
Power-over-Ethernet
PALS AC-DC Series Data Sheet
JUL 06, 2006 revised to SEP 19, 2006
Page 1 of 5
www.power-one.com
Features
RoHS lead free solder and lead solder exempted
products are available
Single-phase AC input
Up to 9 W/in3 power density
1U or 3U height configurations
Power Factor Correction (PFC) Meets EN61000-3-2
Current share with ORing diodes
Overtemperature, overload, and overvoltage
protection
Power supply status indicators
I2C protocol alarms, status, & control
Standby voltage - 12 VDC @ 500 mA with
ORing diode
Enable signal for each output
Model Selection
MODEL
TOTAL OUTPUT
OUTPUT
MAXIMUM OUTPUT
LINE
LOAD
RIPPLE & NOISE
INITIAL SETTING
POWER (WATTS)
VOLTAGE
CURRENT
REGULATION
REGULATION 1
mVp-p 2
ACCURACY
PALS400-2482
400
48V
8A
0.1%
0.2%
120
0.2%
12V
16A
0.1%
0.2%
120
0.2%
PALS600-2482
600
48V
9A
0.1%
0.2%
120
0.2%
12V
16A
0.1%
0.2%
120
0.2%
NOTES:
1 With Remote Sense connected.
2 Maximum peak-to-peak noise expressed as a percentage of output voltage, 20 MHz bandwidth.
Input Specifications
PARAMETER
CONDITIONS/DESCRIPTION
MIN
NOM
MAX
UNITS
Input Voltage - AC
Single-phase continuous input range.
85
264
VAC
Input Frequency
AC input.
47
63
Hz
Hold-up Time
After last AC line peak at full power.
At 115 VAC.
20
ms
Input Current
At full rated load.
At 85 VAC. PALS400:
6.5
Arms
At 85 VAC. PALS600:
10
Inrush Surge Current
Internally limited by thermistor.
Vin = 115VAC (one cycle). 25° C.
17
Apk
Power Factor
Per EN61000-3-2
0.98
W/VA
Operating Frequencies
Boost frequency
95
kHz
Forward converter frequency
125
The PALS Series consists of 400 and 600 watt ac-dc power supplies designed specifically for use in power-over-
ethernet applications. The supplies have dual outputs of 48 and 12 volts which provide LAN port and internal system
power. A 500 mA standby output facilitates I2C interface operations. The units are fully-enclosed, have 1500 VAC
(2250 VDC) output isolation, and comply to IEEE802.3AF.
The PALS Series provides excellent protection against input voltage transients. Supply outputs are fully floating,
meaning that users can use them for either positive or negative polarity needs.
Output voltage terminals and interface access is through a hot-swap connector at the rear of the supply. The AC input
fans, handle, and LED indicator lights are located on the front panel of the supply. Airflow is from the front through the
rear. Alarm, monitoring, and control signals are floating from the rear output and can be referenced.
The PALS Series meets international safety requirements and is CE Marked to the Low Voltage Directive.