- 您現在的位置：買賣IC網 > PDF目錄98053 > PKD4218LESPBI (ERICSSON POWER MODULES AB) 1-OUTPUT 24 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PKD4218LESPBI |
| 廠商： | ERICSSON POWER MODULES AB |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 24 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | SMD-24 |
| 文件頁數： | 8/24頁 |
| 文件大?。?/td> | 811K |
| 代理商： | PKD4218LESPBI |
Ericsson Internal
PRODUCT SPECIFICATION
3 (6)
Prepared (also subject responsible if other)
No.
ESKEVIN
3/1301-BMR628 Uen
Approved
Checked
Date
Rev
Reference
SEC/D (Julia You)
EYINGJI
2008-7-9
B
Operating information continued
Parallel Operation
Two converters may be paralleled for redundancy if the total
power is equal or less than PO max. It is not recommended to
parallel the converters without using external current sharing
circuits.
{See Design Note 006 for detailed information.}
Remote Sense
The DC/DC converters have remote sense that can be used
to compensate for voltage drops between the output and the
point of load. The sense traces should be located close to the
PCB ground layer to reduce noise susceptibility. The remote
sense circuitry will compensate for up to 10% voltage drop
between output pins and the point of load.
If the remote sense is not needed +Sense should be
connected to +Out and -Sense should be connected to -Out.
Over Temperature Protection (OTP)
The converters are protected from thermal overload by an
internal over temperature shutdown circuit.
When Tref as defined in thermal consideration section
exceeds 180°C the converter will shut down. The DC/DC
converter will make continuous attempts to start up (non-
latching mode) and resume normal operation automatically
when the temperature has dropped >30°C below the
temperature threshold.
Over Voltage Protection (OVP)
In the event of an overvoltage condition due to malfunction in
the voltage monotoring circuits, the converter’s PWM
controller will automatically dictate minimum duty-cycle thus
reducing the output voltage to a minimum.
Over Current Protection (OCP)
The converters include current limiting circuitry for protection
at continuous overload.
The output voltage will decrease towards zero for output
currents in excess of max output current (max IO). The
converter will resume normal operation after removal of the
overload. The load distribution should be designed for the
maximum output short circuit current specified.
E
PKD 4000E SI series
DC/DC converters, Input 36-75 V, Output up to 20 A/50 W
EN/LZT 146 375 R2B July 2008
Ericsson Power Modules AB
16
相關PDF資料 |
PDF描述 |
|---|---|
| PKD4218HESI | 1-OUTPUT 21 W DC-DC REG PWR SUPPLY MODULE |
| PKG2625PI | 2-OUTPUT 60 W DC-DC REG PWR SUPPLY MODULE |
| PKG2611PI | 1-OUTPUT 60 W DC-DC REG PWR SUPPLY MODULE |
| PKG2410PI | 1-OUTPUT 46 W DC-DC REG PWR SUPPLY MODULE |
| PKG2623PI | 2-OUTPUT 60 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PKD4218SI | 制造商:Ericsson 功能描述:DC/DC PS SGL-OUT 1.8V 14A 25.2W - Bulk |
| PKD4218SIOA | 制造商:Ericsson 功能描述:DC/DC PS SGL-OUT 1.5V 14A 21W - Bulk |
| PKD4311SI | 制造商:Ericsson 功能描述:DC/DC PS SGL-OUT 5V 6A 30W - Bulk |
| PKD4319SI | 制造商:Ericsson 功能描述:DC/DC PS SGL-OUT 2.5V 12A 30W - Bulk |
| PKD4510ESI | 功能描述:DC/DC轉換器 3.3 Vdc 15A Iso Input 36-75V 50W RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。