- 您現在的位置：買賣IC網 > PDF目錄361106 > NCV8508DW50G (ON SEMICONDUCTOR) 5.0 V, 250 mA LDO with Watchdog and RESET PDF資料下載
參數資料
| 型號： | NCV8508DW50G |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 5.0 V, 250 mA LDO with Watchdog and RESET |
| 中文描述： | 5 V FIXED POSITIVE LDO REGULATOR, 0.9 V DROPOUT, PDSO16 |
| 封裝： | LEAD FREE, SOP-16 |
| 文件頁數： | 9/12頁 |
| 文件大?。?/td> | 89K |
| 代理商： | NCV8508DW50G |
NCV8508
http://onsemi.com
9
CIRCUIT DESCRIPTION
Functional Description
To reduce the drain on the battery a system can go into a
low current consumption mode when ever its not performing
a main routine. The Wakeup signal is generated
continuously and is used to interrupt a microcontroller that
is in sleep mode. The nominal output is a 5.0 volt square
wave (voltage generated from V
OUT
) with a duty cycle of
50% at a frequency that is determined by a timing resistor,
R
Delay
.
When the microprocessor receives a rising edge from the
Wakeup output, it must issue a Watchdog pulse and check its
inputs to decide if it should resume normal operations or
remain in the sleep mode.
The first falling edge of the Watchdog signal causes the
Wakeup to go low within 2.0
s
(typ) and remain low until
the next Wakeup cycle (see Figure 17). Other Watchdog
pulses received within the same cycle are ignored (Figure 3).
During power up, RESET is held low until the output
voltage is in regulation. During operation, if the output
voltage shifts below the regulation limits, the RESET
toggles low and remains low until proper output voltage
regulation is restored. After the RESET delay, RESET
returns high.
The Watchdog circuitry continuously monitors the input
Watchdog signal (WDI) from the microprocessor. The
absence of a falling edge on the Watchdog input during one
Wakeup cycle will cause a RESET pulse to occur at the end
of the Wakeup cycle. (see Figure 4).
The Wakeup output is pulled low during a RESET
regardless of the cause of the RESET. After the RESET
returns high, the Wakeup cycle begins again (see Figure 4).
The RESET Delay Time, Wakeup signal frequency and
RESET high to Wakeup delay time are all set by one external
resistor R
Delay
.
Wakeup Period = (4.17
×
10
7
)R
Delay
RESET Delay Time = (5.21
×
10
8
)R
Delay
RESET HIGH to Wakeup Delay Time = (2.08
×
10
7
)R
Delay
Resistor temperature coefficient and tolerance as well as
the tolerance of the NCV8508 must be taken into account in
order to get the correct system tolerance for each parameter.
Figure 17. Wakeup Response to WDI
Wakeup
WDI
Wakeup
Response
to WDI
Figure 18. Wakeup Response to RESET (Low
Voltage)
Wakeup
Response
to RESET
RESET
Wakeup
相關PDF資料 |
PDF描述 |
|---|---|
| NCV8508DW50R2 | 5.0 V, 250 mA LDO with Watchdog and RESET |
| NCV8664_07 | Ultra−Low Iq Low Dropout Linear Regulator |
| NCV8664ST33T3G | Ultra−Low Iq Low Dropout Linear Regulator |
| NCV8800HDW75 | Synchronous Buck Regulator with 1.0 Amp Switch |
| NCV8800HDW50 | Synchronous Buck Regulator with 1.0 Amp Switch |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCV8508DW50R2 | 功能描述:低壓差穩壓器 - LDO 5V 250mA w/WatchDog RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| NCV8508DW50R2G | 功能描述:低壓差穩壓器 - LDO 5V 250mA w/WatchDog RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| NCV8508PD50 | 功能描述:低壓差穩壓器 - LDO 5V 250mA w/WatchDog RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| NCV8508PD50G | 功能描述:低壓差穩壓器 - LDO 5V 250mA w/WatchDog Reset RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| NCV8508PD50R2 | 功能描述:低壓差穩壓器 - LDO 5V 250mA w/WatchDog RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。