![](http://datasheet.mmic.net.cn/180000/PALCE22V10H-10JC-5_datasheet_11342355/PALCE22V10H-10JC-5_14.png)
14
PALCE22V10Q-10 (Com’l)
ABSOLUTE MAXIMUM RATINGS
Storage Temperature . . . . . . . . . . . . . .-65°C to +150°C
Ambient Temperature with
Power Applied . . . . . . . . . . . . . . . . . .-55°C to +125°C
Supply Voltage with Respect
to Ground . . . . . . . . . . . . . . . . . . . . . -0.5 V to +7.0 V
DC Input Voltage . . . . . . . . . . . . -0.5 V to VCC + 1.0 V
DC Output or I/O Pin
Voltage . . . . . . . . . . . . . . . . . . . -0.5 V to VCC + 1.0 V
Static Discharge Voltage . . . . . . . . . . . . . . . . . 2001 V
Latchup Current (TA = 0°C to +75°C) . . . . . . . . 100 mA
Stresses above those listed under Absolute Maximum Ratings
may cause permanent device failure. Functionality at or above
these limits is not implied. Exposure to Absolute Maximum
Ratings for extended periods may affect device reliability.
Programming conditions may vary.
OPERATING RANGES
Commercial (C) Devices
Ambient Temperature (TA)
Operating in Free Air . . . . . . . . . . . . . . . 0°C to +75°C
Supply Voltage (VCC) with
Respect to Ground. . . . . . . . . . . . . +4.75 V to +5.25 V
Operating ranges dene those limits between which the func-
tionality of the device is guaranteed.
Notes:
1. These are absolute values with respect to the device ground, and all overshoots due to system and tester noise are included.
2. I/O pin leakage is the worst case of IIL and IOZL (or IIH and IOZH).
3. Not more than one output should be tested at a time, and the duration of the short-circuit test should not exceed one second.
VOUT = 0.5 V has been chosen to avoid test problems caused by tester ground degradation.
4. This parameter is guaranteed worst case under test condition. Refer to the ICC vs. frequency graph for typical ICC
characteristics.
DC CHARACTERISTICS OVER COMMERCIAL OPERATING RANGES
Parameter
Symbol
Parameter Description
Test Conditions
Min
Max
Unit
VOH
Output HIGH Voltage
IOH = -3.2 mA, VIN = VIH or VIL, VCC = Min
2.4
V
VOL
Output LOW Voltage
IOL = 16 mA, VIN = VIH or VIL, VCC = Min
0.4
V
VIH
Input HIGH Voltage
Guaranteed Input Logical HIGH
Voltage for all Inputs (Note 1)
2.0
V
VIL
Input LOW Voltage
Guaranteed Input Logical LOW
Voltage for all Inputs (Note 1)
0.8
V
IIH
Input HIGH Leakage Current
VIN = VCC, VCC = Max (Note 2)
10
A
IIL
Input LOW Leakage Current
VIN = 0 V, VCC = Max (Note 2)
-100
A
IOZH
Off-State Output Leakage
Current HIGH
VOUT = VCC, VCC = Max
VIN = VIL or VIH (Note 2)
10
A
IOZL
Off-State Output Leakage
Current LOW
VOUT = 0 V, VCC = Max
VIN = VIL or VIH (Note 2)
-100
A
ISC
Output Short-Circuit
Current
VOUT = 0.5 V, VCC = 5 V
TA = 25°C (Note 3)
-30
-130
mA
ICC (Static)
Supply Current
VIN = 0 V, Outputs Open (IOUT = 0mA),
VCC = Max (Note 4)
55
mA