- 您現在的位置：買賣IC網 > PDF目錄69045 > PKB4207LBPIPMLB/B (ERICSSON POWER MODULES AB) 1-OUTPUT 264 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PKB4207LBPIPMLB/B |
| 廠商： | ERICSSON POWER MODULES AB |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 264 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT PACKAGE-5 |
| 文件頁數： | 7/23頁 |
| 文件大小： | 2349K |
| 代理商： | PKB4207LBPIPMLB/B |
Ericsson Internal
PRODUCT SPECIFICATION
2 (5)
Prepared (also subject responsible if other)
No.
MICMALE
3/1301-BMR 658 Uen
Approved
Checked
Date
Rev
Reference
SEC/D Betty Wu
(EZHEWNG) 2009-12-16
PB3
Operating information
Input Voltage
The input voltage range 36 to 75 Vdc meets the requirements
of the European Telecom Standard ETS 300 132-2 for normal
input voltage range in –48 and –60 Vdc systems,
-40.5 to -57.0 V and –50.0 to -72 V respectively.
At input voltages exceeding 75 V, the power loss will be higher
than at normal input voltage and Tref must be limited to
absolute max 125 °C. The absolute maximum continuous
input voltage is 80 Vdc.
Turn-off Input Voltage
The DC/DC converters monitor the input voltage and will turn
on and turn off at predetermined levels.
The minimum hysteresis between on and off input
voltage is 1.0 V.
Remote Control (RC)
The products are fitted with a
remote control function referenced
to the primary negative input
connection (- In), with positive logic
option available. The RC function
allows the product to be turned
on/off by an external device like a
semiconductor or mechanical
switch. The RC pin has an internal
pull up resistor to + In.
The maximum required sink current is less than 1 mA. When
the RC pin is left open, the voltage generated on the RC pin is
5-10 V. The second option is “positive logic” remote control,
which can be ordered by adding the suffix “P” to the end of the
part number. The DC/DC converter will turn on when the input
voltage is applied with the RC pin open. Turn off is achieved
by connecting the RC pin to the - In. To ensure safe turn off
the voltage difference between RC pin and the - In pin shall be
less than 1 V. The DC/DC converter will restart automatically
when this connection is opened.
Input and Output Impedance
The impedance of both the input source and the load will
interact with the impedance of the DC/DC converter. It is
important that the input source has low characteristic
impedance. Minimum recommended external input
capacitance is 220 F. The performance in some applications
can be enhanced by addition of external capacitance as
described under External Decoupling Capacitors.
External Decoupling Capacitors
When powering loads with significant dynamic current
requirements, the voltage regulation at the point of load can
be improved by addition of decoupling capacitors at the load.
The most effective technique is to locate low ESR ceramic and
electrolytic capacitors as close to the load as possible, using
several parallel capacitors to lower the effective ESR. The
ceramic capacitors will handle high-frequency dynamic load
changes while the electrolytic capacitors are used to handle
low frequency dynamic load changes. Ceramic capacitors will
also reduce any high frequency noise at the load.
It is equally important to use low resistance and low
inductance PCB layouts and cabling.
The recommended absolute maximum value of output
capacitance is 2 000 μF. The user should be aware, however,
that large values of capacitance will affect the ramp-up time of
the DC/DC converter output voltage during
start-up.
Parallel Operation
The converters can be paralleled for redundancy if external o-
ring diodes are used in series with the outputs.
Over Temperature Protection (OTP)
The DC/DC converters are protected from thermal overload by
an internal over temperature shutdown circuit.
When Tref as defined in thermal consideration section
exceeds 125°C the DC/DC converter will shut down. The
DC/DC converter will make continuous attempts to start up
(non-latching mode) and resume normal operation
automatically when the temperature has dropped below the
temperature threshold.
Over Voltage Protection (OVP)
The DC/DC converters have an output over voltage protection
that normally will clamp the output voltage to the OVP
threshold level. If the output voltage should increase to the
OVP threshold level very fast then the DC/DC converter can
shut down and make attempts to start up (non-latching mode).
After removal of the over voltage condition the DC/DC
converter will resume to normal operation automatically.
Over Current Protection (OCP)
The DC/DC converters include current limiting circuitry for
protection at continuous overload.
The output voltage will decrease towards zero for output
currents in excess of max output current (max IO). The DC/DC
converter will resume normal operation after removal of the
overload. The load distribution should be designed for the
maximum output short circuit current specified.
E
PKB 4000B series
Intermediate Bus Converters
Input 36-75 V, Output up to 40 A / 252 W
EN/LZT 146 384 R3C January 2010
Ericsson AB
Technical Specication
15
相關PDF資料 |
PDF描述 |
|---|---|
| PKB4201BPIPHSMLB/B | 1-OUTPUT 204 W DC-DC REG PWR SUPPLY MODULE |
| PKB4201BPIHSMLA/B | 1-OUTPUT 204 W DC-DC REG PWR SUPPLY MODULE |
| PKB4204BPIM/B | 1-OUTPUT 243 W DC-DC REG PWR SUPPLY MODULE |
| PKB4204BSIHSMLB/B | 1-OUTPUT 243 W DC-DC REG PWR SUPPLY MODULE |
| PKB4207LBPIPHSMLB/B | 1-OUTPUT 264 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PKB4217MPI | 功能描述:DC/DC轉換器 240W 11.4V 21A 38-75Vin RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PKB42SW-2800 | 功能描述:音頻指示器及警報器 2.8kHz RoHS:否 制造商:PUI Audio 產品:Indicators 聲壓級:85 dB 音調:Continuous 頻率:2300 Hz +/- 300 Hz 電壓額定值:5 VDC 電流額定值:30 mA 端接類型: 直徑:12 mm 安裝:Through Hole |
| PKB42SWH2800 | 制造商:Murata Manufacturing Co Ltd 功能描述:Audio Buzzer Piezo 12mA Wire Lead 3VDC 2300Hz to 3300Hz Flange Mount |
| PKB42SWH-2800 | 功能描述:音頻指示器及警報器 85DB 2.80KHZ 42.0MM RoHS:否 制造商:PUI Audio 產品:Indicators 聲壓級:85 dB 音調:Continuous 頻率:2300 Hz +/- 300 Hz 電壓額定值:5 VDC 電流額定值:30 mA 端接類型: 直徑:12 mm 安裝:Through Hole |
| PKB4302NGPI | 功能描述:DC/DC轉換器 300W 38-55Vn/9.6Vout 1/8-BRICK RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。