- 您現在的位置：買賣IC網 > PDF目錄369943 > P87C58-1 (INTEL CORP) CHMOS SINGLE-CHIP 8-BIT MICROCONTROLLER PDF資料下載
參數資料
| 型號： | P87C58-1 |
| 廠商： | INTEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | CHMOS SINGLE-CHIP 8-BIT MICROCONTROLLER |
| 中文描述： | 8-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PDIP40 |
| 封裝： | PLASTIC, DIP-40 |
| 文件頁數： | 5/23頁 |
| 文件大?。?/td> | 319K |
| 代理商： | P87C58-1 |
8XC52/54/58
If desired, ALE operation can be disabled by setting
bit 0 of SFR location 8EH. With this bit set, the pin is
weakly pulled high. However, the ALE disable fea-
ture will be suspended during a MOVX or MOVC in-
struction, idle mode, power down mode and ICE
mode. The ALE disable feature will be terminated by
reset. When the ALE disable feature is suspended or
terminated, the ALE pin will no longer be pulled up
weakly. Setting the ALE-disable bit has no affect if
the microcontroller is in external execution mode.
Throughout the remainder of this data sheet, ALE
will refer to the signal coming out of the ALE/PROG
pin, and the pin will be referred to as the ALE/PROG
pin.
PSEN:
Program Store Enable is the read strobe to
external Program Memory.
When the 8XC5X is executing code from external
Program Memory, PSEN is activated twice each
machine cycle, except that two PSEN activations
are skipped during each access to external Data
Memory.
EA/V
PP
:
External Access enable. EA must be
strapped to VSS in order to enable the device to
fetch code from external Program Memory locations
0000H to 0FFFFH. Note, however, that if any of the
Lock bits are programmed, EA will be internally
latched on reset.
EA should be strapped to V
CC
for internal program
executions.
This pin also receives the programming supply volt-
age (V
PP
) during EPROM programming.
XTAL1:
Input to the inverting oscillator amplifier.
XTAL2:
Output from the inverting oscillator amplifi-
er.
OSCILLATOR CHARACTERISTICS
XTAL1 and XTAL2 are the input and output, respec-
tively, of a inverting amplifier which can be config-
ured for use as an on-chip oscillator, as shown in
Figure 3. Either a quartz crystal or ceramic resonator
may be used. More detailed information concerning
the use of the on-chip oscillator is available in Appli-
cation Note AP-155, ‘‘Oscillators for Microcontrol-
lers’’, Order No. 230659.
272336–5
C1, C2
e
30 pF
g
10 pF for Crystals
For Ceramic Resonators, contact resonator manufac-
turer.
Figure 3. Oscillator Connections
To drive the device from an external clock source,
XTAL1 should be driven, while XTAL2 floats, as
shown in Figure 4. There are no requirements on the
duty cycle of the external clock signal, since the in-
put to the internal clocking circuitry is through a di-
vide-by-two flip-flop, but minimum and maximum
high and low times specified on the data sheet must
be observed.
An external oscillator may encounter as much as a
100 pF load at XTAL1 when it starts up. This is due
to interaction between the amplifier and its feedback
capacitance. Once the external signal meets the V
IL
and V
IH
specifications the capacitance will not ex-
ceed 20 pF.
272336–6
Figure 4. External Clock Drive Configuration
IDLE MODE
The user’s software can invoke the Idle Mode. When
the microcontroller is in this mode, power consump-
tion is reduced. The Special Function Registers and
the onboard RAM retain their values during Idle, but
the processor stops executing instructions. Idle
Mode will be exited if the chip is reset or if an en-
abled interrupt occurs.
5
相關PDF資料 |
PDF描述 |
|---|---|
| P87C58-2 | CHMOS SINGLE-CHIP 8-BIT MICROCONTROLLER |
| P87C58-24 | CHMOS SINGLE-CHIP 8-BIT MICROCONTROLLER |
| P87C58-33 | CHMOS SINGLE-CHIP 8-BIT MICROCONTROLLER |
| P80C32-1 | CHMOS SINGLE-CHIP 8-BIT MICROCONTROLLER |
| P80C32-2 | CHMOS SINGLE-CHIP 8-BIT MICROCONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P87C581SF76 | 功能描述:IC MCU 8BIT 32K 16MHZ OTP 40-DIP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:87C 其它有關文件:STM32F101T8 View All Specifications 特色產品:STM32 32-bit Cortex MCUs 標準包裝:490 系列:STM32 F1 核心處理器:ARM? Cortex?-M3 芯體尺寸:32-位 速度:36MHz 連通性:I²C，IrDA，LIN，SPI，UART/USART 外圍設備:DMA，PDR，POR，PVD，PWM，溫度傳感器，WDT 輸入/輸出數:26 程序存儲器容量:64KB（64K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):2 V ~ 3.6 V 數據轉換器:A/D 10x12b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:36-VFQFN，36-VFQFPN 包裝:托盤 配用:497-10030-ND - STARTER KIT FOR STM32497-8853-ND - BOARD DEMO STM32 UNIV USB-UUSCIKSDKSTM32-PL-ND - KIT IAR KICKSTART STM32 CORTEXM3497-8512-ND - KIT STARTER FOR STM32F10XE MCU497-8505-ND - KIT STARTER FOR STM32F10XE MCU497-8304-ND - KIT STM32 MOTOR DRIVER BLDC497-6438-ND - BOARD EVALUTION FOR STM32 512K497-6289-ND - KIT PERFORMANCE STICK FOR STM32MCBSTM32UME-ND - BOARD EVAL MCBSTM32 + ULINK-MEMCBSTM32U-ND - BOARD EVAL MCBSTM32 + ULINK2更多... 其它名稱:497-9032STM32F101T8U6-ND |
| P87C5820SF76 | 功能描述:IC MCU 8BIT 32K 20MHZ OTP 40-DIP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:87C 標準包裝:160 系列:HCS12 核心處理器:HCS12 芯體尺寸:16-位 速度:25MHz 連通性:CAN，EBI/EMI，SCI，SPI 外圍設備:POR，PWM，WDT 輸入/輸出數:35 程序存儲器容量:128KB（128K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:4K x 8 電壓 - 電源 (Vcc/Vdd):2.35 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:52-LQFP 包裝:托盤 |
| P87C5833SF76 | 功能描述:IC MCU 8BIT 32K 33MHZ OTP 40-DIP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:87C 標準包裝:160 系列:HCS12 核心處理器:HCS12 芯體尺寸:16-位 速度:25MHz 連通性:CAN，EBI/EMI，SCI，SPI 外圍設備:POR，PWM，WDT 輸入/輸出數:35 程序存儲器容量:128KB（128K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:4K x 8 電壓 - 電源 (Vcc/Vdd):2.35 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:52-LQFP 包裝:托盤 |
| P87C58SBAA | 制造商: 功能描述: 制造商:PHILIP 功能描述: |
| P87C58X2BA,512 | 功能描述:8位微控制器 -MCU 32K/256 OTP 12/6 CLK COMM PLCC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。