- 您現在的位置：買賣IC網 > PDF目錄98054 > PKY4616PIM (ERICSSON POWER MODULES AB) 1-OUTPUT 600 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PKY4616PIM |
| 廠商： | ERICSSON POWER MODULES AB |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 600 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT PACKAGE-16 |
| 文件頁數： | 4/18頁 |
| 文件大?。?/td> | 618K |
| 代理商： | PKY4616PIM |
Ericsson Internal
PRODUCT SPECIFICATION
2 (6)
Prepared (also subject responsible if other)
No.
MPM//BM/ Andrzej Wojtasik
3/1301-BMR 638/1 Uen
Approved
Checked
Date
Rev
Reference
SEC/D (Julia You)
EUSSVEN
2007-08-15
B
Operating information
Input Voltage
The input voltage range 36 to 75Vdc meets the requirements
of the European Telecom Standard ETS 300 132-2 for normal
input voltage range in —48 and —60 Vdc systems, -40.5 to -
57.0 V and —50.0 to -72 V respectively.
At input voltages exceeding 75 V, the power loss will be
higher than at normal input voltage and T
ref must be limited to
absolute max +110°C. The absolute maximum continuous
input voltage is 100 Vdc.
Turn-off Input Voltage
The DC/DC converters monitor the input voltage and will turn
on and turn off at predetermined levels.
The minimum hysteresis between turn on and turn off input
voltage is 1V.
Remote Control (RC)
The modules are equipped with a remote On/Off control
function. An optocoupler in the remote control circuit
provides a galvanic isolation (1500V DC minimum) between
the remote control pins and the rest of the module’s circuity.
Positive and negative RC logic options are available.
Cycling (Off and On sequence) of the RC input will restart the
module if latched after activation of the output overvoltage
protection function.
The standard version has a “positive logic” remote control
and the module will be off until a sufficient current between
the RC pins is provided.
The figure above presents an example of a circuit which turns
on the standard version module. The minimum current to
guarantee the activation of the RC input is 1,5mA. The
minimum activation voltage over the RC pins is 5.0V. To
guarantee that the RC input is not activated, the current must
be lower than 50μA or the voltage lower than 1,3V.
Input and Output Impedance
The impedance of both the input source and the load will
interact with the impedance of the DC/DC converter. It is
important that the input source has low characteristic
impedance. The converters are designed to be stable without
external capacitors on input or output. However, the module
performance can be enhanced by adding external capacitors
as described under External Decoupling Capacitors.
If the input voltage source contains significant inductance, the
addition of a 220 μF/100 V capacitor across the input of the
converter will ensure stable operation. The capacitor is not
required when powering the DC/DC converter from an input
source with an inductance below10 μH.
External Decoupling Capacitors
When powering loads with significant dynamic current
requirements, the voltage regulation at the point of load can
be improved by addition of decoupling capacitors at the load.
The most effective technique is to locate low ESR ceramic
and electrolytic capacitors as close to the load as possible,
using several parallel capacitors to lower the effective ESR.
The ceramic capacitors will handle high-frequency dynamic
load changes while the electrolytic capacitors are used to
handle low frequency dynamic load changes. Ceramic
capacitors will also reduce any high frequency noise at the
load.
It is equally important to use low resistance and low
inductance PCB layouts and cabling.
External decoupling capacitors will become part of the
control loop of the DC/DC converter and may affect the
stability margins. As a “rule of thumb”, 100 μF/A of output
current can be added without any additional analysis. The
ESR of the capacitors is a very important parameter. Power
Modules guarantee stable operation with a verified ESR value
of >10 mΩ across the output connections.
For further information please contact your local Ericsson
Power Modules representative.
Output Voltage Adjust (Vadj)
The product has an Output Voltage Adjust pin (Vadj). This pin
can be used to adjust the output voltage above or below
Output voltage initial setting.
When increasing the output voltage, the voltage at the output
pins (including any remote sense compensation ) must be
kept below the threshold of the over voltage protection, (OVP)
to prevent the converter from shutting down. At increased
output voltages the maximum power rating of the converter
remains the same, and the max output current must be
decreased correspondingly.
To increase the voltage the resistor should be connected
between the Vadj pin and +Sense pin. The resistor value of the
Output voltage adjust function is according to information
given under the Output section for the respective product.
To decrease the output voltage, the resistor should be
connected between the Vadj pin and —Sense pin.
E
PKY 4000 PI series
DC/DC converters, Input 36-75 V, Output up to 25 A/700 W
EN/LZT 146 380 R1E September 2007
Ericsson Power Modules AB
Technical Specication
12
相關PDF資料 |
PDF描述 |
|---|---|
| PKY4716PIM | 1-OUTPUT 700 W DC-DC REG PWR SUPPLY MODULE |
| PL-RCP-02-S53-11 | FIBER OPTIC RECEIVER, 830-860nm, 2700Mbps |
| PLL2128X | PLL FREQUENCY SYNTHESIZER, 40 MHz |
| PLRXPL-SC-S43-22-N | FIBER OPTIC TRANSCEIVER, 840-860nm, 10520Mbps(Tx), 10520Mbps(Rx), SURFACE MOUNT, LC CONNECTOR |
| PLRXPL-VC-S43-21-N | FIBER OPTIC TRANSCEIVER, 840-860nm, 10312.5Mbps(Tx), 10312.5Mbps(Rx), LC CONNECTOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PKY4617PI | 功能描述:DC/DC轉換器 700W 28V 28A 36-75Vin RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PKY4716PI | 制造商:Ericsson 功能描述:PKY SERIES FULL BRICK - Trays |
| PKY4716PIM | 功能描述:DC/DC轉換器 28Vdc 28A Isolated Input 36-75V 700W RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PKZ 0001 | 制造商:Ericsson 功能描述: |
| PKZ0101 | 制造商:Ericsson 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。