- 您現在的位置：買賣IC網 > PDF目錄363771 > OPA2365 2.2V, 50MHz, Low-Noise, Single-Supply Rail-to-Rail OPERATIONAL AMPLIFIERS PDF資料下載
參數資料
| 型號： | OPA2365 |
| 英文描述： | 2.2V, 50MHz, Low-Noise, Single-Supply Rail-to-Rail OPERATIONAL AMPLIFIERS |
| 中文描述： | 2.2伏，50MHz的，低噪聲，單電源軌至軌運算放大器 |
| 文件頁數： | 9/16頁 |
| 文件大?。?/td> | 301K |
| 代理商： | OPA2365 |
"#$
%"#$
SBOS365A JUNE 2006 REVISED JULY 2006
www.ti.com
9
A simplified schematic illustrating the rail-to-rail input
circuitry is shown in Figure 5.
CAPACITIVE LOADS
The OPA365 may be used in applications where driving
a capacitive load is required. As with all op amps, there
may be specific instances where the OPA365 can be-
come unstable, leading to oscillation. The particular op
amp circuit configuration, layout, gain and output load-
ing are some of the factors to consider when establish-
ing whether an amplifier will be stable in operation. An
op amp in the unity-gain (+1V/V) buffer configuration
and driving a capacitive load exhibits a greater tenden-
cy to be unstable than an amplifier operated at a higher
noise gain. The capacitive load, in conjunction with the
op amp output resistance, creates a pole within the
feedback loop that degrades the phase margin. The
degradation of the phase margin increases as the ca-
pacitive loading increases.
When operating in the unity-gain configuration, the
OPA365 remains stable with a pure capacitive load up
to approximately 1nF. The equivalent series resistance
(ESR) of some very large capacitors (C
L
> 1
μ
F) is suffi-
cient to alter the phase characteristics in the feedback
loop such that the amplifier remains stable. Increasing
the amplifier closed-loop gain allows the amplifier to
drive increasingly larger capacitance. This increased
capability is evident when observing the overshoot re-
sponse of the amplifier at higher voltage gains. See the
typical characteristic graph,
Small-Signal Overshoot
vs. Capacitive Load
.
One technique for increasing the capacitive load drive
capability of the amplifier operating in unity gain is to in-
sert a small resistor, typically 10
to 20
, in series with
the output; see Figure 6. This resistor significantly re-
duces the overshoot and ringing associated with large
capacitive loads. A possible problem with this technique
is that a voltage divider is created with the added series
resistor and any resistor connected in parallel with the
capacitive load. The voltage divider introduces a gain
error at the output that reduces the output swing. The
error contributed by the voltage divider may be insignifi-
cant. For instance, with a load resistance, R
L
= 10k
,
and R
S
= 20
, the gain error is only about 0.2%. Howev-
er, when R
L
is decreased to 600
, which the OPA365
is able to drive, the error increases to 7.5%.
Regulated
Charge Pump
V
OUT
= V
CC
+1.8V
Patent Pending
Very Low Ripple
Topology
I
BIAS
V
CC
+ 1.8V
I
BIAS
I
BIAS
V
S
I
BIAS
V
OUT
V
IN
V
IN
+
Figure 5. Simplified Schematic
10
to
20
V+
V
IN
V
OUT
R
S
R
L
C
L
OPA365
Figure 6. Improving Capacitive Load Drive
相關PDF資料 |
PDF描述 |
|---|---|
| OPA2369 | 1.8V, 1レA max, Zer┆-Crossover RAIL-TO-RAIL I/O OPERATIONAL AMPLIFIER |
| OPA2369AIDCNR | 1.8V, 1レA max, Zer┆-Crossover RAIL-TO-RAIL I/O OPERATIONAL AMPLIFIER |
| OPA2369AIDCNRG4 | 1.8V, 1レA max, Zer┆-Crossover RAIL-TO-RAIL I/O OPERATIONAL AMPLIFIER |
| OPA2369AIDCNT | 1.8V, 1レA max, Zer┆-Crossover RAIL-TO-RAIL I/O OPERATIONAL AMPLIFIER |
| OPA2369AIDCNTG4 | 1.8V, 1レA max, Zer┆-Crossover RAIL-TO-RAIL I/O OPERATIONAL AMPLIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OPA2365AID | 功能描述:運算放大器 - 運放 50MHz Single Supply Rail-to-Rail OP Amp RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| OPA2365AIDG4 | 功能描述:運算放大器 - 運放 50MHz Single Supply Rail-to-Rail OP Amp RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| OPA2365AIDR | 功能描述:運算放大器 - 運放 2.2V 50MHz Lo-Noise Sgl-Spy Rail-to-Rail RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| OPA2365AIDRG4 | 功能描述:運算放大器 - 運放 2.2V 50MHz Lo-Noise Sgl-Spy Rail-to-Rail RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| OPA2365AQDRQ1 | 功能描述:運算放大器 - 運放 2.2V,50MHz,Lo-Noise Sgl-Sply RR Op Amp RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。