參數(shù)資料
型號: PM211J
英文描述: Analog Comparator
中文描述: 模擬比較器
文件頁數(shù): 3/44頁
文件大?。?/td> 186K
代理商: PM211J
Document No: DS8102
Issue: C
Page 3
GENERAL SAFETY POINTS
This equipment has been designed and tested to meet strict international safety requirements,
attention to the following general guidelines will ensure it's continued safe operation.
Always connect mains equipment to a properly grounded power socket. The socket must conform
to I.E.C. publication 364 "Electrical Installation of Buildings", or the equivalent national standard for
example "15th Edition of I.E.E. Wiring Regulations" in the United Kingdom. If in doubt have the
power socket checked by a qualified electrician.
For protection against electric shock, certain parts of equipment, including the interface
connections, are designed such that the voltage is limited to a safe value. In order to maintain this
protection it is essential that any equipment connected to the printer has interface connections that
are similarly protected.
It is recommended that assurance is obtained from manufacturers / suppliers of such equipment
that interfaces comply with the requirements of PELV circuits in accordance with BS7002 or SELV
circuits in accordance with I.E.C. 435 edition 2.
In some cases where equipment is supplied with a moulded mains plug which is not compatible
with local sockets the moulded plug should be cut off and destroyed.
MOULDED MAINS PLUGS
WHICH HAVE BEEN CUT OFF ARE POTENTIALLY DANGEROUS AND MUST BE DESTROYED.
Unless equipment is designed to be used without an earth, e.g. battery powered or double
insulated equipment, the equipment must be earthed.
Always exercise care in moving/positioning equipment.
Always site equipment on a surface suitable for it's weight.
Always use the correct consumables (e.g. paper and ribbons). Use of incorrect consumables will
invalidate the warranty and may result in degraded performance/reduced equipment life.
Do not remove plates, covers or guards that are secured in place by screws or clips. There are no
user serviceable areas within such covers and their removal will invalidate the warranty and may
pose a safety risk.
Do not override or defeat mechanical or electrical interlock devices.
Do not allow hair, jewellery or clothing to hang into the equipment (particularly whilst changing
consumables) since this poses a serious safety risk.
Do not operate the equipment if unusual smells or noises are noticed. Turn the equipment off and
contact your supplier for advice.
相關PDF資料
PDF描述
PM211P Analog Comparator
PM211S Analog Comparator
PM211Y Analog Comparator
PM211Z Analog Comparator
PM114 Dual Zero-Drift Operational Amplifiers; Package: MSOP; No of Pins: 8; Temperature Range: -40°C to +85°C
相關代理商/技術參數(shù)
參數(shù)描述
PM211P 制造商:Analog Devices 功能描述:
PM211S 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog Comparator
PM211Y 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog Comparator
PM211Z 制造商:Rochester Electronics LLC 功能描述:- Bulk
PM2120-100K 功能描述:固定電感器 10uH 10% RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm