參數資料
型號: PIC18F6723T-I/PT
廠商: Microchip Technology
文件頁數: 32/60頁
文件大?。?/td> 0K
描述: IC PIC MCU FLASH 64KX16 64TQFP
產品培訓模塊: Asynchronous Stimulus
標準包裝: 1,200
系列: PIC® 18F
核心處理器: PIC
芯體尺寸: 8-位
速度: 40MHz
連通性: I²C,SPI,UART/USART
外圍設備: 欠壓檢測/復位,HLVD,POR,PWM,WDT
輸入/輸出數: 54
程序存儲器容量: 128KB(64K x 16)
程序存儲器類型: 閃存
EEPROM 大小: 1K x 8
RAM 容量: 3.8K x 8
電壓 - 電源 (Vcc/Vdd): 4.2 V ~ 5.5 V
數據轉換器: A/D 12x12b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 64-TQFP
包裝: 帶卷 (TR)
配用: MA180020-ND - MODULE PLUG-IN HPC EXPL 18F87J11
其它名稱: PIC18F6723T-I/PTTR
PIC18F8723 FAMILY
DS39894B-page 38
2009 Microchip Technology Inc.
2.4
Operation in Power-Managed
Modes
The selection of the automatic acquisition time and A/D
conversion clock is determined in part by the clock
source and frequency while in a power-managed mode.
If the A/D is expected to operate while the device is in
a power-managed mode, the ADCS2:ADCS0 bits in
ADCON2 should be updated in accordance with the
clock source to be used. The ACQT2:ACQT0 bits do
not need to be adjusted as the ADCS2:ADCS0 bits
adjust the TAD time for the new clock speed. After enter-
ing the mode, an A/D acquisition or conversion may be
started. Once started, the device should continue to be
clocked by the same clock source until the conversion
has been completed.
If desired, the device may be placed into the
corresponding Idle mode during the conversion. If the
device clock frequency is less than 1 MHz, the A/D RC
clock source should be selected.
Operation in Sleep mode requires the A/D FRC clock to
be selected. If the ACQT2:ACQT0 bits are set to ‘000’
and a conversion is started, the conversion will be
delayed one instruction cycle to allow execution of the
SLEEP instruction and entry to Sleep mode. The IDLEN
bit (OSCCON<7>) must have already been cleared
prior to starting the conversion.
2.5
Configuring Analog Port Pins
The ADCON1, TRISA, TRISF and TRISH registers all
configure the A/D port pins. The port pins needed as
analog inputs must have their corresponding TRIS bits
set (input). If the TRIS bit is cleared (output), the digital
output level (VOH or VOL) will be converted.
The A/D operation is independent of the state of the
CHS3:CHS0 bits and the TRIS bits.
Note 1: When reading the PORT register, all pins
configured as analog input channels will
read as cleared (a low level). Analog con-
version on pins configured as digital pins
can be performed. The voltage on the pin
will be accurately converted.
2: Analog levels on any pin defined as a dig-
ital input may cause the digital input buffer
to consume current out of the device’s
specification limits.
相關PDF資料
PDF描述
PIC16CE624/JW IC MCU EPROM1KX14 EE COMP 18CDIP
PIC18F6585-E/L IC PIC MCU FLASH 24KX16 68PLCC
DSPIC30F6014AT-20E/PT IC DSPIC MCU/DSP 144K 80TQFP
DG221BDY-E3 IC SWITCH QUAD SPST/CMOS 16SOIC
DG271BDY-T1-E3 IC SWITCH QUAD SPST 16SOIC
相關代理商/技術參數
參數描述
PIC18F67J10 DEVELOPMENT BOARD KIT 制造商:Custom Computer Services (CCS) 功能描述:BOARD DEV FOR PIC18F67J10
PIC18F67J10 DEVELOPMENT KIT 功能描述:KIT DEV EMBEDDED C RoHS:否 類別:編程器,開發系統 >> 通用嵌入式開發板和套件(MCU、DSP、FPGA、CPLD等) 系列:- 標準包裝:1 系列:PICDEM™ 類型:MCU 適用于相關產品:PIC10F206,PIC16F690,PIC16F819 所含物品:板,線纜,元件,CD,PICkit 編程器 產品目錄頁面:659 (CN2011-ZH PDF)
PIC18F67J10-I/PT 功能描述:8位微控制器 -MCU 128 KB FL 4 KB RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC18F67J10T-I/PT 功能描述:8位微控制器 -MCU 128 KB FL 4 KB RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC18F67J11-I/PT 功能描述:8位微控制器 -MCU 128KB FL 3936b RAM 10 MIPS 51 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT