- 您現在的位置：買賣IC網 > PDF目錄370001 > PI4S706TH Parallel Input, 12-Bit Rail-to-Rail Micropower DACs in SSOP; Package: PDIP; No of Pins: 24; Temperature Range: 0°C to +70°C PDF資料下載
參數資料
| 型號： | PI4S706TH |
| 英文描述： | Parallel Input, 12-Bit Rail-to-Rail Micropower DACs in SSOP; Package: PDIP; No of Pins: 24; Temperature Range: 0°C to +70°C |
| 中文描述： | 監控電路| 3.08V的復位高有效監 |
| 文件頁數： | 2/8頁 |
| 文件大?。?/td> | 398K |
| 代理商： | PI4S706TH |
2
PS8703 09/23/03
PI4S705, PI4S706x, PI4S707, PI4S708x, PI4S813L
μP Supervisor Circuts
Pin Name
Type
Description
Manual-Reset
: triggers a reset pulse when pulled below 0.8V, active low. It has an internal 250μA
pull-up current and can be driven from a TTL or CMOS logic line as well as shorted to ground with a
switch.
Power Supply
Ground Reference
for all signals
Power-Fail Voltage Monitor Input
: When PFI is less than 1.25V, PFO goes low. Connect PFI to GND
or Vcc when not used.
Power-Fail Output
: it gets low and sinks current when PFI is less than 1.25V; otherwise PFO stays
high.
Watchdog Input
: If WDI remains high or low for 1.6sec, the internal watchdog timer runs out and
WDO goes low. Floating WDI or connecting WDI to a high-impedance three-state buffer disables the
watchdog feature. The internal watchdog timer clears whenever reset is asserted, WDI is three-stated,
or WDI sees a rising or falling edge.
No Connect
Reset Output pulses
: low for 200ms when triggered, and stays low whenever Vcc is below the reset
threshold. It remains low for 200ms after V
CC
rises above the reset threshold or MR goes from low to
high. A watchdog timeout will not trigger RESET unless WDO is connected to MR.
Watchdog Output
: pulls low when the internal watchdog timer finishes its 1.6sec count and does not
go high again until the watchdog is cleared. WDO also goes low during low-line conditions. Whenever
Vcc is below the reset threshold, WDO stays low; however, unlike RESET, WDO does not have mini-
mum pulse width. As soon as V
CC
rises above the reset threshold, WDO goes high with no delay.
The inverse of RESET
: active high. Whenever RESET is high, RESET is low.
MR
Input
V
CC
GND
Power
Ground
PFI
Input
PFO
Output
WDI
Input
NC
RESET
Output
WDO
Output
RESET
Output
Pin Descriptiom
相關PDF資料 |
PDF描述 |
|---|---|
| PI4S707 | 12-Bit Rail-to-Rail Micropower DACs in SO-8; Package: SO; No of Pins: 8; Temperature Range: 0°C to +70°C |
| PI4S708 | Supervisory Circuits | 4.63V Reset Active Low/High Supervisor |
| PI4S708R | 12-Bit Rail-to-Rail Micropower DACs in SO-8; Package: SO; No of Pins: 8; Temperature Range: -40°C to +85°C |
| PI4S708S | Supervisory Circuits | 2.93V Reset Active Low Supervisor |
| PI4S708T | 12-Bit Rail-to-Rail Micropower DACs in SO-8; Package: SO; No of Pins: 8; Temperature Range: 0°C to +70°C |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PI4ULS3V08M | 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:1.2V to 3.6V Universal Bi-directional Level Shifter with Automatic Direction Control & Advanced Package Solution |
| PI4ULS3V08MZLE | 功能描述:轉換 - 電壓電平 8bit Auto Direction Sensing Volt Trans RoHS:否 制造商:Micrel 類型:CML/LVDS/LVPECL to LVCMOS/LVTTL 傳播延遲時間:1.9 ns 電源電流:14 mA 電源電壓-最大:3.6 V 電源電壓-最小:3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MLF-8 |
| PI4ULS3V08MZLEX | 功能描述:轉換 - 電壓電平 Universal Bi- directionaLevel RoHS:否 制造商:Micrel 類型:CML/LVDS/LVPECL to LVCMOS/LVTTL 傳播延遲時間:1.9 ns 電源電流:14 mA 電源電壓-最大:3.6 V 電源電壓-最小:3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MLF-8 |
| PI4ULS3V08ZFE | 功能描述:轉換 - 電壓電平 Universal Bi- directionaLevel RoHS:否 制造商:Micrel 類型:CML/LVDS/LVPECL to LVCMOS/LVTTL 傳播延遲時間:1.9 ns 電源電流:14 mA 電源電壓-最大:3.6 V 電源電壓-最小:3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MLF-8 |
| PI4ULS3V08ZFEX | 功能描述:轉換 - 電壓電平 Universal Bi- directionaLevel RoHS:否 制造商:Micrel 類型:CML/LVDS/LVPECL to LVCMOS/LVTTL 傳播延遲時間:1.9 ns 電源電流:14 mA 電源電壓-最大:3.6 V 電源電壓-最小:3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MLF-8 |
發布緊急采購，3分鐘左右您將得到回復。