- 您現在的位置：買賣IC網 > PDF目錄363775 > OPA2349EA 1mA, Rail-to-Rail, CMOS OPERATIONAL AMPLIFIERS PDF資料下載
參數資料
| 型號： | OPA2349EA |
| 英文描述： | 1mA, Rail-to-Rail, CMOS OPERATIONAL AMPLIFIERS |
| 中文描述： | 一毫安，軌到軌CMOS運算放大器 |
| 文件頁數： | 7/7頁 |
| 文件大?。?/td> | 141K |
| 代理商： | OPA2349EA |
7
OPA349
R
V
IN
V
CM
V
OUT
R
FIGURE 3. Design Optimization.
In most applications, operation is within the range of only
one differential pair. However, some applications can
subject the amplifier to a common-mode signal in the
transition region. Under this condition, the inherent mis-
match between the two differential pairs may lead to
degradation of the CMRR and THD. The unity-gain buffer
configuration is the most problematic—it will traverse
through the transition region if a sufficiently wide input
DESIGN OPTIMIZATION WITH RAIL-TO-RAIL INPUT OP AMPS
swing is required. A design option would be to configure
the op amp as a unity-gain inverter as shown below and
hold the noninverting input at a set common-mode voltage
outside the transition region. This can be accomplished
with a voltage divider from the supply. The voltage divider
should be designed such that the biasing point for the
noninverting input is outside the transition the region.
COMMON-MODE REJECTION
The CMRR for the OPA349 is specified in two ways so the
best match for a given application may be used. First, the
CMRR of the device in the common-mode range below the
transition region (V
CM
< (V+) – 1.5V) is given. This specifi-
cation is the best indicator of the capability of the device when
the application requires use of one of the differential input
pairs. Second, the CMRR at V
S
= 5V over the entire common-
mode range is specified.
RAIL-TO-RAIL OUTPUT
A class AB output stage with common-source transistors is
used to achieve rail-to-rail output.
Loads that connect to single supply ground (or the V- supply
pin) can cause the op amp to oscillate if the output voltage
is driven to the low limit (Figure 4). Similarly, loads that can
cause current to flow out of the output pin when the output
voltage is near V– can cause oscillations. The op amp will
recover to normal operation a few milliseconds after the
output is driven positively out of the rail.
Some op amp applications can produce this condition even
without a load connected to V– The integrator in Figure 4a
shows an example. Assume that the output ramps nega-
tively, and saturates near 0V. Any negative-going step at
V
IN
will produce a positive output current pulse through R1
and C1. This may incite the oscillation. Diode, D1, prevents
the input step from pulling output current when the output is
saturated at the rail, thus preventing the oscillation.
FIGURE 4. Output Driven to Negative Rail.
V
O
V
IN
V+
OPA349
0V
a)
b)
R
L
1V
(No Load)
V
IN
V+
2V
0V
OPA349
0V
C
1
1nF
R
1
1M
D1
1N4148
相關PDF資料 |
PDF描述 |
|---|---|
| OPA349 | 1mA, Rail-to-Rail, CMOS OPERATIONAL AMPLIFIERS |
| OPA349PA | 1mA, Rail-to-Rail, CMOS OPERATIONAL AMPLIFIERS |
| OPA349UA | 1mA, Rail-to-Rail, CMOS OPERATIONAL AMPLIFIERS |
| OPA2349UA | 1mA, Rail-to-Rail, CMOS OPERATIONAL AMPLIFIERS |
| OPA350PA | High-Speed, Single-Supply, Rail-to-Rail OPERATIONAL AMPLIFIERS MicroAmplifier ⑩ Series |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OPA2349EA/250 | 功能描述:運算放大器 - 運放 1uA Rail-to-Rail CMOS Oper Amplifier RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| OPA2349EA/3K | 功能描述:運算放大器 - 運放 1uA Rail-to-Rail CMOS Oper Amplifier RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| OPA2349EA-1/3K | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述: |
| OPA2349UA | 功能描述:運算放大器 - 運放 1uA Rail-to-Rail CMOS Oper Amplifier RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| OPA2349UA | 制造商:Texas Instruments 功能描述:OP AMP DUAL CMOS RRI/O SMD 2349 |
發布緊急采購，3分鐘左右您將得到回復。