PM1012
–3–
REV. C
ABSOLUT E MAX IMUM RAT INGS
1
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
±
20 V
Input Voltage
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
±
20 V
Differential Input Voltage
3
. . . . . . . . . . . . . . . . . . . . . .
±
1 V
Differential Input Current
3
. . . . . . . . . . . . . . . . . . . .
±
10 mA
Output Short-Circuit Duration . . . . . . . . . . . . . . . . Indefinite
Operating T emperature Range
PM1012G (P, S) . . . . . . . . . . . . . . . . . . . . –40
°
C to +85
°
C
Storage T emperature Range . . . . . . . . . . . . –65
°
C to +150
°
C
Junction T emperature Range . . . . . . . . . . . . –65
°
C to +150
°
C
Lead T emperature (Soldering, 60 sec) . . . . . . . . . . . +300
°
C
Package T ype
u
JA
103
158
4
u
JC
43
43
Units
°
C/W
°
C/W
8-Lead Plastic DIP (P)
8-Lead SO (S)
ORDE RING GUIDE
T emperature
Range
–40
°
C to +85
°
C
–40
°
C to +85
°
C
Package
Description
Package
Options
Model
PM1012GP
PM1012GS
Plastic DIP
SOIC
N-8
SO-8
CAUT ION
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily
accumulate on the human body and test equipment and can discharge without detection.
Although the PM1012 features proprietary ESD protection circuitry, permanent damage may
occur on devices subjected to high energy electrostatic discharges. T herefore, proper ESD
precautions are recommended to avoid performance degradation or loss of functionality.
WARNNG
ESD SENSITIVE DEVICE
NOT ES
1
Absolute maximum ratings apply to both DICE and packaged parts, unless
otherwise noted.
2
For supply voltages less than
±
20 V, the absolute maximum input voltage is equal
to the supply voltage.
3
T he PM1012’s inputs are protected by back-to-back diodes. Current-limiting
resistors are not used in order to achieve low noise. Differential input voltages
greater than 1 V will cause excessive current to flow through the input protection
diodes unless limiting resistance is used.
4
θ
is specified for worst case mounting conditions, i.e.,
θ
is specified for device
in socket for cerdip, and P-DIP packages;
θ
JA
is specified for device soldered to
printed circuit board for SO package.