- 您現在的位置：買賣IC網 > PDF目錄367732 > P87C750EBAA (NXP SEMICONDUCTORS) 0.5MM FFC JUMPER PDF資料下載
參數資料
| 型號： | P87C750EBAA |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 0.5MM FFC JUMPER |
| 中文描述： | 8-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQCC28 |
| 封裝： | PEDESTAL, PLASTIC, MO-047AB, SOT-261-3, LCC-28 |
| 文件頁數： | 5/16頁 |
| 文件大?。?/td> | 158K |
| 代理商： | P87C750EBAA |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
Philips Semiconductors
Product specification
83C750/87C750
80C51 8-bit microcontroller family
1K/64 OTP/ROM, low pin count
1998 May 01
5
POWER-DOWN MODE
In the power-down mode, the oscillator is stopped and the
instruction to invoke power-down is the last instruction executed.
Only the contents of the on-chip RAM are preserved. A hardware
reset is the only way to terminate the power-down mode. the control
bits for the reduced power modes are in the special function register
PCON.
Table 1.
External Pin Status During Idle and
Power-Down Modes
MODE
Port 0
Port 1
Port 2
Idle
Power-down
Data
Data
Data
Data
Data
Data
DIFFERENCES BETWEEN THE 8XC750 AND THE
80C51
Program Memory
On the 8XC750, program memory is 1024 bytes long and is not
externally expandable, so the 80C51 instructions MOVX, LJMP, and
LCALL are not implemented. The only fixed locations in program
memory are the addresses at which execution is taken up in
response to reset and interrupts, which are as follows:
Program Memory
Event
Address
Reset
000
External INT0
003
Counter/timer 0
00B
External INT1
013
Counter/Timer Subsystem
Timer/Counter
The 8XC750 has one timers: a 16-bit timer/counter. The 16-bit
timer/counter’s operation is similar to mode 2 operation on the
80C51, but is extended to 16 bits. The timer/counter is clocked by
either 1/12 the oscillator frequency or by transitions on the T0 pin.
The C/T pin in special function register TCON selects between
these two modes. When the TCON TR bit is set, the timer/counter is
enabled. Register pair TH and TL are incremented by the clock
source. When the register pair overflows, the register pair is
reloaded with the values in registers RTH and RTL. The value in the
reload registers is left unchanged. See the 83C750 counter/timer
block diagram in Figure 1. The TF bit in special function register
TCON is set on counter overflow and, if the interrupt is enabled, will
generate an interrupt.
TCON Register
MSB
LSB
GATE
C/T
TF
TR
IE0
IT0
IE1
IT1
GATE
1 – Timer/counter is enabled only when INT0 pin is high,
and TR is 1.
0 – Timer/counter is enabled when TR is 1.
1 – Counter/timer operation from T0 pin.
0 – Timer operation from internal clock.
1 – Set on overflow of TH.
0 – Cleared when processor vectors to interrupt routine
and by reset.
1 – Timer/counter enabled.
0 – Timer/counter disabled.
1 – Edge detected in INT0.
1 – INT0 is edge triggered.
0 – INT0 is level sensitive.
1 – Edge detected on INT1.
1 – INT1 is edge triggered.
0 – INT1 is level sensitive.
C/T
TF
TR
IE0
IT0
IE1
IT1
These flags are functionally identical to the corresponding 80C51
flags, except that there is only one timer on the 83C750 and the
flags are therefore combined into one register.
Note that the positions of the IE0/IT0 and IE1/IT1 bits are
transposed from the positions used in the standard 80C51 TCON
register.
Interrupt Subsystem – Fixed Priority
The IP register and the 2-level interrupt system of the 80C51 are
eliminated. Simultaneous interrupt conditions are resolved by a
single-level, fixed priority as follows:
Highest priority:
Pin INT0
Counter/timer flag 0
Pin INT1
Special Function Register Addresses
Special function registers for the 8XC750 are identical to those of
the 80C51, except for the changes listed below:
80C51 special function registers not present in the 8XC750 are
TMOD (89), P2 (A0) and IP (B8). The 80C51 registers TH1 and TL1
are replaced with the 87C750 registers RTH and RTL respectively
(refer to Table 2).
OSC
÷
12
TL
TH
TF
RTL
RTH
T0 Pin
TR
Gate
INT0 Pin
Int.
C/T = 0
C/T = 1
Reload
SU00300
Figure 1.
83C751 Counter/Timer Block Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| P87C750EFPN | 80C51 8-bit microcontroller family 1K/64 OTP ROM, low pin count |
| P87C750EBPN | 80C51 8-bit microcontroller family 1K/64 OTP ROM, low pin count |
| P83C750EBPN | 16-Bit Buffers/Drivers with 3-State Outputs 48-SSOP -40 to 85 |
| P83C750EFAA | 128K X 16 BIT, 90 NS, 0-70 C, CMOS EPROM |
| P87C750EFAA | IC,MICROPROCESSOR,ARM THUMB |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P87L42 | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:UNIVERSAL PERIPHERAL INTERFACE CHMOS 8-BIT SLAVE MICROCONTROLLER |
| P87LPC759 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low power, low price, low pin count (14 pin) microcontroller with 1 kbyte OTP |
| P87LPC759BN | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low power, low price, low pin count (14 pin) microcontroller with 1 kbyte OTP |
| P87LPC760 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low power, low price, low pin count (14 pin) microcontroller with 1 kbyte OTP |
| P87LPC760BDH | 功能描述:8位微控制器 -MCU 80C51 1K/128 OTP RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。