘇維埃社會主義共和國，8引腳 |
| 文件頁數： | 9/15頁 |
| 文件大?。?/td> | 289K |
| 代理商： | PR36MF21NSZF |
9
PR26MF21NSZ Series
PR36MF2xNSZ Series
■
Design Considerations
●
Recommended Operating Conditions
Parameter
Input signal current
at ON state
Input signal current at OFF state
In order for the SSR to turn off, the triggering current (I
F
) must be 0.1mA or less.
Particular attention needs to be paid when utilizing SSRs that incorporate zero crossing circuitry.
If the phase difference between the voltage and the current at the output pins is large enough, zero crossing
type SSRs cannot be used. The result, if zero crossing SSRs are used under this condition, is that the SSR
may not turn on and off irregardless of the input current. In this case, only a non zero cross type SSR should
be used in combination with the above mentioned snubber circuit selection process.
When the input current (I
F
) is below 0.1mA, the output Triac will be in the open circuit mode. However, if the
voltage across the Triac, V
D
, increases faster than rated dV/dt, the Triac may turn on. To avoid this situation,
please incorporate a snubber circuit. Due to the many different types of load that can be driven, we can
merely recommend some circuit values to start with : Cs
=
0.022
μ
F and Rs
=
47
. The operation of the SSR
and snubber circuit should be tested and if unintentional switching occurs, please adjust the snubber circuit
component values accordingly.
When making the transition from On to Off state, a snubber circuit should be used ensure that sudden drops
in current are not accompanied by large instantaneous changes in voltage across the Triac.
This fast change in voltage is brought about by the phase difference between current and voltage.
Primarily, this is experienced in driving loads which are inductive such as motors and solenods.
Following the procedure outlined above should provide sufficient results.
For over voltage protection, a Varistor may be used.
Any snubber or Varistor used for the above mentioned scenarios should be located as close to the main
output triac as possible.
All pins shall be used by soldering on the board. (Socket and others shall not be used.)
●
Degradation
In general, the emission of the IRED used in SSR will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these SSRs should provide at least
twice the minimum required triggering current from initial operation.
●
Design guide
Sheet No.: D4-A00501EN
PR26MF21NSZ
PR36MF2xNSZ
Symbol
Unit
Input
Output
Load supply voltage
Load supply current
Frequency
Operating temperature
I
F
(ON)
I
F
(OFF)
V
OUT
(rms)
I
OUT
(rms)
f
T
opr
mA
mA
V
mA
Hz
C
Locate snubber circuit between output terminals
(Cs
=
0.022
μ
F, Rs
=
47
)
Conditions
20
10
0
50
20
25
15
0.1
120
240
I
T
(rms)
×
80%(
)
60
80
MIN.
MAX.
(
) See Fig.2 about derating curve (I
T
(rms) vs. ambient temperature).
Rank 1
Rank 2
相關PDF資料 |
PDF描述 |
|---|---|
| PR36MF21YIPF | IT(rms)÷0.6A, Zero Cross type DIP 8pin Triac output SSR |
| PR36MF21YSZ | IT(rms)÷0.6A, Zero Cross type DIP 8pin Triac output SSR |
| PR36MF21YSZF | IT(rms)÷0.6A, Zero Cross type DIP 8pin Triac output SSR |
| PR36MF22NIPF | IT(rms)÷0.6A, Zero Cross type DIP 8pin Triac output SSR |
| PR36MF22NSZF | IT(rms)÷0.6A, Zero Cross type DIP 8pin Triac output SSR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PR36MF21YIPF | 制造商:SHARP 制造商全稱:Sharp Electrionic Components 功能描述:IT(rms)≤0.6A, Zero Cross type DIP 8pin Triac output SSR |
| PR36MF21YSZ | 制造商:SHARP 制造商全稱:Sharp Electrionic Components 功能描述:IT(rms)≤0.6A, Zero Cross type DIP 8pin Triac output SSR |
| PR36MF21YSZF | 功能描述:固態繼電器-PCB安裝 8-DIP ZC 10mA T/H RoHS:否 制造商:Omron Electronics 控制電壓范圍: 負載電壓額定值:40 V 負載電流額定值:120 mA 觸點形式:1 Form A (SPST-NO) 輸出設備:MOSFET 封裝 / 箱體:USOP-4 安裝風格:SMD/SMT |
| PR36MF22NIPF | 制造商:SHARP 制造商全稱:Sharp Electrionic Components 功能描述:IT(rms)≤0.6A, Zero Cross type DIP 8pin Triac output SSR |
| PR36MF22NSZ | 功能描述:RELAY SSR 240VAC .6A ZC 8-DIP RoHS:否 類別:繼電器 >> 固態 系列:PR36MF 其它有關文件:AQx REACH Cert of Compliance 特色產品:AQY Series Relays 標準包裝:1 系列:PhotoMOS™ AQY 電路:SPST-NO（1 Form A） 輸出類型:AC，DC（RF） 導通狀態電阻:1.25 歐姆 負載電流:250mA 輸入電壓:1.3VDC 電壓 - 負載:0 ~ 40 V 安裝類型:表面貼裝 端接類型:SMD（SMT）接片 封裝/外殼:4-SMD（0.175"，4.45mm） 供應商設備封裝:4-SSOP 包裝:Digi-Reel® 繼電器類型:繼電器 其它名稱:255-2683-6 |
發布緊急采購，3分鐘左右您將得到回復。