參數資料
型號： PDT006A0X43-SRZ
廠商： LINEAGE POWER LLC
元件分類： 電源模塊
英文描述： DC-DC REG PWR SUPPLY MODULE
封裝： ROHS COMPLIANT PACKAGE-9
文件頁數： 11/38頁
文件大?。?/td> 760K
代理商： PDT006A0X43-SRZ
Preliminary Data Sheet
June 13, 2011
6A Digital Pico DLynxTM: Non-isolated DC-DC Power Modules
3 – 14.4Vdc input; 0.45Vdc to 5.5Vdc output; 6A output current
LINEAGE POWER
19
Function
PU
CMD CPR
POL
CPA
Default Value
1
0
1
PU: Sets the default to either operate any time input
power is present or for the ON/OFF to be controlled by
the analog ON/OFF input and the PMBus OPERATION
command. This bit is used together with the CP, CMD
and ON bits to determine startup.
Bit Value
Action
0
Module powers up any time power is
present regardless of state of the analog
ON/OFF pin
1
Module does not power up until
commanded by the analog ON/OFF pin
and the OPERATION command as
programmed in bits [2:0] of the
ON_OFF_CONFIG register.
CMD: The CMD bit controls how the device responds to
the OPERATION command.
Bit Value
Action
0
Module ignores the ON bit in the
OPERATION command
1
Module responds to the ON bit in the
OPERATION command
CPR: Sets the response of the analog ON/OFF pin. This
bit is used together with the CMD, PU and ON bits to
determine startup.
Bit Value
Action
0
Module ignores the analog ON/OFF pin,
i.e. ON/OFF is only controlled through the
PMBUS via the OPERATION command
1
Module requires the analog ON/OFF pin
to be asserted to start the unit
PMBus Adjustable Soft Start Rise Time
The soft start rise time can be adjusted in the module via
PMBus. When setting this parameter, make sure that
the charging current for output capacitors can be
delivered by the module in addition to any load current
to avoid nuisance tripping of the overcurrent protection
circuitry during startup. The TON_RISE command sets
the rise time in ms, and allows choosing soft start times
between 600μs and 9ms, with possible values listed in
Table 5. Note that the exponent is fixed at -4 (decimal)
and the upper two bits of the mantissa are also fixed at
0.
Table 5
Rise Time
Exponent
Mantissa
600μs
11100
00000001010
900μs
11100
00000001110
1.2ms
11100
00000010011
1.8ms
11100
00000011101
2.7ms
11100
00000101011
4.2ms
11100
00001000011
6.0ms
11100
00001100000
9.0ms
11100
00010010000
Output Voltage Adjustment Using the PMBus
The VOUT_SCALE_LOOP parameter is important for a
number of PMBus commands related to output voltage
trimming, margining, over/under voltage protection and
the PGOOD thresholds. The output voltage of the
module is set as the combination of the voltage divider
formed by RTrim and a 20k upper divider resistor
inside the module, and the internal reference voltage of
the module. The reference voltage VREF is nominally set
at 600mV, and the output regulation voltage is then
given by
REF
OUT
V
RTrim
V
×
+
=
20000
Hence the module output voltage is dependent on the
value of RTrim which is connected external to the
module. The information on the output voltage divider
ratio is conveyed to the module through the
VOUT_SCALE_LOOP parameter which is calculated as
follows:
RTrim
LOOP
SCALE
VOUT
+
=
20000
_
The VOUT_SCALE_LOOP parameter is specified using
the “Linear” format and two bytes. The upper five bits
[7:3] of the high byte are used to set the exponent which
is fixed at –9 (decimal). The remaining three bits of the
high byte [2:0] and the eight bits of the lower byte are
used for the mantissa. The default value of the mantissa
is 00100000000 corresponding to 256 (decimal),
corresponding to a divider ratio of 0.5. The maximum
value of the mantissa is 512 corresponding to a divider
ratio of 1. Note that the resolution of the
VOUT_SCALE_LOOP command is 0.2%.
When PMBus commands are used to trim or margin the
output voltage, the value of VREF is what is changed
inside the module, which in turn changes the regulated
output voltage of the module.
The nominal output voltage of the module can be
adjusted with a minimum step size of 0.4% over a ±25%
range from nominal using the VOUT_TRIM command
over the PMBus.
相關PDF資料
PDF描述
PDT012A0X3-SRZ 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PDT012A0X3-SRDZ 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PE3236-54 PHASE LOCKED LOOP, PQCC44
PE3236-21 PHASE LOCKED LOOP, PQCC44
PE33361MLIAA-Z PHASE LOCKED LOOP, QCC48
相關代理商/技術參數
參數描述
PDT012A0X 制造商:LINEAGEPOWER 制造商全稱:LINEAGEPOWER 功能描述:12A Digital Pico DLynxTM: Non-Isolated DC-DC Power Modules
PDT012A0X3 制造商:LINEAGEPOWER 制造商全稱:LINEAGEPOWER 功能描述:12A Digital Pico DLynxTM: Non-Isolated DC-DC Power Modules
PDT012A0X3_1108 制造商:LINEAGEPOWER 制造商全稱:LINEAGEPOWER 功能描述:12A Analog Pico DLynxTM: Non-Isolated DC-DC Power Modules
PDT012A0X3_1109 制造商:LINEAGEPOWER 制造商全稱:LINEAGEPOWER 功能描述:12A Digital Pico DLynxTM: Non-Isolated DC-DC Power Modules
PDT012A0X3-AASRZ 制造商:GE Critical Power 功能描述:- Tape and Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*