參數資料
型號: PEF24902
英文描述: ISDN Line Interface
中文描述: ISDN線路接口
文件頁數: 36/73頁
文件大?。?/td> 1618K
代理商: PEF24902
PEB 2466
PEF 2466
Interface Description
Hardware Reference Manual
27
2001-02-20
5
Interface Description
The SICOFI
4-μC provides four interfaces:
Analog Interface,
PCM Interface,
Signaling Interface, and
Serial Microcontroller Interface.
A general description of these interface is given in the
Product Overview
, Chapter 4
.
Refer to the
Programmers Reference Manual
for information on the configuration and
operation of the four interfaces.
The subsequent chapters in this manual explain how to connect the SICOFI
4-μC to
subscriber line interface circuits (SLICs), microcontrollers, and PCM highways.
5.1
Analog Interface
The Analog Interface in combination with a Subscriber Line Interface Circuit (SLIC)
forms a configurable tip & ring (t/r) telephone line. The AC transmission characteristic of
the SICOFI
4-μC
SLIC combination can be controlled by programming the digital filter
structures inside the SICOFI
4-μC. The correct filter coefficients are determined by the
targeted AC transmission behavior (e.g. Telco specification) and by the transfer
functions of the SLIC.
The SICOFI
4-μC can be interfaced directly to electronic SLICs or transformer solutions.
The high driving capability of up to 300 Ohms eliminates the need for an external
amplifier that is normally used with transformer SLICs.
The peak amplitude of the analog inputs and outputs is at 2.223 V (overload point).
Out-of-band signals applied to the analog inputs are suppressed by the on-chip digital
hardware filters. The poles of these filters are fixed at 12 kHz and 16 kHz which
suppresses the echo signal from teletax pulses very efficiently: As long as the amplitude
of the teletax echo stays below the overload threshold of 2.223 Vp (1.57 Vrms), the voice
signal in the transmit path will not be disturbed. Thus, the on-chip hardware filters can
eliminate the need for external teletax filters.
5.1.1
Coupling Capacitors at the Analog Interface
A coupling capacitor >39 nF must be used on the
V
IN
-pins in the transmit direction. The
required value for the coupling capacitor on the
V
OUT
-pins depends on the input
resistance of the SLIC-circuitry (
R
Load
). It has to be chosen to fulfil the frequency
response requirement in the receive direction.
Figure 16
can be used to determine an
appropriate value for the coupling capacitor (
C
Ext1
).
相關PDF資料
PDF描述
PEF24902H ?Quad ISDN Echocancellation Circuit Analog Front End - 2B1Q/4B3T Code?
PEF24911 ISDN Line Interface
PEB3035-N Telecomm Interface, Other/Special/Misc
PEB3035-P Telecomm Interface, Other/Special/Misc
PEB3081 LTC3783 Evaluation Kit
相關代理商/技術參數
參數描述
PEF24902H 制造商:未知廠家 制造商全稱:未知廠家 功能描述:?Quad ISDN Echocancellation Circuit Analog Front End - 2B1Q/4B3T Code?
PEF24902HV2.1 制造商:Rochester Electronics LLC 功能描述:- Bulk
PEF24911 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ISDN Line Interface
PEF24911H 制造商:未知廠家 制造商全稱:未知廠家 功能描述:?Quad ISDN Echocancellation Circuit Digital Front End - 2B1Q Code?
PEF24911HV1.3 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Infineon Technologies AG 功能描述: