- 您現在的位置：買賣IC網 > PDF目錄98054 > PKJ4719PIT (ERICSSON POWER MODULES AB) 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PKJ4719PIT |
| 廠商： | ERICSSON POWER MODULES AB |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT, HALF BRICK PACKAGE-9 |
| 文件頁數： | 28/39頁 |
| 文件大小： | 1007K |
| 代理商： | PKJ4719PIT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁
Limited Internal
PRODUCT SPECIFICATION
4 (6)
Prepared (also subject responsible if other)
No.
SEC/D EPHILIP
3/1301-BMR630
Approved
Checked
Date
Rev
Reference
SEC/D EPHILIP
(MICJOHN)
2006-1-27
A
Operating information, cont.
Input And Output Impedance
Parallel Operation
Two converters may be paralleled for redundancy if the total
power is equal or less than PO max. It is not recommended to
parallel the converters without using external current sharing
circuits.
Over Temperature Protection (OTP)
The impedance of both the input source and the load will
interact with the impedance of the DC/DC converter. It is
important that the input source has low characteristic
impedance. The converters are designed for stable operation
without external capacitors connected to the input or output.
The performance in some applications can be enhanced by
addition of external capacitance as described under External
Decoupling Capacitors. If the input voltage source contains
significant inductance, the addition of a 100 F capacitor
across the input of the converter will ensure stable operation.
The capacitor is not required when powering the DC/DC
converter from an input source with an inductance below
10 H.
External Decoupling Capacitors
The converters are protected from thermal overload by an
internal over temperature shutdown circuit. When the
baseplate or case temperature exceeds 110°C the converter
will shut down immediately (latching). The converter can be
restarted by cycling the input voltage or using the remote
control function.
Over Voltage Protection (OVP)
The converters have output over voltage protection that will
shut down the converter in over voltage conditions. The
converter can be restarted by cycling the input voltage or
using the remote control function.
Over Current Protection (OCP)
When powering loads with significant dynamic current
requirements, the voltage regulation at the point of load can
be improved by addition of decoupling capacitors at the load.
The most effective technique is to locate low ESR ceramic
and electrolytic capacitors as close to the load as possible,
using several parallel capacitors to lower the effective ESR.
The ceramic capacitors will handle high-frequency dynamic
load changes while the electrolytic capacitors are used to
handle low frequency dynamic load changes. Ceramic
capacitors will also reduce any high frequency noise at the
load.
It is equally important to use low resistance and low
inductance PCB layouts and cabling.
External decoupling capacitors will become part of the control
loop of the DC/DC converter and may affect the stability
margins. As a “rule of thumb”, 100 F/A of output current can
be added without any additional analysis.
The recommended absolute maximum value of output
capacitance is 10 000 F. For further information please
contact your local Ericsson Power Modules representative.
The converters include current limiting circuitry for protection
at continuous overload.
The output voltage will decrease towards zero for output
currents in excess of max output current (max IO). The
converter will resume normal operation after removal of the
overload. The load distribution should be designed for the
maximum output short circuit current specified.
E
PKJ 4000 PI series
DC/DC converters, Input 36-75 V, Output 30A/150W
EN/LZT 146 309 R1B February 2006
Ericsson Power Modules AB
Technical Specication
34
相關PDF資料 |
PDF描述 |
|---|---|
| PKJ4113PIT | 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE |
| PKL4110APITM | 1-OUTPUT 198 W DC-DC REG PWR SUPPLY MODULE |
| PKL4118PITM | 1-OUTPUT 108 W DC-DC REG PWR SUPPLY MODULE |
| PKM4110CPIPNBMLA | 1-OUTPUT 204 W DC-DC REG PWR SUPPLY MODULE |
| PKM4110DPINB | 1-OUTPUT 116 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PKJ4810EPI | 功能描述:DC/DC轉換器 3.3 Vdc 25A Iso Input 48V 82.5W RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PKJ4910PI | 制造商:Ericsson 功能描述:DC/DC PS SGL-OUT 3.3V 30A 100W 9PIN - Bulk |
| PKJ4910PIP | 制造商:Ericsson 功能描述:DC/DC PS SGL-OUT 3.3V 30A 99W - Bulk 制造商:ERICSSON 功能描述: |
| PKJ4910PIT | 功能描述:DC/DC轉換器 3.3 Vdc 30A Iso Input 36-75V 99W RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PKJ50B1/4 | 功能描述:旋鈕和轉盤 STRGHT 0.52" W/SPIN SWITCH KNOB RoHS:否 制造商:Davies Molding 材料:Phenolic 設計:Set Screw 軸尺寸:0.25 in 直徑:3/4 in 顏色:Black 指示器型式:Line |
發布緊急采購，3分鐘左右您將得到回復。