參數資料
型號: OPA627AU
英文描述: Precision High-Speed Difet OPERATIONAL AMPLIFIERS
中文描述: 精密高速Difet運算放大器
文件頁數: 11/13頁
文件大?。?/td> 256K
代理商: OPA627AU
11
OPA627, 637
INPUT PROTECTION
The inputs of the OPA627/637 are protected for voltages
between +V
+ 2V and –V
– 2V. If the input voltage can
exceed these limits, the amplifier should be protected. The
diode clamps shown in Figure 7a will prevent the input
voltage from exceeding one forward diode voltage drop
beyond the power supplies—well within the safe limits. If
the input source can deliver current in excess of the maxi-
mum forward current of the protection diodes, use a series
resistor, R
, to limit the current. Be aware that adding
resistance to the input will
increase noise. The 4nV/
Hz
theoretical thermal noise of a 1k
resistor will add to the
4.5nV/
Hz noise of the OPA627/637 (by the square-root of
the sum of the squares), producing a total noise of 6nV/
Hz.
Resistors below 100
add negligible noise.
Leakage current in the protection diodes can increase the
total input bias current of the circuit. The specified maxi-
mum leakage current for commonly used diodes such as the
1N4148 is approximately 25nA—more than a thousand
times larger than the input bias current of the OPA627/637.
Leakage current of these diodes is typically much lower and
may be adequate in many applications. Light falling on the
junction of the protection diodes can dramatically increase
leakage current, so common glass-packaged diodes should
be shielded from ambient light. Very low leakage can be
achieved by using a diode-connected FET as shown. The
2N4117A is specified at 1pA and its metal case shields the
junction from light.
Sometimes input protection is required on I/V converters of
inverting amplifiers (Figure 7b). Although in normal opera-
tion, the voltage at the summing junction will be near zero
(equal to the offset voltage of the amplifier), large input
transients may cause this node to exceed 2V beyond the
power supplies. In this case, the summing junction should
be protected with diode clamps connected to ground. Even
with the low voltage present at the summing junction,
common signal diodes may have excessive leakage current.
Since the reverse voltage on these diodes is clamped, a
diode-connected signal transistor can be used as an inexpen-
sive low leakage diode (Figure 7b).
FIGURE 7. Input Protection Circuits.
+
–V
S
+V
S
Optional R
S
V
O
D: IN4148 — 25nA Leakage
2N4117A — 1pA Leakage
Siliconix
(a)
=
+
I
IN
V
O
D
D
D
(b)
D
D: 2N3904
=
NC
OPA627
OPA627
FPO
When used as a unity-gain buffer, large common-mode input voltage steps
produce transient variations in input-stage currents. This causes the rising
edge to be slower and falling edges to be faster than nominal slew rates
observed in higher-gain circuits.
(A)
(B)
SMALL SIGNAL RESPONSE
LARGE SIGNAL RESPONSE
FIGURE 8. OPA627 Dynamic Performance, G = +1.
+
OPA627
G = 1
相關PDF資料
PDF描述
OPA627BM Precision High-Speed Difet OPERATIONAL AMPLIFIERS
OPA627BP Precision High-Speed Difet OPERATIONAL AMPLIFIERS
OPA627SM Precision High-Speed Difet OPERATIONAL AMPLIFIERS
OPA640 Wideband Voltage Feedback OPERATIONAL AMPLIFIER
OPA640P Wideband Voltage Feedback OPERATIONAL AMPLIFIER
相關代理商/技術參數
參數描述
OPA627AU 制造商:Texas Instruments 功能描述:IC SM OP-AMP DIFET PRECISION
OPA627AU/2K5 功能描述:高速運算放大器 Prec High-Speed Difet Oper Amp RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
OPA627AU/2K5E4 功能描述:高速運算放大器 Prec High-Speed Difet Oper Amp RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
OPA627AUE4 功能描述:高速運算放大器 Prec High-Speed Difet Oper Amp RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
OPA627AUG4 功能描述:高速運算放大器 Prec High-Speed Difet Oper Amp RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube