- 您現在的位置：買賣IC網 > PDF目錄11270 > PIC18F6722-E/PT (Microchip Technology)IC PIC MCU FLASH 64KX16 64TQFP PDF資料下載
參數資料
| 型號： | PIC18F6722-E/PT |
| 廠商： | Microchip Technology |
| 文件頁數： | 12/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PIC MCU FLASH 64KX16 64TQFP |
| 產品培訓模塊： | Asynchronous Stimulus |
| 標準包裝： | 160 |
| 系列： | PIC® 18F |
| 核心處理器： | PIC |
| 芯體尺寸： | 8-位 |
| 速度： | 25MHz |
| 連通性： | I²C，SPI，UART/USART |
| 外圍設備： | 欠壓檢測/復位，HLVD，POR，PWM，WDT |
| 輸入/輸出數： | 54 |
| 程序存儲器容量： | 128KB（64K x 16） |
| 程序存儲器類型： | 閃存 |
| EEPROM 大?。?/td> | 1K x 8 |
| RAM 容量： | 3.8K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 4.2 V ~ 5.5 V |
| 數據轉換器： | A/D 12x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 125°C |
| 封裝/外殼： | 64-TQFP |
| 包裝： | 托盤 |
| 配用： | MA180020-ND - MODULE PLUG-IN HPC EXPL 18F87J11 |
2006 Microchip Technology Inc.
DS80221C-page 5
PIC18F6627/6722/8627/8722
8.
Module: BOD
The BOD module may reset below the minimum
operating voltage of the device when configured
for BORV1:BORV0 = 11. The updated Reset
voltage specifications are shown in bold in
Work around
Use the next higher BOD voltage setting to ensure
a low VDD is detected above 2.0V.
Date Codes that pertain to this issue:
All engineering and production devices.
TABLE 2:
BROWN-OUT RESET VOLTAGE
9.
Module: EUSART
When performing back-to-back transmission in 9-bit
mode (TX9D bit in the TXSTAx register is set), the
second byte may be corrupted if it is written into
TXREGx immediately after the TMRT bit is set.
Work around
Execute a software delay, at least one-half the
transmission’s bit time, after TMRT is set and prior
to writing subsequent bytes into TXREGx.
Date Codes that pertain to this issue:
All engineering and production devices.
10. Module: EUSART
The EUSART auto-baud feature may periodically
measure the incoming baud rate incorrectly. The
rate of incorrect baud rate measurements will
depend on the frequency of the incoming
synchronization
byte
and
the
system
clock
frequency.
Work around
None.
11. Module: EUSART
In Synchronous mode (SYNC = 1) with clock
polarity high (SCKP = 1), the EUSART transmits a
shorter than expected clock on the CKx pin for the
last bit transmitted.
Work around
None.
12. Module: EUSART
In Synchronous mode, EUSART baud rates using
SPBRGx values of ‘0’ and ‘1’ may not function
correctly.
Work around
Use another baud rate configuration to generate
the desired baud rate.
13. Module: EUSART
After the last received byte has been read from the
EUSART receive buffer, RCREGx, the value is no
longer valid for subsequent read operations. The
RCREGx register should only be read once for
each byte received.
Work around
After each byte is received from the EUSART, store
the byte into a user variable. To determine when a
byte is available to read from RCREGx, poll the
RCIDL (BAUDCONx<6>) bit for a low-to-high
transition or use the EUSART receive interrupt,
RCxIF (PIRx<5>).
14. Module: EUSART
In 9-Bit Asynchronous Full-Duplex Receive mode,
received data may be corrupted if the TX9D bit
(TXSTAx<0>) is not modified immediately after
RCIDL (BAUDCONx<6>) is set.
Work around
Only write to TX9D when a reception is not in
progress (RCIDL = 1). No interrupt is associated
with RCIDL, therefore, it must be polled in software
to determine when TX9D can be updated.
15. Module: ECCP
PIC18F6XXX
device’s
Configuration
Word,
CONFIG3L, is not unimplemented and will switch
the ECCP2 output pin similar to the PIC18F8XXX
devices if the Processor mode does not select
Microcontroller mode.
Work around
In MPLAB IDE, program the PIC18F6XXX device
as its PIC18F8XXX equivalent and assign the
Processor mode bits (PM<1:0>) to ‘11’ for
Microcontroller mode.
D005 VBOR Brown-out Reset Voltage
PIC18LF6627/6722/8627/8722
BORV1:BORV0 = 11 N/A 2.05 N/A V
相關PDF資料 |
PDF描述 |
|---|---|
| PIC18LF4553-I/ML | IC PIC MCU FLASH 16KX16 44QFN |
| VE-2VL-IX-F4 | CONVERTER MOD DC/DC 28V 75W |
| DSPIC33FJ64MC710A-I/PT | IC DSPIC MCU/DSP 64K 100-TQFP |
| VE-2VL-IX-F3 | CONVERTER MOD DC/DC 28V 75W |
| PIC18F458-E/L | IC MCU FLASH 16KX16 W/CAN 44PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PIC18F6722-I/PT | 功能描述:8位微控制器 -MCU FLASH MICROCONTROLLER RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC18F6722-I/PTC01 | 制造商:Microchip Technology Inc 功能描述:8BIT PIC18 RISC 128KB FLASH 40 - Trays |
| PIC18F6722T-E/PT | 功能描述:8位微控制器 -MCU 128 KB FL 3936 RAM 25 MHz RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC18F6722T-I/PT | 功能描述:8位微控制器 -MCU 128 KB FL 4K RAM 70 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC18F6723-E/PT | 功能描述:8位微控制器 -MCU 128KB Flash 4KB RAM 1024 DataEE 12B ADC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發(fā)布緊急采購，3分鐘左右您將得到回復。