參數資料
型號: PPC440SP-RFC533C
廠商: APPLIEDMICRO INC
元件分類: 微控制器/微處理器
英文描述: PowerPC 440SP Embedded Processor
中文描述: 32-BIT, 533 MHz, RISC PROCESSOR, PBGA783
封裝: 29 X 29 MM, 1 MM PITCH, PLASTIC, FCBGA-783
文件頁數: 69/85頁
文件大?。?/td> 615K
代理商: PPC440SP-RFC533C
PowerPC 440SP Embedded Processor
Revision 1.23 - Sept 26, 2006
Data Sheet
AMCC Proprietary
69
Spread Spectrum Clocking
Care must be taken when using a spread spectrum clock generator (SSCG) with the PPC440SP. This controller
uses a PLL for clock generation inside the chip. The accuracy with which the PLL follows the SSCG is referred to
as tracking skew. The PLL bandwidth and phase angle determine how much tracking skew there is between the
SSCG and the PLL for a given frequency deviation and modulation frequency. When using an SSCG with the
PPC440SP the following conditions must be met:
The frequency deviation must not violate the minimum clock cycle time. Therefore, when operating the
PPC440SP with one or more internal clocks at their maximum supported frequency, the SSCG can only lower
the frequency.
The maximum frequency deviation cannot exceed -1%, and the modulation frequency cannot exceed 40 kHz.
In some cases, on-board PPC440SP peripherals impose more stringent requirements.
Use the Peripheral Bus Clock for logic that is synchronous to the peripheral bus since this clock tracks the
modulation.
Use the DDR SDRAM MemClkOut since it also tracks the modulation.
For PCI-X and PCI 66 the maximum spread spectrum is -1% modulated between 30kHz and 33kHz.
Notes:
1. The serial port baud rates are synchronous to the modulated clock. The serial port has a tolerance of
approximately 1.5% on baud rate before framing errors begin to occur. The 1.5% tolerance assumes that
the connected device is running at precise baud rates.
2. Ethernet operation is unaffected.
3. IIC operation is unaffected.
Important:
It is up to the system designer to ensure that any SSCG used with the PPC440SP meets the above
requirements and does not adversely affect other aspects of the system.
相關PDF資料
PDF描述
PPC440SP-RFC667C PowerPC 440SP Embedded Processor
PPC440SP-RNC533C PowerPC 440SP Embedded Processor
PPC440SP-RNC667C PowerPC 440SP Embedded Processor
PPC50505
PPC511
相關代理商/技術參數
參數描述
PPC440SP-RFC667C 制造商:AMCC 制造商全稱:Applied Micro Circuits Corporation 功能描述:PowerPC 440SP Embedded Processor
PPC440SP-RNC533C 制造商:AMCC 制造商全稱:Applied Micro Circuits Corporation 功能描述:PowerPC 440SP Embedded Processor
PPC440SP-RNC667C 制造商:AMCC 功能描述:AMCPPC440SP-RNC667C PWR PROCESSOR CORE
PPC-46 功能描述:電源變壓器 115/230Vac 50/60Hz 1.5VA RoHS:否 制造商:Triad Magnetics 功率額定值:12 VA 初級電壓額定值:115 V / 230 V 次級電壓額定值:12 V / 24 V 安裝風格:SMD/SMT 一次繞組:Dual Primary Winding 二次繞組:Dual Secondary Winding 長度:2.5 in 寬度:2 in 高度:1.062 in
PPC460EX-NUA1000T 制造商:AppliedMicro 功能描述:32 BIT POWERPC CORE, UP TO 1.2 GHZ, 2 10/100/1G ETHERNET, US - Trays