參數資料
型號： NJW1301
廠商： New Japan Radio Co., Ltd.
英文描述： Insulation Displacement (IDC) Connector; No. of Contacts:14; Contact Termination:IDC; Gender:Male; Contact Plating:Gold RoHS Compliant: Yes
中文描述： 信號對NTSC彩色液晶處理器
文件頁數： 35/37頁
文件大小： 325K
代理商： NJW1301
NJW1301
- 33 -
3. Y-signal Mode
1) TRAP
The composite video signal input to pin-19 (VIDEOIN) without the chroma by TRAP
circuit. The TPAP frequency is 3.58MHz, and not through when Y/C input mode.
2) Picture Circuit
The Y/composite-signal input to pin-19 (VIDEOIN) without the synchronous signal. The
pin-25 (PICTURE) adjusts the frequency characteristic around 2MHz and emphasizes the
outline. The pin-25 level emphasizes outline depend on the DC voltage. The Y-signal
output pin-22 (YOUT), and input to pin-24 (YINH) through the external second differential
circuit.
4. INT./EXT. Signal Switch Mode
The analog RGB signal (0.7V
P-P
typ.) input to pin-29, pin-31, and pin-33, and these signal
clamps pedestal. The ext-signal select Y/C-signal or Int-signal by pin-26 (SW).
5. RGB SIGNAL MODE
1) Contrast
The pin-27 (CONTRAST) adjusts the all of RGB signal, which is black-to-white range.
2)
γ
Amplifier
This circuit is non-liner amplifier to adjust the RGB signal equal to the luminous
γ
characteristics. There is two-point adjustment for accurate correction. The pin-38 (VG1)
adjusts low side, and the pin-39 (VG2) adjusts high side.
]
3) Sub
γ
Circuit
This circuit adjusts
γ
characteristics of B/R signal, and sub
γ
adjusts white-balance for
the monitor. The pin-38 (SUBVG1R) and pin-36 (SUBVG2R) adjust low side with R-signal
and high side with
γ
characteristics. The pin-39 (SUBVG1B) and pin-37 (SUBVG2B)
adjust low side with B-signal and high side for
γ
characteristics. These terminal controls
R-signal and B-signal separately.
4) Bright
The pin-27 (CONTRAST) clamps the pedestal after the brightness adjustment (black to
black).
VG1 adjust
Input Signal
VG2 adjust
相關PDF資料
PDF描述
NJW1301FK1 Insulation Displacement (IDC) Connector; No. of Contacts:14; Contact Termination:IDC; Gender:Male; Contact Plating:Gold RoHS Compliant: Yes
NJW1303 SYNCHRONOUS SEPARATOR WITH COUNT DOWN
NJW1303V SYNCHRONOUS SEPARATOR WITH COUNT DOWN
NJW1503A PLL Synthesizer with 3-Wire Bus for TV Tuner
NJW1503AV PLL Synthesizer with 3-Wire Bus for TV Tuner
相關代理商/技術參數
參數描述
NJW1301FK1 功能描述:數字信號處理器和控制器 - DSP, DSC TFT Sgnl Pcsr; NTSC RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
NJW1302G 功能描述:兩極晶體管 - BJT 200W TO-3P PNP RoHS:否 制造商:STMicroelectronics 配置: 晶體管極性:PNP 集電極—基極電壓 VCBO: 集電極—發射極最大電壓 VCEO:- 40 V 發射極 - 基極電壓 VEBO:- 6 V 集電極—射極飽和電壓: 最大直流電集電極電流: 增益帶寬產品fT: 直流集電極/Base Gain hfe Min:100 A 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PowerFLAT 2 x 2
NJW1303 制造商:NJRC 制造商全稱:New Japan Radio 功能描述:SYNCHRONOUS SEPARATOR WITH COUNT DOWN
NJW1303V 制造商:NJRC 制造商全稱:New Japan Radio 功能描述:SYNCHRONOUS SEPARATOR WITH COUNT DOWN
NJW1303V(TE1) 制造商:New Japan Radio Co Ltd (NJR/JRC) 功能描述:Cut Tape 制造商:New Japan Radio 功能描述:SYNCHRONOUS SEPARATOR WITH COUNT DOWN
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*