- 您現在的位置：買賣IC網 > PDF目錄367723 > P80C591SFB (NXP SEMICONDUCTORS) Single-chip 8-bit microcontroller with CAN controller PDF資料下載
參數資料
| 型號： | P80C591SFB |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Single-chip 8-bit microcontroller with CAN controller |
| 中文描述： | 8-BIT, 16 MHz, MICROCONTROLLER, PQFP44 |
| 封裝： | 10 X 10 X 1.75 MM, PLASTIC, SOT-307-2, QFP-44 |
| 文件頁數： | 10/161頁 |
| 文件大?。?/td> | 588K |
| 代理商： | P80C591SFB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁
1999 Aug 19
10
Philips Semiconductors
Objective Specification
Single-chip 8-bit microcontroller with CAN controller
P8xC591
P2.0/A08 to
P2.7/A15
18 to 25 24 to 31
Port 2 (P2.0 to P2.7)
: 8-bit programmable I/O port lines;
A08 to A15
: High-order address byte for external memory.
Alternate function: High-order address byte for external memory (A08-A15).
Port 2 is also used to input the upper order address during EPROM
programming and verification. A8 is on P2.0, A9 on P2.1, through A12 on
P2.4.
During reset, Port 2 will be asynchronously driven HIGH.
Port 2 has four output modes selected on a per bit basis by writing to the
P2M1 and P2M2 registers as follows:
P2M1.x
0
0
1
1
1
Open drain
Program Store Enable
output: read strobe to the external Program Memory
via Ports 0 and 2. Is activated twice each machine cycle during fetches from
external Program Memory. When executing out of external Program Memory
two activations of PSEN are skipped during each access to external Data
Memory. PSEN is not activated (remains HIGH) during no fetches from
external Program Memory. PSEN can sink/source 8 LSTTL inputs. It can
drive CMOS inputs without external pull-ups.
Address Latch Enable
output. Latches the low byte of the address during
access of external memory in normal operation. It is activated every six
oscillator periods except during an external Data Memory access. ALE can
sink/source 8 LSTTL inputs. It can drive CMOS inputs without an external
pull-up. To prohibit the toggling of ALE pin (RFI noise reduction) the bit A0
(SFR: AUXR.0) must be set by software; see Table 4.
PROG
: the programming pulse input; alternative function for the P87C591.
External Access
input. If, during reset, EA is held at a TTL level HIGH the
CPU executes out of the internal Program Memory. If, during reset, EA is held
at a TTL level LOW the CPU executes out of external Program Memory via
Port 0 and Port 2. EA is not allowed to float. EA is latched during reset and
don’t care after reset.
V
PP
: the programming supply voltage; alternative function for the P87C591.
Port 0
: 8-bit open-drain bidirectional I/O port.
During reset, Port 0 is HIGH-Impedance (Tri-State).
P2M2.x
0
1
0
Mode Description
Pseudo-bidirectional (standard c51 configuration default)
Push-Pull
High impedance
PSEN
26
32
ALE/PROG
27
33
EA/V
PP
29
35
P0.0/AD0 to
P0.7/AD7
30 to 37 36 to 43
AD7 to AD0
: Multiplexed Low-order address and Data bus for external
memory. During these accesses internal pull-ups are activated. Port 0 can
sink/source up to 8 LSTTL inputs.
Analog to Digital Conversion Reference Resistor:
High-end.
Analog ground.
AV
ref+
AV
SS
38
39
44
1
SYMBOL
PIN
DESCRIPTION
QFP44
PLCC44
相關PDF資料 |
PDF描述 |
|---|---|
| P83C591SFB | Single-chip 8-bit microcontroller with CAN controller |
| P87C591SFB | Single-chip 8-bit microcontroller with CAN controller |
| P80C591 | Single-chip 8-bit microcontroller with CAN controller |
| P83C591 | Single-chip 8-bit microcontroller with CAN controller |
| P87C591 | Single-chip 8-bit microcontroller with CAN controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P80C592 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with on-chip CAN |
| P80C592FFA | 制造商:NXP Semiconductors 功能描述: |
| P80C592FFA/00,512 | 功能描述:8位微控制器 -MCU 80C51 W/CAN 16MHZ ROMLESS RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| P80C592FFA/00,512 | 制造商:NXP Semiconductors 功能描述:8BIT MCU+CAN, SMD, 80C592, PLCC68 |
| P80C592FFA/00,518 | 功能描述:8位微控制器 -MCU SINGLE-CHIP 8-BIT MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。