- 您現在的位置：買賣IC網 > PDF目錄11397 > PIC18F87J60T-I/PT (Microchip Technology)IC PIC MCU FLASH 64KX16 80TQFP PDF資料下載
參數資料
| 型號： | PIC18F87J60T-I/PT |
| 廠商： | Microchip Technology |
| 文件頁數： | 4/8頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PIC MCU FLASH 64KX16 80TQFP |
| 產品培訓模塊： | Asynchronous Stimulus PIC18 J Series MCU Overview |
| 標準包裝： | 1,200 |
| 系列： | PIC® 18F |
| 核心處理器： | PIC |
| 芯體尺寸： | 8-位 |
| 速度： | 41.667MHz |
| 連通性： | 以太網，I²C，SPI，UART/USART |
| 外圍設備： | 欠壓檢測/復位，POR，PWM，WDT |
| 輸入/輸出數： | 55 |
| 程序存儲器容量： | 128KB（64K x 16） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 3808 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2 V ~ 3.6 V |
| 數據轉換器： | A/D 15x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 80-TQFP |
| 包裝： | 帶卷 (TR) |
| 配用： | AC162064-ND - HEADER INTFC MPLABICD2 64/80/100 AC164323-ND - MODULE SKT FOR 100TQFP |
PIC18F97J60 FAMILY
DS80292D-page 4
2008 Microchip Technology Inc.
7.
Module: Ethernet (TX)
When configured for half duplex and a transmit
operation encounters unusual collision timing,
there is a small chance that the Ethernet transmit
engine will internally deadlock. The PHY will stop
transmitting the packet and normal RX operations
will
continue.
However,
the
TXRTS
bit
(ECON1<3>) will stay set indefinitely. The TXIF
(EIR<3>) and TXERIF (EIR<1>) bits will not
become set.
This deadlock condition applies only to half-duplex
operation and is most readily observable when the
network has a duplex mismatch (i.e., PIC18F97J60
family device is configured for half duplex and the
remote node is configured for full duplex). In most
cases, high network utilization is needed to observe
the issue.
Work around
To prevent most transmit deadlock conditions,
issue a TX Logic Reset prior to transmitting each
packet:
1. Set TXRST (ECON1<7>)
2. Clear TXRST
3. Wait 1.6
μs or longer
4. Set TXRTS to start the transmission.
Issuing a TX Logic Reset may cause the Ethernet
transmit error interrupt to occur and the associated
TXERIF bit to become set, which can be ignored.
To detect and recover from any possible deadlock
conditions, applications should implement a timer to
poll the TXRTS bit. If the Ethernet hardware enters
the deadlock state and fails to clear this bit by the
time the timer expires, software should manually
clear the TXRTS bit, issue a TX Logic Reset and
then set the TXRTS bit to retry transmission. The
timer should be cleared and restarted whenever the
application sets TXRTS. The timer expiration time
should be chosen to allow adequate time for
ordinary
packets
to
finish
transmitting,
after
accounting for possible delays due to the medium
being occupied by other nodes. For example, a
time-out value of 3 ms is suitable since it will allow a
maximum length 1518-byte packet to be transmit-
ted at 10Base-T speeds while giving reasonable
margin to account for potential collisions.
Date Codes that pertain to this issue:
All engineering and production devices.
8.
Module: Ethernet (DMA)
When the DMA is configured to compute an IP
checksum, there is a small chance that an incom-
ing packet receive event will cause the DMA to
internally deadlock. In these cases, the DMAST bit
(ECON1<5>) stays set indefinitely, and the DMA
done interrupt never occurs.
Work around
Perform checksum calculations in software. Use
the DMA only for copy operations.
Date Codes that pertain to this issue:
All engineering and production devices.
9.
Module: I/O (PORTJ)
The weak internal pull-up resistors on pins RJ4
and RJ5 cannot be enabled on the PIC18F86J60,
PIC18F86J65 and PIC18F87J60 devices. Setting
the RJPU bit (PORTA<7>) has no effect on the I/O
pin state.
Work around
Install external pull-up resistors on RJ4 and RJ5.
Alternatively, use any of the PORTB, PORTD or
PORTE pins which all have weak internal pull ups.
Date Codes that pertain to this issue:
All engineering and production devices.
Note:
This issue is only applicable to the
80-pin device.
相關PDF資料 |
PDF描述 |
|---|---|
| PIC24FJ128GA106-E/PT | IC PIC MCU FLASH 128KB 64-TQFP |
| DG411HSDY-T1-E3 | IC SWITCH QUAD SPST 16-SOIC |
| PIC16C72AT-20I/SS | IC MCU OTP 2KX14 A/D PWM 28SSOP |
| DSPIC33FJ16GS504T-I/ML | IC DSPIC MCU/DSP 16K 44-QFN |
| PIC16C621T-04I/SO | IC MCU OTP 1KX14 COMP 18SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PIC18F87J72-I/PT | 功能描述:8位微控制器 -MCU Energy Meter 128KB LCD, CTMU, RTCC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC18F87J72T-I/PT | 功能描述:8位微控制器 -MCU Energy Meter 128KB LCD, CTMU, RTCC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC18F87J90-I/PT | 功能描述:8位微控制器 -MCU Segmnt LCD 128KBFlsh 4KBRAM 12MIPS RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC18F87J90T-I/PT | 功能描述:8位微控制器 -MCU Segmnt LCD 128KBFlsh 4KBRAM 12MIPS RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC18F87J93-I/PT | 功能描述:8位微控制器 -MCU 80pn,SEG LCD,4KB RAM 128KB Flsh,12bit ADC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。