參數資料
型號： P80CE560EFB
廠商： NXP SEMICONDUCTORS
元件分類： 微控制器/微處理器
英文描述： 8-BIT MICROCONTROLLER
中文描述： 8-BIT, 16 MHz, MICROCONTROLLER, PQFP80
封裝： 14 X 20 MM, 2.80 MM HEIGHT, PLASTIC, SOT-318-2, QFP-80
文件頁數： 50/84頁
文件大小： 441K
代理商： P80CE560EFB
1997 Aug 01
50
Philips Semiconductors
Product specification
8-bit microcontroller
P8xCE560
16.2.4
S
ECONDS
T
IMER
This counter provides an overflow signal every second,
when the 32 kHz oscillator is running. The overflow output
sets the interrupt flag SECINT. This interrupt can be
disabled/enabled by ENSECI. If SECINT is enabled, it is
logically ORed with INT1 (External interrupt 1).
The ‘seconds’ interrupt andINT1 therefore share the same
priority and vector. The software has to check both flags
SECINT (PLLCON.5) and IE1 (TCON.3) to distinguish
between the two interrupt sources. SECINT can only be
cleared via writing a logic 0 to this bit.
The external interruptsINT0,INT1 or the seconds interrupt
can wake-up the PLL oscillator and the microcontroller as
described in Chapter 15.3. For a wake-up via INT1 or
seconds interrupt, IE1 must be enabled and
level-sensitive.
A further function of the seconds timer is to control the
start-up timing of the microcontroller after reset or after
wake-up from Power-down.
It controls the stretching of the reset pulse to the
microcontroller and controls releasing the system clock to
the microcontroller. A RSTIN signal of 1
μ
s at minimum will
reset the microcontroller.
In the even of reset or wake-up with halted 32 kHz
oscillator: from RSTIN falling edge or wake-up interrupt
it takes 560 ms at maximum for the start-up of the
32 kHz oscillator itself and the stabilization of the PLLs.
In the event of wake-up with running 32 kHz oscillator:
from wake-up interrupt it takes about 10 ms for the
stabilization of the PLLs.
After this start-up time, the microcontroller is supplied with
the system clock and - in case of a reset - the internally
stretched reset signal overlaps about 45
μ
s, to guarantee
a proper initialization of the microcontroller.
For further information refer to Chapter 15.
Fig.19 Block diagram PLL.
handbook, full pagewidth
MBH086
32 kHz
OCSILLATOR
PHASE
COMPARATOR
Rf
C1
C2
LOOP
FILTER
CCO
32.768 kHz
XTAL3
XTAL4
PROGRAMMABLE
DIVIDER
PLLCON
SECONDS TIMER
PD
PD
RUN32
RSTIN
INTERNAL BUS
'seconds'
interrupt
request
reset to
controller
system
clock
相關PDF資料
PDF描述
P83CE560EFB NPN Silicon Power Transistor, TO-220F-3SL
P80CE598FHB 8-bit microcontroller with CAN controller(帶CAN控制器的8位微控制器)
P83CE598FFB 8-bit microcontroller with CAN controller(帶CAN控制器的8位微控制器)
P83CE598FHB 8-bit microcontroller with CAN controller(帶CAN控制器的8位微控制器)
P80CE654FBB 8-BIT MICROCONTROLLER
相關代理商/技術參數
參數描述
P80CE562EHA 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller
P80CE598 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with on-chip CAN
P80CE598FFB 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with on-chip CAN
P80CE598FFB/00,518 功能描述:8位微控制器 -MCU 8B MCU ON-CHIP CAN RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P80CE598FFB/00,557 功能描述:8位微控制器 -MCU 8B MCU ON-CHIP CAN RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*