參數資料
型號： PPC405EP-3LB200C
廠商： APPLIEDMICRO INC
元件分類： 微控制器/微處理器
英文描述： PowerPC 405EP Embedded Processor
中文描述： 32-BIT, 200 MHz, RISC PROCESSOR, PBGA385
封裝： 31 X 31 MM, LEAD FREE, PLASTIC, EBGA-385
文件頁數： 42/50頁
文件大小： 373K
代理商： PPC405EP-3LB200C
PPC405EP – PowerPC 405EP Embedded Processor
42
AMCC
Revision 1.07 – September 10, 2007
Data Sheet
Spread Spectrum Clocking
Care must be taken when using a spread spectrum clock generator (SSCG) with the PPC405EP. This controller
uses a PLL for clock generation inside the chip. The accuracy with which the PLL follows the SSCG is referred to
as tracking skew. The PLL bandwidth and phase angle determine how much tracking skew there is between the
SSCG and the PLL for a given frequency deviation and modulation frequency. When using an SSCG with the
PPC405EP the following conditions must be met:
The frequency deviation must not violate the minimum clock cycle time. Therefore, when operating the
PPC405EP with one or more internal clocks at their maximum supported frequency, the SSCG can only
lower the frequency.
The maximum frequency deviation cannot exceed
3%, and the modulation frequency cannot exceed
40kHz. In some cases, on-board PPC405EP peripherals impose more stringent requirements (see Note 1).
Use the peripheral bus clock (PerClk) for logic that is synchronous to the peripheral bus since this clock
tracks the modulation.
Use the SDRAM MemClkOut since it also tracks the modulation.
Notes:
1. The serial port baud rates are synchronous to the modulated clock. The serial port has a tolerance of approx-
imately 1.5% on baud rate before framing errors begin to occur. The 1.5% tolerance assumes that the
connected device is running at precise baud rates. If an external serial clock is used the baud rate is unaf-
fected by the modulation.
2. Operation of the PPC405EP PCI Bridge is unaffected by the use of an SSCG.
The PCI controller must be operated in asynchronous mode. When in asynchronous mode, the PCI bus clock
must be driven into the PPC405EP PCIClk input. In this configuration the PCI controller supports the
66.66 MHz PCI clock specification which specifies a maximum frequency deviation of -1% at a modulation of
between 30 kHz and 33 kHz.
3. Ethernet operation is unaffected.
4. IIC operation is unaffected.
Caution:
It is up to the system designer to ensure that any SSCG used with the PPC405EP meets the above
requirements and does not adversely affect other aspects of the system.
相關PDF資料
PDF描述
PPC405EP-3LB200CZ PowerPC 405EP Embedded Processor
PPC405EP-3LB266C PowerPC 405EP Embedded Processor
PPC405EP-3LB266CZ PowerPC 405EP Embedded Processor
PPC405EP-3LB333C PowerPC 405EP Embedded Processor
PPC405EP-3LB333CZ PowerPC 405EP Embedded Processor
相關代理商/技術參數
參數描述
PPC405EP-3LB200CZ 制造商:AppliedMicro 功能描述:MPU 405EP RISC 32-Bit 0.18um 200MHz 3.3V 385-Pin EBGA T/R
PPC405EP-3LB266C 制造商:AppliedMicro 功能描述:MPU 405EP RISC 32-Bit 0.18um 266MHz 3.3V 385-Pin EBGA Tray 制造商:AMCC 功能描述:MPU 405EP RISC 32BIT 0.18UM 266MHZ 3.3V 385PIN EBGA - Trays 制造商:AMCC 功能描述:AMCPPC405EP-3LB266C 32BIT PPC UP TO 333M 制造商:Applied Micro Circuits Corporation 功能描述:MPU 405EP RISC 32-Bit 0.18um 266MHz 3.3V 385-Pin EBGA Tray
PPC405EP-3LB266CZ 制造商:AppliedMicro 功能描述:MPU 405EP RISC 32-Bit 0.18um 266MHz 3.3V 385-Pin EBGA T/R 制造商:AMCC 功能描述:AMCPPC405EP-3LB266CZ 32B MPU EOL040910
PPC405EP-3LB333C 制造商:AMCC 功能描述:MPU 405EP RISC 32BIT 0.18UM 333MHZ 3.3V 385BGA - Trays 制造商:AMCC 功能描述:AMCPPC405EP-3LB333C 32 BIT POWER PCCORE
PPC405EP-3LB333CZ 制造商:AMCC 制造商全稱:Applied Micro Circuits Corporation 功能描述:PowerPC 405EP Embedded Processor
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*