參數資料
型號: PIC16C433T-E/SO
廠商: Microchip Technology
文件頁數: 47/126頁
文件大?。?/td> 0K
描述: IC MCU CMOS 8BIT 10MHZ 2K 18SOIC
標準包裝: 1,100
系列: PIC® 16C
核心處理器: PIC
芯體尺寸: 8-位
速度: 10MHz
連通性: LIN(本地互連網絡)
外圍設備: POR,WDT
輸入/輸出數: 5
程序存儲器容量: 3.5KB(2K x 14)
程序存儲器類型: OTP
RAM 容量: 128 x 8
電壓 - 電源 (Vcc/Vdd): 4.5 V ~ 5.5 V
數據轉換器: A/D 4x8b
振蕩器型: 內部
工作溫度: -40°C ~ 125°C
封裝/外殼: 18-SOIC(0.295",7.50mm 寬)
包裝: 帶卷 (TR)
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁當前第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁
2002 Microchip Technology Inc.
Preliminary
DS41139B-page 25
PIC16C433
5.0
I/O PORT
As with any other register, the I/O register can be writ-
ten and read under program control. However, read
instructions (i.e., MOVF GPIO,W) always read the I/O
pins independent of the pin’s Input/Output modes. On
RESET, all I/O ports are defined as input (inputs are at
hi-impedance), since the I/O control registers are all
set.
5.1
GPIO
GPIO is an 8-bit I/O register. Only the low order 6 bits
are used (GP<5:0>). Bits 6 and 7 (LINTX and LINRX,
respectively) are used by the LIN bus transceiver
peripheral. Please note that GP3 is an input only pin.
The configuration word can set several I/O’s to alter-
nate functions. When acting as alternate functions, the
pins will read as ‘0’ during port read. Pins GP0, GP1
and GP3 can be configured with weak pull-ups and
also with interrupt-on-change. The interrupt-on-change
and weak pull-up functions are not pin selectable. If pin
4 (GP3), is configured as MCLR, a weak pull-up is
always on. Interrupt-on-change for this pin is not set
and GP3 will read as '0'. Interrupt-on-change is
enabled by setting bit GPIE, INTCON<3>. Note that
external oscillator use overrides the GPIO functions on
GP4 and GP5.
5.2
TRIS Register
This register controls the data direction for GPIO. A '1'
from a TRIS Register bit puts the corresponding output
driver in a Hi-impedance mode. A '0' puts the contents
of the output data latch on the selected pins, enabling
the output buffer. The exceptions are GP3, which is
input only and its TRIS bit will always read as '1', while
GP6 and GP7 TRIS bits will read as ’0’.
Upon RESET, the TRIS Register is all '1's, making all
pins inputs.
TRIS for pins GP4 and GP5 is forced to a ’1’, where
appropriate. Writes to TRIS <5:4> will have an effect in
EXTRC and INTRC oscillator modes only. When GP4
is configured as CLKOUT, changes to TRIS<4> will
have no effect.
5.3
I/O Interfacing
The equivalent circuit for an I/O port pin is shown in
Figure 5-1 through Figure 5-5. All port pins, except
GP3, which is input only, may be used for both input
and output operations. For input operations, these
ports are non-latching. Any input must be present until
read by an input instruction (i.e., MOVF GPIO,W). The
outputs are latched and remain unchanged until the
output latch is rewritten. To use a port pin as output, the
corresponding direction control bit in TRIS must be
cleared (= 0). For use as an input, the corresponding
TRIS bit must be set. Any I/O pin (except GP3) can be
programmed individually as input or output.
Port pins LINTX and LINRX are used for the LIN bus
transceiver. These port pins are not available externally
on the package. Users should avoid writing to pins GP6
(SDA) and GP7 (SCL), when not communicating with
the LIN bus transceiver.
Note:
A read of the ports reads the pins, not the
output data latches. That is, if an output
driver on a pin is enabled and driven high,
but the external system is holding it low, a
read of the port will indicate that the pin is
low.
Note:
On a Power-on Reset, GP0, GP1, GP2
and GP4 are configured as analog inputs
and read as '0'.
相關PDF資料
PDF描述
22-02-3103 CONN FFC/FPC VERTICAL 10POS .100
PIC16C432T-E/SS IC MCU CMOS 8BIT 20MHZ 2K 20SSOP
PIC16C432-I/P IC MCU CMOS 8-BIT 20MHZ 2K 20DIP
PIC16C432-E/P IC MCU CMOS 8-BIT 20MHZ 2K 20DIP
PIC18LF452T-I/L IC MCU FLASH 16KX16 A/D 44PLCC
相關代理商/技術參數
參數描述
PIC16C433T-I/SO 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 6 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC16C505/JW 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC16C505-04/P 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 4MHz PDIP14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC16C505-04/P 制造商:Microchip Technology Inc 功能描述:IC 8BIT CMOS MCU (TUBE 30) 16C505 制造商:Microchip Technology Inc 功能描述:IC 8BIT CMOS MCU 16C505 DIP14
PIC16C505-04/SL 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 4MHz SOIC14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT