參數資料
型號: P80C851FFP
廠商: NXP SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: CMOS single-chip 8-bit microcontroller with on-chip EEPROM
中文描述: 8-BIT, 16 MHz, MICROCONTROLLER, PDIP40
封裝: 0.600 INCH, PLASTIC, DIP-40
文件頁數: 8/22頁
文件大小: 182K
代理商: P80C851FFP
Philips Semiconductors
Product specification
80C851/83C851
CMOS single-chip 8-bit microcontroller
with on-chip EEPROM
1998 Jul 03
8
ECNTRL0
7
6
5
4
3
2
1
0
ECNTRL1
ECNTRL2
ECNTRL3
– –
EWP
EEINT
IFE
Bit
ECNTRL.7
Symbol
IFE
Function
Active high EEPROM interrupt flag: set by the sequencer or by software;
reset by software.
When set and enabled, this flag forces an interrupt to the same vector as the
serial port interrupt (see Interrupt section).
EEPROM interrupt enable: set and reset by software (active high).
Erase/write in progress flag: set and reset by the sequencer (active high).
When EWP is set, access to the EEPROM is not possible. EWP cannot be set or
reset by software.
Reserved.
See table below.
ECNTRL.6
ECNTRL.5
EEINT
EWP
ECNTRL.4
ECCTRL.3–
ECNTRL.0
Operation
ECNTRL.3
ECNTRL.2
ECNTRL.1
ECNTRL.0
Byte mode
Row erase
Page write*
Page erase/write*
block erase
*Future products.
0
1
1
0
1
0
0
0
1
0
0
0
Byte mode:
Normal EEPROM mode, default mode after reset. In this mode, data can be read and
written to one byte at a time.
This is the default mode when byte mode is selected. This means that the contents of the
addressed byte are available in the data register.
This mode is activated by writing to the data register. The address register must be loaded
first. Since the old contents are read first (by default), this allows the sequencer to decide
whether an erase/write or write cycle only (data = 00H) is required.
In this mode, the addressed row is cleared. The three LSBs of EADRL are not significant,
i.e. the 8 bytes addressed by EADRL are cleared in the same time normally needed to clear
one byte (t
= t
= t
). For the following write modes, only the write and not the
erase/write cycle is required. For example, using the row erase mode, programming 8 bytes
takes t
TOTOAL
= t
E
+ 8
×
t
W
compared to t
TOTAL
= 8
×
t
E
+ 8
×
t
W
(t
E
= t
ERASE
t
W
= t
WRITE
).
For future products.
For future products.
In this mode all 256 bytes are cleared. The byte containing the security bits is also cleared.
t
BLOCKERASE
= t
E
. The contents of EADRH, EADRL and EDAT are insignificant.
Read mode:
Write mode:
Row erase:
Page write:
Page erase/write:
Block erase:
Figure 2. Control Register (ECNTRL)
Program Sequences and Register Contents after Reset
The contents of the EEPROM registers after a Reset are the default values:
EADRH
= 1xxxxxxxB
(security bit address)
EADRL
= 00H
(security bit address)
ETIM
= 08H
(minimum erase time with the lowest permissible oscillator frequency)
ECNTRL
= 00H
(Byte mode, read)
EDAT
= xxH
(security bit)
Initialize:
MOV ETIM, ..
MOV EADRH, ..
Read:
MOV EADRL, ..
MOV .., EDAT
Write:
MOV EADRL, ..
MOV EDAT, ..
Erase row:
MOV EADRL, ..
Row address. 3LSBs don’t care
MOV ECNTRL, #0CH
Erase row mode
MOV EDAT, ..
(EDAT) don’t care
Erase block: MOV ECNTRL, 0AH
Erase block mode
MOV EDAT, ..
(EDAT) don’t care
If the security bit is to be altered, the program generally starts as follows:
MOV EADRH, #80H
MOV EADRL, #00H
相關PDF資料
PDF描述
P83C851FFP CMOS single-chip 8-bit microcontroller with on-chip EEPROM
P80C851FFA CMOS single-chip 8-bit microcontroller with on-chip EEPROM
P83C851FFA CMOS single-chip 8-bit microcontroller with on-chip EEPROM
P80C851FFB CMOS single-chip 8-bit microcontroller with on-chip EEPROM
P83C851FFB CMOS single-chip 8-bit microcontroller with on-chip EEPROM
相關代理商/技術參數
參數描述
P80C851FHA 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:CMOS single-chip 8-bit microcontroller with on-chip EEPROM
P80C851FHB 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:CMOS single-chip 8-bit microcontroller with on-chip EEPROM
P80C851FHP 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:CMOS single-chip 8-bit microcontroller with on-chip EEPROM
P80C851IBA 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:CMOS single-chip 8-bit microcontroller with on-chip EEPROM
P80C851IBB 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:CMOS single-chip 8-bit microcontroller with on-chip EEPROM