參數資料
型號： P87C591
廠商： NXP Semiconductors N.V.
英文描述： Single-chip 8-bit microcontroller with CAN controller
中文描述： 單芯片8 - CAN控制器位微控制器
文件頁數： 35/161頁
文件大小： 588K
代理商： P87C591
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁當前第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁
1999 Aug 19
35
Philips Semiconductors
Objective Specification
Single-chip 8-bit microcontroller with CAN controller
P8xC591
3.
This mode of operation forces the CAN Controller to be error passive. Message Transmission is not possible. The
Listen Only Mode can be used e.g. for software driven bit rate detection and “hot plugging”.
During a Hardware reset or when the Bus Status bit is set ‘1’ (Bus-Off), the Reset Mode bit is set ‘1’ (present). During
an external reset the CPU cannot set the Reset Mode bit ‘0’ (absent). Therefore, after having set the Reset Mode bit
‘0’, the CPU must check this bit to ensure that the external reset pin is not being held HIGH. After the Reset Mode
bit is set ‘0’ the CAN Controller will wait for:
a) one occurrence of Bus-Free signal (11 recessive bits), if the preceding reset has been caused by Hardware reset
or a CPU-initiated reset.
b) 128 occurrences of Bus-Free, if the preceding reset has been caused by a CAN Controller initiated Bus-Off,
before re-entering the Bus-On mode
4.
12.5.3
C
OMMAND
R
EGISTER
(CMR)
The contents of the Command Register are used to change the behaviour of the CAN Controller. Control bits may be set
or reset by the CPU which uses the Command Register as a read/write memory.
Table 14
Command Register (CMR) CAN Addr. 1, bit interpretation
Notes
1.
Upon Self Reception Request a message is transmitted and simultaneously received if the acceptance filter is set to
the corresponding identifier. A receive and a transmit interrupt will indicate correct self reception. (see also Self Test
Mode in Mode Register).
This command bit is used to clear the Data Overrun condition signalled by the Data Overrun Status bit. As long as
the Data Over run Status bit is set no further Data Overrun Interrupt is generated.
After reading the contents of the Receive Buffer, the CPU can release this memory space of the RXFIFO by setting
the Release Receive Buffer bit ‘1’. This may result in another message becoming immediately available within the
Receive Buffer. If there is no other message available, the Receive Interrupt bit is reset. The Receive Interrupt is also
reset in case there is no “high priority” message available within the FIFO (see acceptance filter description) and the
available message bytes are equal to or less to the specified value within the Receive Interrupt Level Register. If the
RRB command is given, it will take at least 2 internal clock cycles before a new receive interrupt is generated and
Rx Buffer Start Address is updated.
2.
3.
BIT
SYMBOL
NAME
VALUE
FUNCTION
CMR.7
to
CMR.5
CMR.4
-
reserved
-
SRR
Self Reception Request;
Notes 1 and 6
1 (present)
A message shall be transmitted and received
simultaneously.
0 (absent)
1 (clear)
0 (no action)
1 (released)
CMR.3
CDO
Clear Data Overrun;
Note 2
The Data Overrun Status bit is cleared.
CMR.2
RRB
Release Receive Buffer;
Note 3
The Receive Buffer, representing the message
memory space in the RXFIFO is released.
0 (no action)
1 (present)
CMR.1
AT
Abort Transmission;
Notes 4 and 6
If not already in progress, a pending Transmission
Request is cancelled.
0 (absent)
1 (present)
0 (absent)
CMR.0
TR
Transmission Request;
Notes 5 and 6
A message shall be transmitted.
相關PDF資料
PDF描述
P83C591VFA Single-chip 8-bit microcontroller with CAN controller
P80CE560 8-BIT SINGLE CHIP MICROCONTROLLERS
P87CE560EFB BATTERY CHG UNIV 12VDC @ 500MA
P83CE560 8-BIT SINGLE CHIP MICROCONTROLLERS
P87CE560 8-BIT SINGLE CHIP MICROCONTROLLERS
相關代理商/技術參數
參數描述
P87C591VFA/00,512 功能描述:8位微控制器 -MCU 80C51 16K OTP/CAN RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P87C654X2BBD,157 功能描述:8位微控制器 -MCU 16K/256 OTP 12/6 CLK I2C LQFP RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P87C654X2FA 制造商:NXP Semiconductors 功能描述:P87C654X2FA 8bit microcontroller,33MHz
P87C654X2FA,529 功能描述:8位微控制器 -MCU 16K/256 OTP 12/6 CLK RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P87C654X2FA-S 功能描述:8位微控制器 -MCU 16K/256 OTP 12/6 CLK I2C PLCC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*